參數資料
型號： IS43R16800A1
廠商： Integrated Silicon Solution, Inc.
英文描述： 8Meg x 16 128-MBIT DDR SDRAM
中文描述： 8Meg × 16的128 - Mbit DDR SDRAM內存
文件頁數： 6/72頁
文件大?。?/td> 2174K
代理商： IS43R16800A1
6
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. 00A
04/17/06
ISSI
IS43R16800A1
Register Definition
Mode Register
The Mode Register is used to define the specific mode of operation of the DDR SDRAM. This definition includes the selection of
a burst length, a burst type, a CAS latency, and an operating mode. The Mode Register is programmed via the Mode Register
Set command (with BA0 = 0 and BA1 = 0) and retains the stored information until it is programmed again or the device loses
power (except for bit A8, which is self-clearing).
Mode Register bits A0-A2 specify the burst length, A3 specifies the type of burst (sequential or interleaved), A4-A6 specify the
CAS latency, and A7-A11 specify the operating mode.
The Mode Register must be loaded when all banks are idle, and the controller must wait the specified time before initiating the
subsequent operation. Violating either of these requirements results in unspecified operation.
Burst Length
Read and write accesses to the DDR SDRAM are burst oriented, with the burst length being programmable. The burst length
determines the maximum number of column locations that can be accessed for a given Read or Write command. Burst lengths
of 2, 4, or 8 locations are available for both the sequential and the interleaved burst types.
Reserved states should not be used, as unknown operation or incompatibility with future versions may result.
When a Read or Write command is issued, a block of columns equal to the burst length is effectively selected. All accesses for
that burst take place within this block, meaning that the burst wraps within the block if a boundary is reached. The block is
uniquely selected by A1-Ai when the burst length is set to two, by A
2
-Ai when the burst length is set to four and by A
3
-Ai when
the burst length is set to eight (where Ai is the most significant column address bit for a given configuration). The remaining
(least significant) address bit(s) is (are) used to select the starting location within the block. The programmed burst length
applies to both Read and Write bursts.
相關PDF資料
PDF描述
IS43R16800A1-5TL 8Meg x 16 128-MBIT DDR SDRAM
IS43R32400A 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-5B 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-5BL 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-6B 4Meg x 32 128-MBIT DDR SDRAM
相關代理商/技術參數
參數描述
IS43R16800A1-5TL 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A-5T 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5TL 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5TL-TR 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5T-TR 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*