- 您現在的位置：買賣IC網 > PDF目錄4019 > IDT79RC64T575-200DP (IDT, Integrated Device Technology Inc)IC MPU 64BIT EMB 200MHZ 208-QFP PDF資料下載
參數資料
| 型號： | IDT79RC64T575-200DP |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 27/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MPU 64BIT EMB 200MHZ 208-QFP |
| 標準包裝： | 24 |
| 處理器類型： | RISC 64-位 |
| 速度： | 200MHz |
| 電壓： | 2.5V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 208-BFQFP 裸露焊盤 |
| 供應商設備封裝： | 208-PQFP（28x28） |
| 包裝： | 托盤 |
| 其它名稱： | 79RC64T575-200DP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁
8 of 28
December 14, 2001
79RC64574 79RC64575
Interrupt Interface
Int*(5:0)
I
Interrupt
Six general processor interrupts, bit-wise ORed with bits 5:0 of the interrupt register.
NMI*
I
Non-maskable interrupt
Non-maskable interrupt, ORed with bit 6 of the interrupt register.
Initialization Interface
VCCOkI
VCC is OK
When asserted, this signal indicates to the processor that the power supply has been above the Vcc minimum
for more than 100 milliseconds and will remain stable. The assertion of VCCOk initiates the initialization
sequence.
ColdReset*
I
Cold reset
This signal must be asserted for a power on reset or a cold reset. ColdReset must be de-asserted synchro-
nously with SysClock.
Reset*
I
Reset
This signal must be asserted for any reset sequence. It can be asserted synchronously or asynchronously for
a cold reset, or synchronously to initiate a warm reset. Reset must be de-asserted synchronously with
SysClock.
ModeClock
O
Boot-mode clock
Serial boot-mode data clock output at the system clock frequency divided by two hundred fifty-six.
ModeIn
I
Boot-mode data in
Serial boot-mode data input.
JTAG Interface
TDI
I
JTAG Data In
On the rising edge of TCK, serial input data are shifted into either the Instruction register or Data register,
depending on the TAP controller state. An external pull-up resistor is required.
TDO
O
JTAG Data Out
On the falling edge of TCK, the TDO is serial data shifted out from either the instruction or data register. When
no data is shifted out, the TDO is tri-stated (high impedance).
TCK
I
JTAG Clock Input
An input test clock used to shift into or out of the boundary-scan register cells. TCK is independent of the sys-
tem and processor clock with nominal 40-60% duty cycle.
TMS
I
JTAG Command Select
The logic signal received at the TMS input is decoded by the TAP controller to control test operation. TMS is
sampled on the rising edge of TCK. An external pull-up resistor is required.
TRST*
I
JTAG Reset
The TRST* pin is an active-low signal used for asynchronous reset of the debug unit, independent of the pro-
cessor logic. During normal CPU operation, the JTAG controller will be held in the reset mode, asserting this
active low pin.
When asserted low, this pin will also tristate the TDO pin. An external pull-down resistor is required.
JTAG32*
I
JTAG 32-bit scan
This pin is used to control length of the scan chain for SysAD (32-bit or 64-bit) for the JTAG mode. When set
to Vss, 32-bit bus mode is selected. In this mode, only SysAD(31:0) are part of the scan chain. When set to
Vcc, 64-bit bus mode is selected. In this mode, SysAD(63:0) are part of the scan chain. This pin has a built-in
pull-down device to guarantee 32-bit scan, if it is left un connected.
JR_Vcc
I
JTAG VCC
This pin has an internal pull-down to continuously reset the JTAG controller (if left unconnected) bypassing
the TRst* pin. When supplied with Vcc, the TRst* pin will be the primary control for the JTAG reset.
Pin Name
Type
Description
Table 5 Pin Descriptions (Page 2 of 2)
相關PDF資料 |
PDF描述 |
|---|---|
| GMC40DTEH | CONN EDGECARD 80POS .100 EYELET |
| FMC40DRAS-S734 | CONN EDGECARD 80POS .100 R/A SLD |
| RSC65DTEN | CONN EDGECARD 130POS .100 EYELET |
| RSC65DTEH | CONN EDGECARD 130POS .100 EYELET |
| EMC40DTES | CONN EDGECARD 80POS .100 EYELET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IDT79RC64T575-250DP | 功能描述:IC MPU 64BIT EMB 250MHZ 208-QFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| IDT79RC64V474-180DZ | 功能描述:IC MPU 64BIT EMB 180MHZ 128-QFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| IDT79RC64V474-200DZ | 功能描述:IC MPU 64BIT EMB 200MHZ 128-QFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| IDT79RC64V475-180DP | 功能描述:IC MPU 64BIT EMB 180MHZ 208-QFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
| IDT79RC64V475-200DP | 功能描述:IC MPU 64BIT EMB 200MHZ 208-QFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:- 標準包裝:2 系列:MPC8xx 處理器類型:32-位 MPC8xx PowerQUICC 特點:- 速度:133MHz 電壓:3.3V 安裝類型:表面貼裝 封裝/外殼:357-BBGA 供應商設備封裝:357-PBGA（25x25） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。