- 您現在的位置：買賣IC網 > PDF目錄299034 > EQD020A0F641Z (LINEAGE POWER LLC) 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | EQD020A0F641Z |
| 廠商： | LINEAGE POWER LLC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, EIGHTH BRICK-9 |
| 文件頁數： | 14/15頁 |
| 文件大?。?/td> | 272K |
| 代理商： | EQD020A0F641Z |
Data Sheet
November 9, 2006
EQD020 Series Single Output: Eighth Brick Power Modules:
19-60Vdc Input; 3.3Vdc Output; 66W
Tyco Electronics Power Systems
8
Test Configurations
Figure 16. Input Reflected Ripple Current Test
Setup.
NOTE: All voltage measurements to be taken at the module
terminals, as shown above. If sockets are used then
Kelvin connections are required at the module terminals
to avoid measurement errors due to socket contact
resistance.
VO(+)
COM
1uF .
RESISTIVE
LOAD
SCOPE
COPPER STRIP
GROUND PLANE
10uF
Figure 17. Output Ripple and Noise Test Setup.
η =
VO.IO
VIN.IIN
x 100 %
Efficiency
VO
COM
VIN(+)
COM
RLOAD
Rcontact
Rdistribution
Rcontact
Rdistribution
Rcontact
Rdistribution
VIN
VO
NOTE: All voltage measurements to be taken at the module
terminals, as shown above. If sockets are used then
Kelvin connections are required at the module terminals
to avoid measurement errors due to socket contact
resistance.
Figure 18. Output Voltage and Efficiency Test
Setup.
Design Considerations
Input Filtering
The power module should be connected to a low ac-
impedance source. Highly inductive source
impedance can affect the stability of the power
module. For the test configuration in Figure 16, a
33F electrolytic capacitor (ESR<0.1 at 100 kHz),
mounted close to the power module helps ensure the
stability of the unit. Consult your sales representative
for further applications guidelines.
Safety Considerations
For safety-agency approval of the system in which the
power module is used, the power module must be
installed in compliance with the spacing and
separation requirements of the end-use safety agency
standard, i.e., UL60950-1, CSA C22.2 No. 60950-1-
03, EN60950-1 and VDE 0805:2001-12.
These converters have been evaluated to the spacing
requirements for Basic Insulation, per the above
safety standards; and 1500 Vdc is applied from Vin to
Vout to 100% of outgoing production.
For end products connected to –48V dc nominal DC
MAINS (i.e. central office dc battery plant), no further
fault testing is required. For all input voltages, other
than DC MAINS, where the input voltage is less than
60V dc, if the input meets all of the requirements for
SELV, then:
The output may be considered SELV. Output
voltages will remain within SELV limits even with
internally-generated non-SELV voltages. Single
component failure and fault tests were performed
in the power converters.
One pole of the input and one pole of the output
are to be grounded, or both circuits are to be kept
floating, to maintain the output voltage to ground
voltage within ELV or SELV limits.
The power module has ELV (extra-low voltage)
outputs when all inputs are ELV.
All flammable materials used in the manufacturing of
these modules are rated 94V-0, or tested to the
UL60950 A.2 for reduced thickness.
The input to these units is to be provided with a
maximum 6.3 A very fast-acting surface mount fuse in
the unearthed lead.
TO OSCILLOSCOPE
CURRENT PROBE
LTEST
12μH
BATTERY
CS 220μF
Electrolytic
E.S.R.<0.1 Ω
@ 20°C 100kHz
33μF
Tantalum
VIN(+)
COM
NOTE: Measure input reflected ripple current with a simulated
source inductance (L TEST) of 12μH. Capacitor CS offsets
possible battery impedance. Measure current as shown
above.
CIN
相關PDF資料 |
PDF描述 |
|---|---|
| EQW006A0B1-S | 1-OUTPUT 72 W DC-DC REG PWR SUPPLY MODULE |
| EQW025A0Y61Z | 1-OUTPUT 45 W DC-DC REG PWR SUPPLY MODULE |
| EQW025A0Y1Z | 1-OUTPUT 45 W DC-DC REG PWR SUPPLY MODULE |
| EQW012A0A1 | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| EQXP-HC535R-FREQ1 | CRYSTAL OSCILLATOR, CLOCK, 0.75 MHz - 125 MHz, HCMOS OUTPUT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EQD020A0FZ | 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:Eighth Brick Through-Hole Power Modules |
| EQD075A1 | 功能描述:DC/DC轉換器 5V/3.3V 15A/20A 75W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| EQD075A1-HZ | 功能描述:DC/DC轉換器 75W 18-60V 5/3.3V 15/20A TH RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| EQD075A4 | 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:18-60Vdc Input; 3.3 to 5.0Vdc Output; 75W |
| EQD075A41 | 功能描述:DC/DC轉換器 TH 75W 15/20A IN 18-60V OUT 5/3.3V RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。