17 FN7870.0 June 21, 2011 Applications Information VLOGIC Requirements<" />
參數資料
型號: ISL23325UFVZ
廠商: Intersil
文件頁數: 9/20頁
文件大?。?/td> 0K
描述: IC DGTL POT 256POS 50K 14TSSOP
標準包裝: 960
系列: XDCP™
接片: 256
電阻(歐姆): 50k
電路數: 2
溫度系數: 標準值 65 ppm/°C
存儲器類型: 易失
接口: I²C,2 線串口
電源電壓: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: *
封裝/外殼: *
供應商設備封裝: *
包裝: *
ISL23325
17
FN7870.0
June 21, 2011
Applications Information
VLOGIC Requirements
VLOGIC should be powered continuously during normal operation.
In a case where turning VLOGIC OFF is necessary, it is
recommended to ground the VLOGIC pin of the ISL23325.
Grounding the VLOGIC pin or both VLOGIC and VCC does not affect
other devices on the same bus. It is good practice to put a 1F
cap in parallel to 0.1F as close to the VLOGIC pin as possible.
VCC Requirements and Placement
It is recommended to put a 1F capacitor in parallel with 0.1F
decoupling capacitor close to the VCC pin.
Wiper Transition
When stepping up through each tap in voltage divider mode,
some tap transition points can result in noticeable voltage
transients, or overshoot/undershoot, resulting from the sudden
transition from a very low impedance “make” to a much higher
impedance “break” within a short period of time (<1s). There
are several code transitions such as 0Fh to 10h, 1Fh to 20h,...,
EFh to FFh, which have higher transient glitch. Note, that all
switching transients will settle well within the settling time as
stated in the datasheet. A small capacitor can be added
externally to reduce the amplitude of these voltage transients.
However, that will also reduce the useful bandwidth of the circuit,
thus may not be a good solution for some applications. It may be
a good idea, in that case, to use fast amplifiers in a signal chain
for fast recovery.
相關PDF資料
PDF描述
TM7EW502 TRIMMER 5K OHM 0.5W TH
ISL84053IVZ IC MULTIPLEXER TRPL 2X1 16TSSOP
TM7EW501 TRIMMER 500 OHM 0.5W TH
TM7EW500 TRIMMER 50 OHM 0.5W TH
TM7EW205 TRIMMER 2M OHM 0.5W TH
相關代理商/技術參數
參數描述
ISL23325UFVZ-T7A 功能描述:數字電位計 IC 256 TAPVOLATILE I2C DUAL FL RNG IND 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325UFVZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFRUZ-T7A 功能描述:數字電位計 IC 256 TAPVOLATILE I2C DUAL FL RNG IND 16LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFRUZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23325WFVZ 功能描述:數字電位計 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel