參數資料
型號: DSD1793
英文描述: DIODE, SMT SCHOTTKY 3A 60V SK36 SMC
中文描述: 24位192千赫采樣高級分段音頻立體聲數模轉換器
文件頁數: 14/47頁
文件大小: 428K
代理商: DSD1793
DSD1793
SLES075A MARCH 2003 REVISED JANUARY 2004
www.ti.com
21
Write Register
A master can write to any DSD1793 registers using single or multiple accesses. The master sends a DSD1793 slave
address with a write bit, a register address, and the data. If multiple access is required, the address is that of the
starting register, followed by the data to be transferred. When the data are received properly, the index register is
incremented automatically by 1. When the index register reaches 0x7F, the next value is 0x0. When undefined
registers are accessed, the DSD1793 does not send an acknowledgement. Figure 29 is a diagram of the write
operation.
Transmitter
M
S
M
S
M
S
M
S
S
M
Data Type
St
Slave
address
W
ACK
Register
address
ACK
Write data 1
ACK
Write data 2
ACK
ACK
Sp
M: Master device
S: Slave device
St: Start condition
ACK: Acknowledge
Sp: Stop condition
W: Write
Figure 29. Write Operation
Read Register
A master can read the DSD1793 register. The value of the register address is stored in an indirect index register in
advance. The master sends a DSD1793 slave address with a read bit after storing the register address. Then the
DSD1793 transfers the data which the index register points to. When the data are transferred during a multiple
access, the index register is incremented by 1 automatically. (When first going into read mode immediately following
a write, the index register is not incremented. The master can read the register that was previously written.) When
the index register reaches 0x7F, the next value is 0x0. The DSD1793 outputs some data when the index register is
0x10 to 0x1F, even if it is not defined in Table 4. Figure 30 is a diagram of the read operation.
Transmitter
M
S
M
S
M
S
M
M
Data Type
St
Slave
address
W
ACK
Register
address
ACK
Sr
Slave
address
R
ACK
Data
ACK
NACK
Sp
M: Master device
S: Slave device
St: Start condition
Sr: Repeated start condition
ACK: Acknowledge
Sp: Stop condition
NACK: Not Acknowledge
W: Write
R: Read
NOTE: The slave address after the repeat start condition must be the same as the previous slave address.
Figure 30. Read Operation
Noise Suppression
The DSD1793 incorporates noise suppression using the system clock (SCK). However, there must be no more than
two noise spikes in 600 ns. The noise suppression works for SCK frequencies between 8 MHz and 40 MHz in fast
mode. However, it works incorrectly in the particular following conditions.
Case 1:
1.
t(SCK) > 120 ns (t(SCK): period of SCK)
2.
t(HI) + t(DHD) < t(SCK) × 5
3.
Spike noise exists on the first half of the SCL HIGH pulse.
4.
Spike noise exists on the SDA HIGH pulse just before SDA goes LOW.
SCL
SDA
Noise
When these conditions occur at the same time, the data is recognized as LOW.
相關PDF資料
PDF描述
DS138632-120 RAMified Watchdog Timekeeper
DS1411 Serial Port iButton Holder
DS-808-4N Broadband Eight-Way Power Divider 20 - 2000 MHz
DS-808-4SMA Broadband Eight-Way Power Divider 20 - 2000 MHz
DS1867-010 Dual Digital Potentiometer with EEPROM
相關代理商/技術參數
參數描述
DSD1793DB 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
DSD1793DBG4 功能描述:音頻數/模轉換器 IC 24B 192kHz Sampl Adv Segment Aud St DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
DSD1793DBR 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
DSD1793DBRG4 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
DSD1794 制造商:TI 制造商全稱:Texas Instruments 功能描述:24-BIT, 192-kHz SAMPLING, ADVANCED SEGMENT, AUDIO STRRO DIGITAL-TO-ALALOG CONVERTER