參數資料
型號: DS2154
英文描述: WSD 151 SOLDERING STATION 230V UKWSD 151 SOLDERING STATION 230V UK; Frequency, supply max:60Hz; Frequency, supply min:50Hz; Height:101mm; Length:166mm; Power, input:150W; Temperature range:50(degree C) - 550(degree C); Voltage,
中文描述: 增強型E1單芯片收發器
文件頁數: 40/87頁
文件大小: 1106K
代理商: DS2154
DS2154
40 of 87
5.0 ERROR COUNT REGISTERS
There are a set of four counters in the DS2154 that record bipolar or code violations, errors in the CRC4
SMF code words, E bits as reported by the far end, and word errors in the FAS. Each of these four
counters are automatically updated on either 1-second boundaries (CCR2.7=0) or every 62.5 ms
(CCR2.7=1) as determined by the timer in Status Register 2 (SR2.4). Hence, these registers contain
performance data from either the previous second or the previous 62.5 ms. The user can use the interrupt
from the timer to determine when to read these registers. The user has a full second (or 62.5 ms) to read
the counters before the data is lost.
5.1 BPV or Code Violation Counter
Violation Count Register 1 (VCR1) is the most significant word and VCR2 is the least significant word of
a 16-bit counter that records either BiPolar Violations (BPVs) or Code Violations (CVs). If CCR2.6=0,
then the VCR counts bipolar violations. Bipolar violations are defined as consecutive marks of the same
polarity. In this mode, if the HDB3 mode is set for the receive side via CCR1.2, then HDB3 code words
are not counted as BPVs. If CCR2.6=1, then the VCR counts code violations as defined in ITU O.161.
Code violations are defined as consecutive bipolar violations of the same polarity. In most applications,
the DS2154 should be programmed to count BPVs when receiving AMI code and to count CVs when
receiving HDB3 code. This counter increments at all times and is not disabled by loss of sync conditions.
The counter saturates at 65,535 and will not rollover. The bit error rate on an E1 line would have to be
greater than 10**
-2
before the VCR would saturate.
VCR1: UPPER BIPOLAR VIOLATION COUNT REGISTER 1
(Address=00 Hex)
VCR2:LOWER BIPOLAR VIOLATION COUNT REGISTER 2
(Address=01 Hex)
(MSB) (LSB)
V15
V14
V13
V12
V11
V7
V6
V5
V4
V3
V10
V2
V9
V1
V8
V0
VCR1
VCR2
SYMBOL
POSITION
NAME AND DESCRIPTION
V15
VCR1.7
MSB of the 16-bit bipolar or code violation count .
V0
VCR2.0
LSB of the 16-bit bipolar or code violation count.
相關PDF資料
PDF描述
DS2155 T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface
DS2156 T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface
DS2156L T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface
DS2156LN T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface
DS2182 T1 Line Monitor
相關代理商/技術參數
參數描述
DS2154DK 功能描述:KIT DESIGN E1 DS2154 RoHS:否 類別:編程器,開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像,彩色(RGB) 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP
DS2154L 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2154L+ 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2154LA2 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2154LA2+ 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray