- 您現在的位置：買賣IC網 > PDF目錄385273 > DS2422 (MAXIM INTEGRATED PRODUCTS INC) 1K-Bit 1-Wire RAM with Counters(帶計數器的1K位1線串行RAM) PDF資料下載
參數資料
| 型號： | DS2422 |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | DRAM |
| 英文描述： | 1K-Bit 1-Wire RAM with Counters(帶計數器的1K位1線串行RAM) |
| 中文描述： | 1K X 1 STANDARD SRAM, PDSO6 |
| 封裝： | 3.70 X 4 X 1.50 MM, TSOC-6 |
| 文件頁數： | 23/23頁 |
| 文件大?。?/td> | 146K |
| 代理商： | DS2422 |
DS2422/DS2423
021998 23/23
NOTES:
1. All voltages are referenced to ground.
2. V
PUP
= external pull–up voltage.
3. Input load is to ground.
4. An additional reset or communication sequence cannot begin until the reset high time has expired.
5. Read data setup time refers to the time the host must pull the 1–Wire bus low to read a bit. Data is guaranteed
to be valid within 1
μ
s of this falling edge.
6. Capacitance on the data pin could be 800 pF when power is first applied. If a 5 k
resistor is used to pull up the
data line to V
PUP
, 5
μ
s after power has been applied the parasite capacitance will not affect normal communica-
tions.
7. The reset low time (t
RSTL
) should be restricted to a maximum of 960
μ
s, to allow interrupt signaling, otherwise,
it could mask or conceal interrupt pulses.
8. V
IH
is a function of the external pull–up resistor and V
PUP
.
9. Under certain low voltage conditions V
ILMAX
may have to be reduced to as much as 0.5V to always guarantee a
presence pulse.
10.The counter inputs are designed for interfacing to mechanical switches and piezo sensors. If interfacing to digital
circuits, one should use an open–drain driver.
11. A lower impedance pull–up, e. g., for reed switches, can be achieved by connecting an external resistor from the
counter input to V
BAT
.
12.Read and write scratchpad (all 32 bytes) at V
BAT
of 3.0 V.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2423 | 4K-Bit 1-Wire RAM with Counters(帶計數器的4K位1線串行RAM) |
| DS2450 | 1-Wire Quad A/D Converter(1線串行四路A/D轉換器) |
| DS2480 | Serial 1-Wire Line Driver(1線串行線驅動器) |
| DS2505-UNW | UniqueWare Add-only Memory(專用只加存儲器) |
| DS2506-UNW | UniqueWare Add-only Memory(專用只加存儲器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2422P | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Serial SRAM |
| DS2422S | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS2422S+ | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS2422X | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| DS2423 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:4kbit 1-Wire RAM with Counter |
發布緊急采購，3分鐘左右您將得到回復。