- 您現在的位置：買賣IC網 > PDF目錄383077 > ICE3A1065L (INFINEON TECHNOLOGIES AG) Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/Depletion CoolMOS⑩ and Latched off Mode PDF資料下載
參數資料
| 型號： | ICE3A1065L |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 英文描述： | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/Depletion CoolMOS⑩ and Latched off Mode |
| 中文描述： | 離線式開關電源電流模式控制器，集成了?650V啟動細胞/消耗的CoolMOS⑩和鎖存關閉模式 |
| 文件頁數： | 14/28頁 |
| 文件大小： | 525K |
| 代理商： | ICE3A1065L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
CoolSET-F3
ICE3xxx65L
Functional Description
Version 2.0
14
8 May 2006
exceeded. Therefore the overvoltage detection is only
activated if the FB signal is outside the operating range
> 4.8V, e.g. when Open Loop happens. This means
any small voltage overshoots of V
VCC
during normal
operating can not start the Latched Off Mode.
The internal Voltage Reference is switched off once
Latched Off Mode is entered in order to reduce the
current consumption of the IC as much as possible.
Latched Off Mode can only be reset by decreasing
V
VCC
< 6V. In this stage, only the UVLO is working
which controls the Startup Cell by switching on/off at
V
VCCon
/V
VCCoff
. During this phase, the average current
consumption is only 300
μ
A. As there is no longer a self-
supply by the auxiliary winding, VCC drops. The
Undervoltage Lockout switches on the integrated
Startup Cell when VCC falls below 8.5V. The Startup
Cell is switched off again when VCC has exceeded
15V. Once the Latched Off Mode was entered, there is
no Start Up Phase after VCC has exceeded the switch-
on level of the Undervoltage Lockout. Therefore VCC
changes between the switch-on and switch-off levels of
the Undervoltage Lockout with a saw tooth shape (see
Figure 18).
Figure 18
Signals in Latched Off Mode
The Thermal Shutdown block monitors the junction
temperature of the IC. After detecting a junction
temperature higher than 140°C, Latched Off Mode is
entered.
The signals coming from the temperature detection and
VCC overvoltage detection are fed into a spike
blanking with a time constant of 8.0
μ
s to ensure system
reliability.
Furthermore, a short winding or short diode on the
secondary side can be detected by the comparator C11
which is in parallel to the propagation delay
compensated current limit comparator C10. In normal
operating mode comparator C10 keeps the maximum
level of the CS signal at 1V. If there is a failure such as
short winding or short diode, C10 is no longer able to
limit the CS signal at 1V. C11 detects then the over
current and enters immediately the Latched Off Mode
to keep the SMPS in a safe stage.
3.6.3.2
Auto Restart Mode
Figure 19
Auto Restart Mode
In case of Overload or Open Loop, FB exceeds 4.8V
which will be observed by C4. At this time S1 is
released that V
SoftS
can increase. If V
SoftS
exceeds 5.4V
which is observed by C3, Auto Restart Mode is entered
as both inputs of the gate G5 are high. In combining the
FB and SoftS signals, there is a blanking window
generated which prevents the system to enter Auto
Restart Mode due to large load jumps. This time
window is the same as for the Active Burst Mode and
can therefore be adjusted by the external C
SoftS
.
In case of VCC undervoltage, the IC enters into the
Auto Restart Mode and starts a new startup cycle.
Short Optocoupler also leads to VCC undervoltage as
there is no self supply after activating the internal
reference and bias.
In contrast to the Latched Off Mode, there is always a
Startup Phase with switching cycles in Auto Restart
Mode. After this Start Up Phase, the conditions are
again checked whether the failure mode is still present.
Normal operation is resumed once the failure mode is
removed that had caused the Auto Restart Mode.
8.5V
t
I
VCCStart
t
1.05mA
V
OUT
V
VCC
t.b.d
C3
5.4V
C4
4.8V
&
G5
4.4V
S1
1
G2
Control Unit
5k
Auto
Restart
Mode
R
SoftS
6.5V
SoftS
FB
Voltage
Reference
相關PDF資料 |
PDF描述 |
|---|---|
| ICE3B0365L | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/Depletion CoolMOS⑩ and Latched off Mode |
| ICE3A1565L | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/Depletion CoolMOS⑩ and Latched off Mode |
| ICE3A2565 | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/CoolMOS |
| ICE3A3065I | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/CoolMOS |
| ICE3A3065P | Off-Line SMPS Current Mode Controller with integrated 650V Startup Cell/CoolMOS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICE3A1065LJ | 功能描述:電流型 PWM 控制器 CoolSET F3 650V RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| ICE3A1065LJHKLA1 | 制造商:Infineon Technologies AG 功能描述:Current Mode PWM Controller 650V 1A 8-Pin PDIP 制造商:Infineon Technologies AG 功能描述:IC OFFLINE CTRLR SMPS OTP 8DIP |
| ICE3A1065LXK | 制造商:Infineon Technologies AG 功能描述:Current Mode PWM Controller 8-Pin PDIP |
| ICE3A1065XK | 制造商:Infineon Technologies AG 功能描述:Current Mode PWM Controller 650V 1A 8-Pin PDIP |
| ICE3A1565 | 功能描述:電流型 PWM 控制器 Off-Line SMPS Currnt Mode CTRLR 650V RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。