參數資料
型號: DS2482S-100+
廠商: Maxim Integrated Products
文件頁數: 5/24頁
文件大?。?/td> 0K
描述: IC BRIDGE I2C TO 1-WIRE 8-SOIC
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 100
控制器類型: I²C 總線控制器
接口: I²C
電源電壓: 3.3V,5V
電流 - 電源: 750µA
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SOIC
包裝: 管件
產品目錄頁面: 1429 (CN2011-ZH PDF)
Single-Channel 1-Wire Master
1-Wire Write Byte
Command Code
A5h
Command Parameter
Data Byte
Description
Writes a single data byte to the 1-Wire line.
Typical Use
To write commands or data to the 1-Wire line. Equivalent to executing eight 1-Wire Single Bit
commands, but faster due to less I2C traffic.
Restriction
1-Wire activity must have ended before the DS2482-100 can process this command.
Error Response
Command code and data byte are not acknowledged if 1WB = 1 at the time the command code is
received and the command is ignored.
Command Duration
8 x tSLOT + maximum 262.5ns, counted from falling edge of the last bit (LSB) of the data byte.
1-Wire Activity
Begins maximum 262.5ns after falling SCL edge of the LSB of the data byte (i.e., before the data
byte acknowledge). Note: The bit order on the I2C bus and the 1-Wire line is different (1-Wire: LSB
first; I2C: MSB first). Therefore, 1-Wire activity cannot begin before the DS2482-100 has received
the full data byte.
Read Pointer Position
Status Register (for busy polling).
Status Bits Affected
1WB (set to 1 for 8 x tSLOT).
Configuration Bits Affected
1WS, SPU, APU apply.
1-Wire Read Byte
Command Code
96h
Command Parameter
None
Description
Generates eight read-data time slots on the 1-Wire line and stores result in the Read Data
Register.
Typical Use
To read data from the 1-Wire line. Equivalent to executing eight 1-Wire Single Bit commands with
V = 1 (write-one time slot), but faster due to less I2C traffic.
Restriction
1-Wire activity must have ended before the DS2482-100 can process this command.
Error Response
Command code is not acknowledged if 1WB = 1 at the time the command code is received and
the command is ignored.
Command Duration
8 x tSLOT + maximum 262.5ns, counted from the falling SCL edge of the command code
acknowledge bit.
1-Wire Activity
Begins maximum 262.5ns after the falling SCL edge of the command code acknowledge bit.
Read Pointer Position
Status Register (for busy polling). Note: To read the data byte received from the 1-Wire line, issue
the Set Read Pointer command and select the Read Data Register. Then access the DS2482-100
in read mode.
Status Bits Affected
1WB (set to 1 for 8 x tSLOT).
Configuration Bits Affected
1WS, APU apply.
DS2482-100
Maxim Integrated
13
相關PDF資料
PDF描述
PIC16LF1828-E/SO IC MCU 8BIT 7KB FLASH 20SOIC
PIC16F1828-E/SO IC MCU 8BIT 7KB FLASH 20SOIC
PIC16F722T-I/MV IC MCU 8BIT 3.5KB FLASH 28UQFN
VI-BNN-IW-F3 CONVERTER MOD DC/DC 18.5V 100W
PIC16LF722T-I/ML IC PIC MCU FLASH 3.5KB 28-QFN
相關代理商/技術參數
參數描述
DS2482S-100/R 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Single-Channel 1-Wire Master
DS2482S-100/T 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Single-Channel 1-Wire Master
DS2482S-100/T&R 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
DS2482S-100+ 功能描述:接口 - 專用 1-Wire Master RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
DS2482S-100+T&R 制造商:Maxim Integrated Products 功能描述: 制造商:Maxim Integrated Products 功能描述:SGL CH 1 WIRE MASTER 8SOIC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:SINGLE-CHANNEL 1-W LN DR 8SO/T&R LF 制造商:Maxim Integrated Products 功能描述:IC I2C TO 1WIRE BRIDGE 8SOIC 制造商:Maxim Integrated Products 功能描述:I2C to 1 Wire Bridge Device SOIC8 T/R