- 您現在的位置：買賣IC網 > PDF目錄379211 > IL1815N (INTEGRAL JOINT STOCK COMPANY) AMPLIFIER IC FOR SENSORS WITH DIFFERENT CONDUCTANCE PDF資料下載
參數資料
| 型號： | IL1815N |
| 廠商： | INTEGRAL JOINT STOCK COMPANY |
| 英文描述： | AMPLIFIER IC FOR SENSORS WITH DIFFERENT CONDUCTANCE |
| 中文描述： | 放大器IC與不同電導傳感器 |
| 文件頁數： | 5/8頁 |
| 文件大小： | 195K |
| 代理商： | IL1815N |
IL1815
5
pin 09) or processed input signal (from pin 03), having passed the controller of data
transmission delay, for transmission to output stage of IC logic block.
The amplifier is started by incoming positive threshold voltage that is generated during
effect of voltage peak on output 07. This peak appears when input signal comes into
output 03 of the circuit and its maximum value varies in time with input signal amplitude.
Thus, input hysteresis changes with amplitude of input signal. That allows electrical circuit
to perceive the signal where high-frequency noise is grater than amplitude of input signal
of lower frequency. Minimum amplitude of input signal V
I
= 75 mV.
Latching circuit of input voltage.
Voltage of input signal on output 03 is internally fixed.
Напряжение
входного
сигнала
на
выводе
03
внутренне
зафиксировано
. Remaining
limit of input signal on this output is ensured by external resistor R3 (see fig.1), which is to
be chosen to provide maximum current (amplitude value)
±
3 mA in normal operation
conditions.
T1
R2
2kOhm
R1
1kOhm
R3
1kOhm
Vp
T4
T2
T3
T5
T6
T7
Output 03
Input voltage latching circuit
.
Positive inputs of amplifiers (from output 03) are fixed in electrical circuit (see fig.2) by
connected in series resistor R3 and diode T4 connected to ground. Therefore for
changes of input signal exceeding 500 mV relative to ground level, input current will be
dropped on ground through output 02 of the device. On the other hand, active limits
of the above mentioned
latch
tie output 3 usually to 350 mV below ground level for
negative input signals (see R1, R2, T2, T3 in fig.2). Thus, for transmitting input signal more
相關PDF資料 |
PDF描述 |
|---|---|
| IL19006 | THREE PHASE POWER/ENERGY METERING IC WITH INSTANTANEOUS PULSE OUTPUT |
| IL202 | Optocoupler DC-IN 1-CH Transistor With Base DC-OUT 6-Pin PDIP |
| IL203 | Optocoupler DC-IN 1-CH Transistor With Base DC-OUT 6-Pin PDIP |
| IL203-X009T | Optocoupler - Transistor Output, TRANSISTOR OUTPUT OPTOCOUPLER |
| IL202-X001 | OPTOCOUPL DC-IN 1CH TRANS W/BASE DC-OUT 6PDIP - Bulk |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IL19006 | 制造商:INTEGRAL 制造商全稱:INTEGRAL 功能描述:THREE PHASE POWER/ENERGY METERING IC WITH INSTANTANEOUS PULSE OUTPUT |
| IL19-C20-H05-3150-200 | 制造商:Schaffner 功能描述:Power Cord with locking system, 250VAC, 50/60Hz, 16A 制造商:Schaffner 功能描述:Locking C19 IEC Cable 2M C20 IEC End |
| IL19-C20-SJT-3160-183 | 功能描述:6.0' (1.83m) Power Cord Black IEC 320-C20 To IEC 320-C19 SJT 制造商:schaffner emc inc. 系列:- 零件狀態:有效 樣式:公頭插針（刀片）到插座（插槽） 第一連接器:IEC 320-C20 第二連接器:IEC 320-C19 導體數:3 電線類型:SJT 線規:- 屏蔽:- 長度:6.0'（1.83m） 認證標記:CSA，KEMA，PSE，RoHS，UR 認證國家/地區:加拿大，日本，荷蘭，英國，美國 顏色:黑 額定電壓:250V 額定電流:16A 工作溫度:-25°C ~ 70°C 特性:- 標準包裝:50 |
| IL19-EU1-H05-3150-200 | 制造商:Schaffner 功能描述:Locking C19 IEC Cable 2M EU Plug |
| IL19-SE-H05-3150-200 | 制造商:Schaffner 功能描述:POWER CORD IEC C19/ FREE END 制造商:Schaffner 功能描述:POWER CORD, IEC C19/ FREE END, 2M, 16A 制造商:Schaffner 功能描述:Locking C19 IEC CableE 2M Stripped End |
發布緊急采購，3分鐘左右您將得到回復。