- 您現在的位置：買賣IC網 > PDF目錄97868 > DS229SN (DALLAS SEMICONDUCTOR) LINE TRANSCEIVER, PDSO20 PDF資料下載
參數資料
| 型號： | DS229SN |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Line Driver or Receiver |
| 英文描述： | LINE TRANSCEIVER, PDSO20 |
| 封裝： | SOIC-20 |
| 文件頁數： | 45/47頁 |
| 文件大?。?/td> | 413K |
| 代理商： | DS229SN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁
MAX1464
Low-Power, Low-Noise Multichannel
Sensor Signal Processor
7
Maxim Integrated
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
DIGITAL INPUTS (GPIO1, GPIO2, SCLK, DI, CKSEL, CKIO,
CS)
Input High Threshold Voltage
VIH
0.8 x
VDD
V
Input Low Threshold Voltage
VIL
0.2 x
VDD
V
Input Hysteresis
VIHYS
0.2
V
CKSEL,
CS = VSS
38
-90
Input Leakage Current
IIN
GPIO1, GPIO2, SCLK, DI, CKIO = VDD
38
+90
A
Input Capacitance
CIN
5pF
DIGITAL OUTPUTS (GPIO1, GPIO2, DO, CKIO)
GPIO1, GPIO2, DO
VDD - 0.1
RLOAD =
∞
CKIO (Note 10)
4.9
GPIO1, GPIO2, DO
VDD - 0.15
Output-Voltage High
VOH
RLOAD = 2k
Ω to VSS
CKIO (Note 10)
4.6
V
GPIO1, GPIO2, DO
0.05
RLOAD =
∞
CKIO (Note 10)
0.1
GPIO1, GPIO2, DO
0.2
Output-Voltage Low
VOL
RLOAD = 2k
Ω to VDD
CKIO (Note 10)
0.4
V
FLASH MEMORY
Maximum Erase Cycles
(Notes 11, 12)
10k
Cycles
Minimum Erase Time
tERASE
(Notes 11, 12)
4.2
ms
Minimum Write Time
tWRITE
(Notes 11, 12)
80
s
FLASH Programming Current
IDDFP
Writing to the FLASH or erasing the FLASH
(Note 13)
30
mA
ELECTRICAL CHARACTERISTICS (continued)
(VDDF = VDD = 4.5V to 5.5V, VSSF = VSS = 0V, fCLK = 4.0MHz, TA = TMIN to TMAX. Typical values are at VDDF = VDD = 5.0V, VSSF = VSS = 0V,
TA = +25°C, unless otherwise noted.) (Note 1)
Note 1:
Current into a pin is defined as positive. Current out of a pin is defined as negative. All voltages are referenced to VSS.
Note 2:
All modules are off, except internal reference, oscillator, and power-on reset (POR) and CKSEL bit is set to zero.
Note 3:
The CPU and ADC are not on at the same time. The ADC and CPU currents are not additive.
Note 4:
IDACn does not include output buffer currents (IOPLGn or IOPSMn).
Note 5:
For gains above 240, an additional digital gain can be provided by the CPU.
Note 6:
The PWM input data is the 12-bit left-justified data in the 16-bit input field.
Note 7:
PWM gain error measured as:
Note 8:
The internal reference voltage has a nominal value of 5V (4
VBG) even when VDD is greater or less than 5VDC.
Note 9:
Input-referred offset error is the ADC offset error divided by the PGA gain.
Note 10: When the CKIO is configured in output mode to observe the internal oscillator signal, the total current is above the
specified limits.
Note 11: fCLK must be within 5% of 4MHz.
Note 12: Allow a minimum elapsed time of 4.2ms when executing a FLASH erase command, before sending any other command.
Allow a minimum elapsed time of 80s between FLASH write commands.
Note 13: FLASH programming current is guaranteed by design.
GE
PWM
F
Xh
PWM
Xh
PWM
OUT
=
()
()
×
00
100
3584
100%
相關PDF資料 |
PDF描述 |
|---|---|
| DS2151Q | DATACOM, FRAMER, PQCC44 |
| DS229S | LINE TRANSCEIVER, PDSO20 |
| DS232AE | LINE TRANSCEIVER, PDSO20 |
| DS232AR | LINE TRANSCEIVER, PDSO16 |
| DS232AR-N | LINE TRANSCEIVER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS229SN+ | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| DS22B57 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x8 SRAM |
| DS22B57S | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x8 SRAM |
| DS22EV5110 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:DVI, HDMI Extended Reach Equalizer with Retimer and Output De-Emphasis |
| DS22EV5110-EVKC | 功能描述:DEMO KIT CAT5 EXTENDER HDMI RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
發布緊急采購，3分鐘左右您將得到回復。