參數資料
型號： HFBR-5103
英文描述： 1300 nm 2000 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(1300 nm 2000 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
中文描述： 1300納米2000米，光纖分布式數據介面，100 Mbps的自動取款機，并在低成本1x9封裝形式快速以太網收發器（1300納米2000米，光纖分布式數據介面，100 Mbps的自動取款機，快速以太網收發器（低價格1x9封裝類型））
文件頁數： 2/24頁
文件大?。?/td> 351K
代理商： HFBR-5103
2
ATM applications for physical
layers other than 100 Mbps
Multimode Fiber Interface are
supported by Agilent. Products
are available for both the single
mode and the multimode fiber
SONET OC-3c (STS-3c) ATM
interfaces and the 155 Mbps/194
MBd multimode fiber ATM
interface as specified in the ATM
Forum UNI.
Contact your Agilent sales
representative for information on
these alternative FDDI and ATM
products.
Low Cost 500 m Desktop
Links
The HFBR-5105/-5105T are
1300 nm products which are fully
compliant with the requirements
of the FDDI LCF-PMD standard.
The FDDI LCF-PMD standard is
in the final approval stage as ISO/
IEC WD 9314-9 and ANSI LCF-
PMD Revision 1.3.
These multimode fiber trans-
ceivers can be used for 500 meter
backbone and desktop links for
FDDI, Fast Ethernet, or ATM 100
Mbps traffic.
The HFBR-5105 transceiver
utilizes the duplex SC connector
receptacle specified in the FDDI
LCF-PMD standard.
Alternative 800 nm Low Cost
500 m Desktop Links
The HFBR-5104/-5104T are very
low cost 800 nm alternative to
the HFBR-5105/-5105T for FDDI,
ATM or Fast Ethernet links from
the wiring closet to the desktop.
They comply with the perform-
ance requirements of the draft
FDDI LCF-PMD document as
translated by Agilent to the 800
nm wavelength. This transceiver
will transfer the full range of
FDDI signals at the required
1x10
-12
Bit Error Rate over
distances up to 500 meters using
62.5/125
μ
m multimode fiber
cables.
This product is intended for use
in cost sensitive applications
where the benefits of fiber optic
links are important.
Transmitter Sections
The transmitter sections of the
HFBR-5103 and HFBR-5105
series utilize 1300 nm Surface
Emitting InGaAsP LEDs and the
HFBR-5104 series uses a low cost
820 nm AlGaAs LED. These LEDs
are packaged in the optical
subassembly portion of the
transmitter section. They are
driven by a custom silicon IC
which converts differential PECL
logic signals, ECL referenced
(shifted) to a +5 Volt supply, into
an analog LED drive current.
Receiver Sections
The receiver sections of the
HFBR-5103 and HFBR-5105
series utilize InGaAs PIN photo-
diodes coupled to a custom
silicon transimpedance preampli-
fier IC. The HFBR-5104 series
uses the same preamplifier IC in
conjunction with an inexpensive
silicon PIN photodiode. These are
packaged in the optical sub-
assembly portion of the receiver.
These PIN/preamplifier combi-
nations are coupled to a custom
quantizer IC which provides the
final pulse shaping for the logic
output and the Signal Detect
function. The data output is dif-
ferential. The signal detect output
is single-ended. Both data and
signal detect outputs are PECL
compatible, ECL referenced
(shifted) to a +5 Volt power
supply.
Package
The overall package concept for
the HP transceivers consists of
the following basic elements; two
optical subassemblies, an
electrical subassembly and the
housing as illustrated in Figure 1
and Figure 1a.
The package outline drawing and
pin out are shown in Figures 2,
2a and 3. The details of this
package outline and pin out are
compliant with the multisource
Figure 1. Block Diagram.
DATA OUT
SIGNAL
DETECT OUT
DATA IN
ELECTRICAL SUBASSEMBLY
QUANTIZER IC
DRIVER IC
TOP VIEW
PIN PHOTODIODE
DUPLEX SC
RECEPTACLE
OPTICAL
SUBASSEMBLIES
LED
PREAMP IC
DIFFERENTIAL
SINGLE-ENDED
DIFFERENTIAL
相關PDF資料
PDF描述
HFBR-5103T 1300 nm 2000 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(1300 nm 2000 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
HFBR-5104T 800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
HFBR-5105T 1300nm 500 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(1300nm 500 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
HFBR-5104 800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, and Fast Ethernet Transceivers in Low Cost 1x9 Package Style(800 nm 500 m，F(xiàn)DDI, 100 Mbps ATM, 快速以太網收發器（低價格 1x9 封裝類型）)
HFBR-5107T 820 nm，100VG-AnyLAN Multimode Fiber Transceivers in Low Cost 1x9 Package Style(820 nm，100VG-AnyLAN 多模式光收發器（低價格 1x9封裝類型）)
相關代理商/技術參數
參數描述
HFBR-5103A 制造商:Rochester Electronics LLC 功能描述: 制造商:Avago Technologies 功能描述:
HFBR-5103AT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:125 MBd ATM and Fast Ethernet Transceiver in Low Cost 1x9 Package: Extended Temp.. ST Receptacle
HFBR-5103E 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecomm/Datacomm
HFBR-5103F 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecomm/Datacomm
HFBR-5103J 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecomm/Datacomm
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*