參數資料
型號: IDT82V3255DKG
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 通信及網絡
英文描述: WAN PLL
中文描述: SPECIALTY TELECOM CIRCUIT, PQFP64
封裝: GREEN, TQFP-64
文件頁數: 46/127頁
文件大小: 868K
代理商: IDT82V3255DKG
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
IDT82V3255
WAN PLL
Programming Information
46
June 19, 2006
6
PROGRAMMING INFORMATION
After reset, all the registers are set to their default values. The regis-
ters are read or written via the microprocessor interface.
Before
PROTECTION_CNFG is recommended to be confirmed to make sure
whether the write operation is enabled. The device provides 3 register
protection modes:
Protected mode: no other registers can be written except register
PROTECTION_CNFG itself;
Fully Unprotected mode: all the writable registers can be written;
Single Unprotected mode: one more register can be written
besides register PROTECTION_CNFG. After write operation
(not including writing a ‘1’ to clear a bit to ‘0’), the device auto-
matically switches to Protected mode.
any
write
operation,
the
value
in
register
Writing ‘0’ to the registers will take no effect if the registers are
cleared by writing ‘1’.
T0 and T4 paths share some registers, whose addresses are 27H,
28H, 2AH, 4EH, 4FH, 5AH, 5BH, 62H ~ 64H, 68H and 69H. The names
of shared registers are marked with a *. Before register read/write oper-
ation, register T4_T0_REG_SEL_CNFG is recommended to be con-
firmed to make sure whether the register operation is available for T0 or
T4 path.
The access of the Multi-word Registers is different from that of the
Single-word Registers. Take the registers (04H, 05H and 06H) for an
example, the write operation for the Multi-word Registers follows a fixed
sequence. The register (04H) is configured first and the register (06H) is
configured last. The three registers are configured continuously and
should not be interrupted by any operation. The crystal calibration con-
figuration will take effect after all the three registers are configured. Dur-
ing read operation, the register (04H) is read first and the register (06H)
is read last. The crystal calibration reading should be continuous and not
be interrupted by any operation.
Certain bit locations within the device register map are designated as
Reserved. To ensure proper and predictable operation, bits designated
as Reserved should not be written by the users. In addition, their value
should be masked out from any testing or error detection methods that
are implemented.
6.1
REGISTER MAP
Table 34
is the map of all the registers, sorted in an ascending order
of their addresses.
Table 34: Register List and Map
Address
(Hex)
Register Name
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Reference
Page
Global Control Registers
00
01
ID[7:0] - Device ID 1
ID[15:8] - Device ID 2
NOMINAL_FREQ[7:0]_CNFG - Crys-
tal Oscillator Frequency Offset Calibra-
tion Configuration 1
NOMINAL_FREQ[15:8]_CNFG - Crys-
tal Oscillator Frequency Offset Calibra-
tion Configuration 2
NOMINAL_FREQ[23:16]_CNFG
Crystal Oscillator Frequency Offset
Calibration Configuration 3
T4_T0_REG_SEL_CNFG - T0 / T4
Registers Selection Configuration
PHASE_ALARM_TIME_OUT_CNFG -
Phase Lock Alarm Time-Out Configu-
ration
ID[7:0]
ID[15:8]
P 51
P 51
04
NOMINAL_FREQ_VALUE[7:0]
P 52
05
NOMINAL_FREQ_VALUE[15:8]
P 52
06
-
NOMINAL_FREQ_VALUE[23:16]
P 52
07
-
-
-
T4_T0_SE
L
-
-
-
-
P 53
08
MULTI_FACTOR[1:0]
TIME_OUT_VALUE[5:0]
P 53
09
INPUT_MODE_CNFG - Input Mode
Configuration
AUTO_EX
T_SYNC_
EN
EXT_SYN
C_EN
PH_ALAR
M_TIMEO
UT
SYNC_FREQ[1:0]
IN_SONET
_SDH
-
REVERTIV
E_MODE
P 54
0A
DIFFERENTIAL_IN_OUT_OSCI_CNF
G - Differential Input / Output Port &
Master Clock Configuration
-
-
-
-
-
OSC_EDG
E
OUT1_PE
CL_LVDS
-
P 55
相關PDF資料
PDF描述
IDT82V3255TF WAN PLL
IDT82V3255TFG WAN PLL
IDT82V3280 WAN PLL
IDT82V3280DQ WAN PLL
IDT82V3280DQG WAN PLL
相關代理商/技術參數
參數描述
IDT82V3255DKG8 功能描述:IC PLL WAN SMC STRATUM 3 64-TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3255EDGBLANK 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3255TF 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3255TFBLANK 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3255TFG 功能描述:IC PLL WAN SMC STRATUM 3 64-TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT