16
FN6725.0
June 17, 2008
Tx Loading Considerations
When the ISL5410xA is powered-up and its Tx outputs are
disabled, via either the PD (power-down) pin, the
power-down register bit (register 0x02[5]), or the tri-state
outputs bits (register 0x05[1:0]), the Tx pins are high
impedance. In this state they will draw no current from the
Rx pins of any TMDS receiver they may be connected to.
However if power to the ISL5410xA is removed, the Tx pins
are no longer high-impedance.
Figure 10 shows the relevant
equivalent circuit, including the internal ESD protection
diodes. For simplicity, only one of the eight Tx outputs, ESD
protection diodes, and Rx termination resistors are shown.
When VD to the ISL5410xA drops below ~2.7V and power is
applied to the external TMDS receiver, ESD protection
diodes inside the ISL5410xA can become forward-biased,
drawing current from the external TMDS receiver it is
attached to.
This is non-ideal and will cause the ISL5410xA to fail HDMI
Compliance Test 7-3 (“VOFF”). VOFF is the voltage across
each 50
Ω Rx
N resistor when the power is removed from the
device containing the ISL5410xA.
To prevent this leakage current, insert a Schottky diode
between the VD power net and the VD_ESD pins as shown
in
Figure 11. With the addition of this diode the system will
pass compliance test 7-3.
PCB Layout Recommendations
Because of the high speed of the TMDS signals, careful
PCB layout is critical to maximize performance. The
following guidelines should be adhered to as closely as
possible:
All TMDS pair traces should have a characteristic
impedance of 50
Ω with respect to the power/ground
planes and 100
Ω with respect to each other. Failure to
meet this requirement will increase reflections, shrinking
the available eye.
Avoid vias for all 3 high speed TMDS pairs. Vias add
inductance which causes a discontinuity in the
characteristic impedance of the trace. Keep all the traces
on the top (or the bottom) of the PCB. The TMDS clock
can have vias if necessary, since it is lower speed and less
critical. If you must use a via, ensure the vias are
symmetrical (put identical vias in both lines of the
differential pair).
For each TMDS channel, the trace lengths of the 3 TMDS
pairs (0, 1 and 2) should ideally be the same to reduce
inter channel skew introduced by the board.
The trace length of the clock pair is not critical at all.
Since the clock is only used as a frequency reference, its
phase/delay is inconsequential. In addition, since the
TMDS clock frequency is 1/10th the pixel rate, the clock
signal itself is much more noise-immune. So liberties
(such as vias and circuitous paths) can be taken when
routing the clock lines.
FIGURE 9. ISL54100 EYE DIAGRAM AFTER 15m CABLE
FIGURE 10. ISL5410xA ESD PROTECTION DIODES
ISL5410xA
VD
VD_ESD
(74, 95)
3.3VTX
TxN
Tx
3.3VRX
50
RxN
FIGURE 11. SCHOTTKY DIODE MODIFICATION
ISL5410xA
VD
VD_ESD
(74, 95)
3.3VTX
TxN
Tx
3.3VRX
50
RxN
D1
C1
0.1
μF
ISL54100A, ISL54101A, ISL54102A