175
8006K–AVR–10/10
ATtiny24/44/84
Notes:
1. Typical values at +25
°C.
2. “Min” means the lowest value where the pin is guaranteed to be read as high.
3. “Max” means the highest value where the pin is guaranteed to be read as low.
4. Although each I/O port can sink more than the test conditions (10 mA at VCC = 5V, 5 mA at VCC = 3V) under steady state
conditions (non-transient), the sum of all I
OL (for all ports) should not exceed 60 mA. If IOL exceeds the test conditions, VOL
may exceed the related specification. Pins are not guaranteed to sink current greater than the listed test condition.
5. Although each I/O port can source more than the test conditions (10 mA at VCC = 5V, 5 mA at VCC = 3V) under steady state
conditions (non-transient), the sum of all I
OH (for all ports) should not exceed 60 mA. If IOH exceeds the test condition, VOH
may exceed the related specification. Pins are not guaranteed to source current greater than the listed test condition.
6. The RESET pin must tolerate high voltages when entering and operating in programming modes and, as a consequence,
enabled (PRR = 0xFF) and there is no I/O drive.
8. BOD Disabled.
20.3
Speed
The maximum operating frequency of the device depends on V
CC relationship is linear between 1.8V < VCC < 2.7V
and between 2.7V < V
CC < 4.5V.
Figure 20-1. Maximum Frequency vs. V
CC (ATtiny24V/44V/84V)
ICC
Power Supply Current
Active 1MHz, VCC = 2V
0.33
0.8
mA
Active 4MHz, VCC = 3V
1.6
2.5
mA
Active 8MHz, VCC = 5V
5
9
mA
Idle 1MHz, VCC = 2V
0.11
0.4
mA
Idle 4MHz, VCC = 3V
0.4
1.0
mA
Idle 8MHz, VCC = 5V
1.5
3.5
mA
Power-down mode
WDT enabled, VCC = 3V
4.5
10
A
WDT disabled, VCC = 3V
0.15
2
A
Table 20-1.
DC Characteristics. T
A = -40°C to +85°C (Continued)
Symbol
Parameter
Condition
Min
Typ
(1)
Max
Units
10 MHz
4 MHz
1.8V
2.7V
5.5V
Safe Operating Area