參數資料
型號： IDT72V51446L7-5BB8
廠商： IDT, Integrated Device Technology Inc
文件頁數： 19/57頁
文件大小： 0K
描述： IC FLOW CTRL MULTI QUEUE 256-BGA
標準包裝： 1,000
類型： 多隊列流量控制
安裝類型： 表面貼裝
封裝/外殼： 256-BBGA
供應商設備封裝： 256-BGA（17x17）
包裝： 帶卷 (TR)
其它名稱： 72V51446L7-5BB8
26
COMMERCIALANDINDUSTRIAL
TEMPERATURERANGES
IDT72V51436/72V51446/72V51456 3.3V, MULTI-QUEUE FLOW-CONTROL DEVICES
(16 QUEUES) 36 BIT WIDE CONFIGURATION 589,824, 1,179,648 and 2,359,296 bits
TABLE 4 — FLAG OPERATION BOUNDARIES & TIMING (CONTINUED)
NOTE:
n = Almost Empty Offset value.
Default values: if DF is LOW at Master Reset then n = 8
if DF is HIGH at Master Reset then n = 128
PAEn Timing
Assertion:
Read Operation to
PAEn LOW: 2 RCLK* + tPAE
De-assertion:
Write to
PAEn HIGH: tSKEW3 + RCLK* + tPAE
If tSKEW3 is violated there may be 1 added clock: tSKEW3 + 2 RCLK* + tPAE
* If a queue switch is occurring on the read port at the point of flag assertion or de-assertion
there may be one additional RCLK clock cycle delay.
Programmable Almost Empty Flag Bus,
PAEn Boundary
I/O Set-Up
PAEn Boundary Condition
in36 to out36
PAEn Goes HIGH after
(Both ports selected for same queue when the 1st
n+2 Writes
Word is written in until the boundary is reached)
(see note below for timing)
in36 to out36
PAEn Goes HIGH after
(Write port only selected for same queue when the n+1 Writes
1st Word is written in until the boundary is reached) (see note below for timing)
in36 to out18
PAEn Goes HIGH after n+1
Writes (see below for timing)
in36 to out9
PAEn Goes HIGH after n+1
Writes (see below for timing)
in18 to out36
PAEn Goes HIGH after
(Both ports selected for same queue when the 1st
([n+2] x 2) Writes
Word is written in until the boundary is reached)
(see note below for timing)
in18 to out36
PAEn Goes HIGH after
(Write port only selected for same queue when the ([n+1] x 2) Writes
1st Word is written in until the boundary is reached) (see note below for timing)
in9 to out36
PAEn Goes HIGH after
(Both ports selected for same queue when the 1st
([n+2] x 4) Writes
Word is written in until the boundary is reached)
(see note below for timing)
in9 to out36
PAEn Goes HIGH after
(Write port only selected for same queue when the ([n+1] x 4) Writes
1st Word is written in until the boundary is reached) (see note below for timing)
NOTE:
n = Almost Empty Offset value.
Default values:
if DF is LOW at Master Reset then n = 8
if DF is HIGH at Master Reset then n = 128
PAE Timing
Assertion:
Read Operation to
PAE LOW: 2 RCLK + tRAE
De-assertion: Write to
PAE HIGH: tSKEW2 + RCLK + tRAE
If tSKEW2 is violated there may be 1 added clock: tSKEW2 + 2 RCLK + tRAE
Programmable Almost Empty Flag,
PAE Boundary
I/O Set-Up
PAE Assertion
in36 to out36
PAE Goes HIGH after n+2
(Both ports selected for same queue when the 1st
Writes
Word is written in until the boundary is reached)
(see note below for timing)
in36 to out18
PAE Goes HIGH after n+1
(Both ports selected for same queue when the 1st
Writes
Word is written in until the boundary is reached)
(see note below for timing)
in36 to out9
PAE Goes HIGH after n+1
(Both ports selected for same queue when the 1st
Writes
Word is written in until the boundary is reached)
(see note below for timing)
in18 to out36
PAE Goes HIGH after
(Both ports selected for same queue when the 1st
([n+2] x 2) Writes
Word is written in until the boundary is reached)
(see note below for timing)
in9 to out36
PAE Goes HIGH after
(Both ports selected for same queue when the 1st
([n+2] x 4) Writes
Word is written in until the boundary is reached)
(see note below for timing)
PACKET READY FLAG,
PR BOUNDARY
Assertion:
Both the rising and falling edges of
PR are synchronous to RCLK.
PR Falling Edge occurs upon writing the first TEOP marker, on input D35,
(assuming a TSOP marker, on input D34 has previously been written). i.e. a
complete packet is available within a queue.
Timing:
From WCLK rising edge writing the TEOP word
PR goes LOW after: tSKEW4
+ 2 RCLK + tPR
If tSKEW4 is violated:
PR goes LOW after tSKEW4 + 3 RCLK + tPR
(Please refer to Figure 18, Data Input (Transmit) Packet Mode of Operation
for timing diagram).
De-assertion:
PRRisingEdgeoccursuponreadingthelastRSOPmarker,fromoutputQ34.
i.e. there are no more complete packets available within the queue.
Timing:
From RCLK rising edge Reading the RSOP word the
PR goes HIGH after: 2
RCLK + tPR
(Please refer to Figure 19, Data Output (Receive) Packet Mode of Operation
for timing diagram).
PACKET READY FLAG BUS,
PRn BOUNDARY
Assertion:
Both the rising and falling edges of
PRn are synchronous to RCLK.
PRn Falling Edge occurs upon writing the first TEOP marker, on input D35,
(assuming a TSOP marker, on input D34 has previously been written). i.e. a
complete packet is available within a queue.
Timing:
From WCLK rising edge writing the TEOP word
PR goes LOW after: tSKEW4
+ 2 RCLK* + tPAE
If tSKEW4 is violated
PRn goes LOW after tSKEW4 + 3 RCLK* + tPAE
*Ifaqueueswitchisoccurringonthereadportatthepointofflagassertionthere
may be one additional RCLK clock cycle delay.
De-assertion:
PRRisingEdgeoccursuponreadingthelastRSOPmarker,fromoutputQ34.
i.e. there are no more complete packets available within the queue.
Timing:
From RCLK rising edge Reading the RSOP word the
PR goes HIGH after:
2 RCLK* + tPAE
*If a queue switch is occurring on the read port at the point of flag assertion or
de-assertion there may be one additional RCLK clock cycle delay.
相關PDF資料
PDF描述
LFECP10E-3FN484I IC FPGA 10.2KLUTS 484FPBGA
LFECP10E-4FN484C IC FPGA 10.2KLUTS 484FPBGA
LFEC10E-3FN484I IC FPGA 10.2KLUTS 484FPBGA
LFEC10E-4FN484C IC FPGA 10.2KLUTS 484FPBGA
LFECP10E-3FN256I IC FPGA 10.2KLUTS 256FPBGA
相關代理商/技術參數
參數描述
IDT72V51446L7-5BBI 功能描述:IC FLOW CTRL MULTI QUEUE 256-BGA RoHS:否 類別:集成電路 (IC) >> 專用 IC 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:調幀器 應用:數據傳輸 安裝類型:表面貼裝 封裝/外殼:400-BBGA 供應商設備封裝:400-PBGA（27x27） 包裝:散裝
IDT72V51453L6BB 功能描述:IC FLOW CTRL MULTI QUEUE 256-BGA RoHS:否 類別:集成電路 (IC) >> 專用 IC 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:調幀器 應用:數據傳輸 安裝類型:表面貼裝 封裝/外殼:400-BBGA 供應商設備封裝:400-PBGA（27x27） 包裝:散裝
IDT72V51453L6BB8 功能描述:IC FLOW CTRL MULTI QUEUE 256-BGA RoHS:否 類別:集成電路 (IC) >> 專用 IC 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:調幀器 應用:數據傳輸 安裝類型:表面貼裝 封裝/外殼:400-BBGA 供應商設備封裝:400-PBGA（27x27） 包裝:散裝
IDT72V51453L7-5BB 功能描述:IC FLOW CTRL MULTI QUEUE 256-BGA RoHS:否 類別:集成電路 (IC) >> 專用 IC 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:調幀器 應用:數據傳輸 安裝類型:表面貼裝 封裝/外殼:400-BBGA 供應商設備封裝:400-PBGA（27x27） 包裝:散裝
IDT72V51453L7-5BB8 功能描述:IC FLOW CTRL MULTI QUEUE 256-BGA RoHS:否 類別:集成電路 (IC) >> 專用 IC 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:調幀器 應用:數據傳輸 安裝類型:表面貼裝 封裝/外殼:400-BBGA 供應商設備封裝:400-PBGA（27x27） 包裝:散裝
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*