- 您現在的位置：買賣IC網 > PDF目錄385271 > DS1233 (Maxim Integrated Products, Inc.) 5V EconoReset(5V Econo復位芯片) PDF資料下載
參數資料
| 型號： | DS1233 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 5V EconoReset(5V Econo復位芯片) |
| 中文描述： | 5V、經濟型復位芯片 |
| 文件頁數： | 2/5頁 |
| 文件大小： | 46K |
| 代理商： | DS1233 |
DS1233
022698 2/5
OPERATION – POWER MONITOR
The DS1233 provides the functions of detecting out–of–
tolerance power supply conditions and warning a pro-
cessor–based system of impending power failure.
When V
CC
is detected as out–of–tolerance, as defined
by the tolerance of the part selected, the RST signal is
asserted. On power–up, RST is kept active for approxi-
mately 350 ms after the power supply has reached the
selected tolerance. This allows the power supply and
microprocessor to stabilize before RST is released.
OPERATION – PUSHBUTTON RESET
The DS1233 provides for a pushbutton switch to be con-
nected to the RST output pin. When the DS1233 is not
in a reset cycle, it continuously monitors the RST signal
for a low going edge. If an edge is detected, the DS1233
will debounce the switch by pulling the RST line low. Af-
ter the internal timer has expired, the DS1233 will con-
tinue to monitor the RST line. If the line is still low, the
DS1233 will continue to monitor the line looking for a ris-
ing edge. Upon detecting a release, the DS1233 will
force the RST line low and hold it low for 350 ms.
NOTE:
For proper operation with an external pushbutton, a ca-
pacitor between 100 pF and 0.01
μ
F must be connected
between RST and ground. In applications where addi-
tional reset current is required, a minimum capacitance
of 500 pF should be used, along with a parallel external
pull–up resistor of 1K
minimum.
BLOCK DIAGRAM
Figure 1
VccAND BIAS
T.C. REFERENCE
DELAY
Ground
RST
Vcc
RST
MONITOR
APPLICATION EXAMPLE
Figure 2
DS1233
VCC
MICROPROCESSOR
RESET
PUSHBUTTON
CAPACITOR
RST
相關PDF資料 |
PDF描述 |
|---|---|
| DS1243Y | 64K NV SRAM with Phantom Clock(帶幻影實時時鐘的非易失性SRAM) |
| DS1244Y | 256K NV SRAM with Phantom Clock(帶幻影實時時鐘的非易失性SRAM) |
| DS1245AB | 1024K Nonvolatile SRAM(1024K 非易失性靜態RAM) |
| DS1245Y | 1024K Nonvolatile SRAM(1024K 非易失性靜態RAM) |
| DS1245W | 3.3V 1024K Nonvolatile SRAM(3.3V 1024K 非易失性靜態RAM) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS123310 | 制造商:DALLAS SEMI 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| DS1233-10 | 功能描述:監控電路 5V EconoReset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1233-10/T&R | 制造商:Maxim Integrated Products 功能描述:ECONO RESET TO-92 (10%)-TRL - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:IC ECONORESET 5V 10% TO92-3 |
| DS1233-10/T&R | 功能描述:監控電路 5V EconoReset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1233-10+ | 功能描述:監控電路 5V EconoReset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。