- 您現在的位置：買賣IC網 > PDF目錄375714 > FA3647P (FUJI ELECTRIC CO LTD) PWM control IC with light load power saving function For Switching Power Supply Control PDF資料下載
參數資料
| 型號： | FA3647P |
| 廠商： | FUJI ELECTRIC CO LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | PWM control IC with light load power saving function For Switching Power Supply Control |
| 中文描述： | 1 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | DIP-8 |
| 文件頁數： | 17/21頁 |
| 文件大小： | 406K |
| 代理商： | FA3647P |
FA3641P(N), FA3647P(N)
74
13. Correcting overload detection current (FA3641 only)
If the power supply output is overloaded, the IC overcurrent
limiting function restricts the output power and the overload
shutdown function stops the IC. The output current when an
overload occurs varies depending on the input voltage; the
higher the input voltage, the more the overload detection current
may increase.
If any problems occur as a result of the appearance of this
symptom, connect resistor R8 between current detection
resistor Rs and the IS (+) pin and add resistor R7 for correction
as shown in Figure 32. The standard resistance of R8 is several
hundred ohms, and that of R7 is from several hundred kilohms
to several megohms.
Note that the above correction slightly lowers the output current
when overload even where the input voltage is low. This
correction is available only for the FA3641 that uses positive
polarity for overcurrent detection.
14. Preventing malfunction caused by noise
The IS pin for overcurrent limiting function detects the MOSFET
current converted to the voltage. The parasitic capacitor and
inductor of the MOSFET, transformer, wiring, etc. cause a noise
in switching operation. If this switching noise causes a
malfunction of overcurrent limitimg function, insert the RC filter
into IS pin as shown in Figure 14.
Also, connect a noise prevention capacitor (0.1
μ
F or more) to
the REF pin that outputs the reference voltage for each
component.
15. Preventing malfunction caused by negative voltage
applied to a pin
When large negative voltage is applied to each IC pin, a
parasitic element in the IC may operate and cause malfunction.
Be careful not to allow the voltage applied to each pin to drop
below
–
0.3V.
Especially for the OUT pin, voltage oscillation caused after the
MOSFET turns off may be applied to the OUT pin via the
parasitic capacitance of the MOSFET, causing the negative
voltage to be applied to the OUT pin. If the voltage falls below
–
0.3V, add a Schottky diode between the OUT pin and the
ground. The forward voltage of the Schottky diode can suppress
the voltage applied to the OUT pin.
Use the low forward voltage of the Schottky diode. Similarly, be
careful not to cause the voltages at other pins to fall below
–
0.3V.
16. Gate circuit configuration
To adjust switching speeds or prevent oscillation at gate
terminals, resistors are normally inserted between the power
MOSFET gate terminal to be driven and the OUT pin of the IC.
You may prefer to decide on the drive current independently, to
turn the MOSFET on and off. If so, connect the MOSFET gate
terminal to the OUT pin of the IC as shown in Figure 34.
In the circuit shown in Figure 34, Rg1 and Rg2 restrict the
current when the MOSFET is turned on, and only Rg1 restricts
the current when it is turned off.
Fig. 33 Protection of OUT pin against the negative voltage
Fig. 32 Correcting overload detecting current circuit
Fig. 34 Gate circuit
相關PDF資料 |
PDF描述 |
|---|---|
| FA365 | THIN SMD HIGH-FREQUENCY CRYSTAL UNIT |
| FA-365 | THIN SMD HIGH-FREQUENCY CRYSTAL UNIT |
| FA3675F | For Switching Power Supply Control |
| FA3863X | SUPER BRIGHT LED |
| FA38SA50LC | RECTIFIER BRIDGE 25A 200V 350A-ifsm 1.05V-vf 10uA-ir GBJ 15/TUBE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FA3647P-D1 | 制造商:Fuji Electric 功能描述: |
| FA365 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:THIN SMD HIGH-FREQUENCY CRYSTAL UNIT |
| FA-365 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:THIN SMD HIGH-FREQUENCY CRYSTAL UNIT |
| FA-365 14.31818MHZ 50PPM 16PF | 制造商:Epson Toyocom Corporation 功能描述:XTAL FA-365 14.31818MHZ 50PPM 16PF |
| FA-365 16.0000MB-G3 | 功能描述:CRYSTAL 16.0000MHZ 20PF SMD RoHS:是 類別:晶體和振蕩器 >> 晶體 系列:FA-365 標準包裝:1 系列:ABLS2 類型:MHz 晶體 頻率:3.579545MHz 頻率穩定性:±30ppm 頻率公差:±30ppm 負載電容:18pF ESR（等效串聯電阻）:180 歐姆 工作模式:基諧 工作溫度:-40°C ~ 85°C 額定值:- 安裝類型:表面貼裝 封裝/外殼:HC49/US 尺寸/尺寸:0.449" L x 0.185" W（11.40mm x 4.70mm） 高度:0.130"（3.30mm） 包裝:剪切帶 (CT) 產品目錄頁面:1683 (CN2011-ZH PDF) 其它名稱:535-9855-1 |
發布緊急采購，3分鐘左右您將得到回復。