參數資料
型號： HC55142IMZ
廠商： Intersil
文件頁數： 13/36頁
文件大?。?/td> 0K
描述： IC SLIC UNIVERSAL LP 28-PLCC
標準包裝： 37
系列： UniSLIC14
功能： 用戶線路接口概念（SLIC）
電路數： 1
電源電壓： 4.75 V ~ 5.25 V
電流 - 電源： 2.25mA
功率（瓦特）： 1.5W
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 28-LCC（J 形引線）
供應商設備封裝： 28-PLCC（11.51x11.51）
包裝： 管件
包括： 電池跟蹤抗削頂失真，回路和接地鍵檢測，振鈴控制
20
FN4659.13
June 1, 2006
SPM Pin
For optimum performance, the PC board interconnect the
SPM pin should be as short as possible. If pulses metering is
not being used, then this pin should be grounded as close to
the device pin as possible.
RLIM Pin
The current limiting resistor RLIM needs to be as close to the
RLIM pin as possible.
Layout of the 2-Wire Impedance Matching
Resistor ZT
Proper connection to the ZT pin is to have the external ZT
network as close to the device pin as possible.
The ZT pin is a high impedance pin that is used to set the
proper feedback for matching the impedance of the 2-wire
side. This will eliminate circuit board capacitance on this pin
to maintain the 2-wire return loss across frequency.
Digital Logic Inputs
Table 1 is the logic truth table for the 3V to 5V logic input
pins. A combination of the control pins C3, C2 and C1 select
1 of the possible 6 operating states. The 8th state listed is
Thermal Shutdown. Thermal Shutdown protection is invoked
if a fault condition on the tip or ring causes the junction
temperature of the die to exceed 175°C. A description of
each operating state and the control logic follows:
Open Circuit State (C3 = 0, C2 = 0, C1 = 0)
In this state, the tip and ring outputs are in a high impedance
condition (>1M
). No supervisory functions are available
and SHD and GKD outputs are at a TTL high level.
4-wire loopback testing can be performed in this state. With
the PTG pin floating, the signal on the VTX output is 180
o out
of phase and approximately 2 times the VRX input signal. If
the PTG pin is grounded, then the amplitude will be
approximately the same as its input and 180o out of phase.
Ringing State (C3 = 0, C2 = 0, C1 = 1)
In this state, the output of the ring relay driver pin (RRLY)
goes low (energizing the ring relay to connect the ringing
signal to the phone) if either of the following two conditions
are satisfied:
(1) The RSYNC_REV pin is grounded through a resistor -
This connection enables the RRLY pin to go low the instant
the ringing state is invoked, without any regard for the
ringing voltage (90VRMS -120VRMS) across the relay
contacts. The resistor (34.8k
to 70k) is required to limit
the current into the RSYNC_REV pin.
(2) A ring sync pulse is applied to the RSYNC_REV pin -
This connection enables the RRLY pin to go low at the
command of a ring sync pulse. A ring sync pulse should go
TABLE 1. DETECTOR STATES
STATE
C3
C2
C1
SLIC OPERATING STATE
ACTIVE DETECTOR
OUTPUT
SHD
GKD_ LVM
0
Open Circuit State
4 wire loopback test capability
HIGH
1
0
1
Ringing State
(Previous State cannot be Reverse
Active State)
Ring Trip Detector
HIGH
2
0
1
0
Forward Active State
Loop Current Detector
Ground Key Detector
3
0
1
Test Active State
Requires previous state to be in the
Forward Active state to determine the
On hook or Off hook status of the line.
On Hook Loopback Detector
LOW
Ground Key Detector
HIGH
Off Hook Loop Current Detector
LOW
Line Voltage Detector
4
1
0
Tip Open - Ground Start State
Ground Key Detector
5
1
0
1
Reserved
N/A
6
1
0
Reverse Active State
Loop Current Detector
Ground Key Detector
7
1
Test Reversal Active State
Requires previous state to be in the
Reverse Active state to determine the
On hook or Off hook status of the line.
On Hook Loop Current Detector
HIGH
Off Hook Loop Current Detector
LOW
Line Voltage Detector
8
X
Thermal Shutdown
LOW
HC55120, HC55121, HC55130, HC55140, HC55142, HC55143, HC55150
相關PDF資料
PDF描述
S9S08AW32E5MPUE MCU 32K FLASH AUTO MONET 64-LQFP
S9S08AW32E5MFUE MCU 32K FLASH AUTO MONET 64-QFP
MC9S08QE96CLK IC MCU 8BIT 96K FLASH 80-LQFP
HC55140IMZ IC SLIC UNIVERSAL LP 28-PLCC
MC9S08AC96MFGE MCU 8BIT 96K FLASH 44-LQFP
相關代理商/技術參數
參數描述
HC55142IMZ96 功能描述:電信線路管理 IC HC55142IM IN TAPE RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
HC55143 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power Universal SLIC Family
HC55143IM 功能描述:IC SLIC UNIVERSAL LP 32-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:UniSLIC14 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:*
HC5514X 制造商:Harris Corporation 功能描述:
HC5514XB 制造商:Harris Corporation 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*