- 您現在的位置：買賣IC網 > PDF目錄67593 > FW330G71-56T 1-OUTPUT 250 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | FW330G71-56T |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 250 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | 2.40 X 4.60 INCH, 0.57 INCH HEIGHT, POWER MODULE |
| 文件頁數： | 9/29頁 |
| 文件大小： | 347K |
| 代理商： | FW330G71-56T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
16
Tyco Electronics Corp.
Advance Data Sheet
March 2000
36 to 75 Vdc Input, 3.6, 3.3, 2.5, 2.0, or 1.8 Vdc Output; 180 W to 330 W
FW330 Power Modules: dc-dc Converters;
Feature Descriptions (continued)
Module Synchronization
SYNC OUT Pin
This pin contains a clock signal referenced to the VI(–)
pin. The frequency of this signal will equal either the mod-
ule’s internal clock frequency or the frequency estab-
lished by an external clock applied to the SYNC IN pin.
When synchronizing several modules together, the
modules can be connected in a daisy-chain fashion
where the SYNC OUT pin of one module is connected
to the SYNC IN pin of another module. Each module in
the chain will synchronize to the frequency of the rst
module in the chain.
To avoid loading effects, ensure that the SYNC OUT
pin of any one module is connected to the SYNC IN pin
of only one module. Any number of modules can be
synchronized in this daisy-chain fashion.
Overtemperature Protection
These modules feature an overtemperature protection
circuit to safeguard against thermal damage. The cir-
cuit shuts down and latches off the module when the
maximum case temperature is exceeded. The module
can be restarted by cycling the dc input power for at
least 1.0 second or by toggling the remote on/off signal
for at least 1.0 second.
Forced Load Sharing (Parallel Operation)
For either redundant operation or additional power
requirements, the power module can be congured for
parallel operation with forced load sharing (see Figure
26). For a typical redundant conguration, fuses or an
equivalent should be used to protect against short-cir-
cuit conditions. Because of the remote sense, the for-
ward-voltage drops across the fuses do not affect the
set point of the voltage applied to the load. For addi-
tional power requirements, where multiple units are
used to develop combined power in excess of the rated
maximum, the fuses are not needed.
An internal anti-rollback circuit prevents either output
voltage from falling more than 1 V below the other dur-
ing light load operation.
Good layout techniques should be observed for noise
immunity. To implement forced load sharing, the follow-
ing connections must be made:
s
The parallel pins of all units must be connected
together. The paths of these connections should be
as direct as possible.
s
All remote-sense pins must be connected to the
power bus at the same point. That is, connect all
remote-sense (+) pins to the (+) side of the power
bus at the same point, and connect all remote-sense
(–) pins to the (–) side of the power bus at the same
point. Close proximity and directness are necessary
for good noise immunity.
s
Add a 1000 pF capacitor across the PARALLEL pin
and SENSE(–) pin of each module. Locate the
capacitor as close to the module as possible.
8-581 (C).d
Figure 26. Wiring Conguration for Redundant
Parallel Operation
Power Good Signal
The power good signal (PWRGOOD pin) is an open-
collector, secondary-referenced pin that is pulled low
when all ve of the following conditions are met:
1.
The overvoltage shutdown latch is not set.
2.
The thermal shutdown latch is not set.
3.
The unit is not in current limit.
4.
Secondary internal bias is present.
5.
The sensed output voltage is greater than the out-
put undervoltage set-point.
VO(–)
PARALLEL
SENSE(+)
SENSE(–)
VO(+)
CASE
VI(+)
ON/OFF
VI(–)
VO(–)
PARALLEL
SENSE(+)
SENSE(–)
VO(+)
CASE
VI(+)
ON/OFF
VI(–)
相關PDF資料 |
PDF描述 |
|---|---|
| FW330S3R671-56 | 1-OUTPUT 330 W DC-DC REG PWR SUPPLY MODULE |
| FW330F1-33T | 1-OUTPUT 330 W DC-DC REG PWR SUPPLY MODULE |
| FW330Y1-33T | 1-OUTPUT 180 W DC-DC REG PWR SUPPLY MODULE |
| FW400R61-18 | 1-OUTPUT 392 W DC-DC REG PWR SUPPLY MODULE |
| FX2030C | SPECIALTY CONSUMER CIRCUIT, DIP42 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FW332 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| FW340 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:N-Channel and P-Channel Silicon MOSFETs General-Purpose Switching Device |
| FW-34-01-F-D-250-100 | 制造商:Samtec Inc 功能描述:.050'' BOARD SPACERS - Bulk |
| FW-34-01-F-D-280-125 | 制造商:Samtec Inc 功能描述:.050'' BOARD SPACERS - Bulk |
| FW-34-01-F-D-350-065 | 制造商:Samtec Inc 功能描述:CONN BD STACKER HDR 68 POS 1.27MM SLDR ST TH - Bulk |
發布緊急采購，3分鐘左右您將得到回復。