- 您現在的位置：買賣IC網 > PDF目錄370429 > HB28D064MM2 (Hitachi,Ltd.) MultiMediaCard 16 Mbyte/32 Mbyte/64 Mbyte/128 MByte PDF資料下載
參數資料
| 型號： | HB28D064MM2 |
| 廠商： | Hitachi,Ltd. |
| 英文描述： | MultiMediaCard 16 Mbyte/32 Mbyte/64 Mbyte/128 MByte |
| 中文描述： | 多媒體16 Mbyte/32 Mbyte/64 Mbyte/128字節 |
| 文件頁數： | 26/88頁 |
| 文件大?。?/td> | 329K |
| 代理商： | HB28D064MM2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
HB28E016/D032/D064/B128MM2
26
Read, Write and Erase Time-out Conditions
The times after which a time-out condition for read/write/erase operations occurs are (card independent) 10
times longer than the access/program times for these operations given below. A card shall complete the
command within this time period, or give up and return an error message. If the host does not get a
response within the defined time-out it should assume the card is not going to respond anymore and try to
recover (e.g. reset the card, power cycle, reject, etc.). The typical access and program times are defined as
follows:
Read
The read access time is defined as the sum of the two times given by the CSD parameters TAAC and
NSAC (refer to Table “Card Specific Data (CSD)”). These card parameters define the typical delay
between the end bit
of the read command and the start bit of the data block. This number is card dependent
and should be used by the host to calculate throughput and the maximal frequency for stream read.
Write
The R2W_FACTOR field in the CSD is used to calculate the typical block program time obtained by
multiplying the read access time by this factor. It applies to all write/erase commands (e.g.
SET(CLEAR)_WRITE_PROTECT, PROGRAM_CSD(CID) and the block write commands). It should be
used by the host to calculate throughput and the maximal frequency for stream write.
Erase
The duration of an erase command will be (order of magnitude) the number of sectors to be erased
multiplied by the block write delay.
相關PDF資料 |
PDF描述 |
|---|---|
| HB28E016MM2 | MultiMediaCard 16 Mbyte/32 Mbyte/64 Mbyte/128 MByte |
| HB28C048A6 | FLASH ATA Card |
| HB28C048C6 | CompactFlash⑩ |
| HB28C016A6 | FLASH ATA Card |
| HB28C016C6 | CompactFlash⑩ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HB2A102K-S265B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
| HB2A102K-S565B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
| HB2A103K-S565B | 制造商:Hitano Enterprise Corp 功能描述: |
| HB2A122K-S265B | 制造商:Hitano Enterprise Corp 功能描述: |
| HB2A122K-S565B | 制造商:Hitano Enterprise Corp 功能描述:Bulk |
發布緊急采購，3分鐘左右您將得到回復。