- 您現在的位置：買賣IC網 > PDF目錄379182 > DS2154 WSD 151 SOLDERING STATION 230V UKWSD 151 SOLDERING STATION 230V UK; Frequency, supply max:60Hz; Frequency, supply min:50Hz; Height:101mm; Length:166mm; Power, input:150W; Temperature range:50(degree C) - 550(degree C); Voltage, PDF資料下載
參數資料
| 型號： | DS2154 |
| 英文描述： | WSD 151 SOLDERING STATION 230V UKWSD 151 SOLDERING STATION 230V UK; Frequency, supply max:60Hz; Frequency, supply min:50Hz; Height:101mm; Length:166mm; Power, input:150W; Temperature range:50(degree C) - 550(degree C); Voltage, |
| 中文描述： | 增強型E1單芯片收發器 |
| 文件頁數： | 12/87頁 |
| 文件大小： | 1106K |
| 代理商： | DS2154 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁
DS2154
12 of 87
Receive Sync [RSYNC].
An extracted pulse, one RCLK wide, is output at this pin which identifies either
frame or CAS/CRC multiframe boundaries. If the receive side elastic store is enabled, then this pin can be
enabled to be an input at which a frame or multiframe boundary pulse synchronous with RSYSCLK is
applied.
Receive Frame Sync [RFSYNC].
An extracted 8 kHz pulse, one RCLK wide, is output at this pin which
identifies frame boundaries.
Receive Multiframe Sync [RMSYNC].
An extracted pulse, one RSYSCLK wide, is output at this pin
which identifies multiframe boundaries. If the receive side elastic store is disabled, then this output will
output multiframe boundaries associated with RCLK.
Receive Data [RDATA].
Updated on the rising edge of RCLK with the data out of the receive side
framer.
Receive System Clock [RSYSCLK].
1.544 MHz or 2.048 MHz clock. Only used when the elastic store
function is enabled. Should be tied low in applications that do not use the elastic store. Can be burst at
rates up to 8.192 MHz.
Receive Signaling Output [RSIG].
Outputs signaling bits in a PCM format. Updated on rising edges of
RCLK when the receive side elastic store is disabled. Updated on the rising edges of RSYSCLK when the
receive side elastic store is enabled. See Section 13 for timing examples.
Receive Loss of Sync / Loss of Transmit Clock [RLOS/LOTC].
A dual function output that is
controlled by the TCR2.0 control bit. This pin can be programmed to either toggle high when the
synchronizer is searching for the frame and multiframe or to toggle high if the TCLK pin has not been
toggled for 5
μ
s.
Receive Carrier Loss [RCL].
Set high when the line interface detects a loss of carrier. [Note: a test
mode exists to allow the DS2154 to detect carrier loss at RPOSI and RNEGI in place of detection at RTIP
and RRING].
Receive Signaling Freeze [RSIGF].
Set high when the signaling data is frozen via either automatic or
manual intervention. Used to alert downstream equipment of the condition.
8 MHz Clock [8MCLK].
8.192 MHz output clock that is referenced to the clock that is output at the
RCLK pin.
Receive Positive Data Output [RPOSO].
Updated on the rising edge of RCLKO with the bipolar data
out of the line interface. This pin is normally tied to RPOSI.
Receive Negative Data Output [RNEGO].
Updated on the rising edge of RCLKO with the bipolar data
out of the line interface. This pin is normally tied to RNEGI.
Receive Clock Output [RCLKO].
Buffered recovered clock from the E1 line. This pin is normally tied
to RCLKI.
Receive Positive Data Input [RPOSI].
Sampled on the falling edge of RCLKI for data to be clocked
through the receive side framer. RPOSI and RNEGI can be tied together for a NRZ interface. Can be
internally connected to RPOSO by tying the LIUC pin high.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2155 | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
| DS2156 | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
| DS2156L | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
| DS2156LN | T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface |
| DS2182 | T1 Line Monitor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2154DK | 功能描述:KIT DESIGN E1 DS2154 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| DS2154L | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154L+ | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154LA2 | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS2154LA2+ | 功能描述:網絡控制器與處理器 IC Enhanced E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。