參數資料
型號： IS43R16800A1
廠商： Integrated Silicon Solution, Inc.
英文描述： 8Meg x 16 128-MBIT DDR SDRAM
中文描述： 8Meg × 16的128 - Mbit DDR SDRAM內存
文件頁數： 4/72頁
文件大?。?/td> 2174K
代理商： IS43R16800A1
4
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. 00A
04/17/06
ISSI
IS43R16800A1
PIN FUNCTIONS
Symbol
A0-A11
Type
Input Pin
Function (In Detail)
Address inputs are sampled during several commands. During an Active
command, A0-A11 select a row to open. During a Read or Write command,
A0-A8 select a starting column for a burst. During a Pre-charge command,
A10 determines whether all banks are to be pre-charged, or a single bank.
During a Load Mode Register command, the address inputs select an
operating mode.
Bank Address inputs are used to select a bank during Active, Pre-charge,
Read, or Write commands. During a Load Mode Register command, BA0
and BA1 are used to select between the Base or Extended Mode Register
CAS
is Column Access Strobe, which is an input to the device command
along with
RAS
and
WE
. See “Command Truth Table” for details.
Clock Enable: CKE High activates and CKE Low de-activates internal clock
signals and input/output buffers. When CKE goes Low, it can allow Self
Refresh, Pre-charge Power Down, and Active Power Down. CKE must be
High during entire Read and Write accesses. Input buffers except CK,
CK
, and CKE are disabled during Power Down. CKE uses an SSTL 2
input, but will detect a LVCMOS Low level after VDD is applied.
All address and command inputs are sampled on the rising edge of the
clock input CK and the falling edge of the differential clock input
CK
.
Output data is referenced from the crossings of CK and
CK
.
The Chip Select input enables the Command Decoding block of the device.
When
CS
is disabled, a NOP occurs. See “Command Truth Table” for
details. Multiple DDR SDRAM devices can be managed with
CS
.
These are the Data Mask inputs. During a Write operation, the Data Mask
input allows masking of the data bus. DM is sampled on each edge of DQS.
There are two Data Mask input pins for the x16 DDR SDRAM. Each input
applies to DQ0-DQ7, or DQ8-DQ15.
These are the Data Strobe inputs. The Data Strobe is used for data capture.
During a Read operation, the DQS output signal from the device is edge-
aligned with valid data on the data bus. During a Write operation, the DQS
input should be issued to the DDR SDRAM device when the input values on
DQ inputs are stable. There are two Data Strobe pins for the x16 DDR
SDRAM. Each of the two Data Strobe pins applies to DQ0-DQ7, or DQ8-
DQ15.
The pins DQ0 to DQ15 represent the data bus. For Write operations, the
data bus is sampled on Data Strobe. For Read operations, the data bus is
sampled on the crossings of CK and
CK
.
No Connect: This pin should be left floating. These pins could be used for
256Mbit or higher density DDR SDRAM.
RAS
is Row Access Strobe, which is an input to the device command
along with
CAS
and
WE
. See “Command Truth Table” for details.
WE
is Write Enable, which is an input to the device command along with
RAS
and
CAS
. See “Command Truth Table” for details.
VDDQ is the output buffer power supply.
VDD is the device power supply.
VREF is the reference voltage for SSTL 2.
VSSQ is the output buffer ground.
VSS is the device ground.
BA0, BA1
Input Pin
CAS
Input Pin
CKE
Input Pin
CK,
CK
Input Pin
CS
Input Pin
LDM, UDM
Input Pin
LDQS, UDQS
Input/Output Pin
DQ0-DQ15
Input/Output Pin
NC
—
RAS
Input Pin
WE
Input Pin
VDDQ
VDD
VREF
VSSQ
VSS
Power Supply Pin
Power Supply Pin
Power Supply Pin
Power Supply Pin
Power Supply Pin
相關PDF資料
PDF描述
IS43R16800A1-5TL 8Meg x 16 128-MBIT DDR SDRAM
IS43R32400A 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-5B 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-5BL 4Meg x 32 128-MBIT DDR SDRAM
IS43R32400A-6B 4Meg x 32 128-MBIT DDR SDRAM
相關代理商/技術參數
參數描述
IS43R16800A1-5TL 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A-5T 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5TL 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5TL-TR 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800A-5T-TR 功能描述:動態隨機存取存儲器 128M 2.5v 8Mx16 400MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*