參數資料
型號： DM9801E
廠商： Electronic Theatre Controls, Inc.
英文描述： 1M home Phonrline Network Physical Layer Single Chip Transceiver
中文描述： 100萬家庭Phonrline網絡物理層單芯片收發器
文件頁數： 50/61頁
文件大小： 589K
代理商： DM9801E
DM9801
1M Home Phoneline Network Physical Layer Single Chip Transceiver
50
Preliminary
Version: DM9801-DS-P02
March 20, 2000
Management Interfaces
The DM9801 may be managed from either of two interfaces
with managed parameters varying depending on the
interface:
1. Remote control-word management commands
embedded in the AID header on the wire network.
2. Management messages from the local management
entity.
AID Header Remote Control-Word Commands
Home Phoneline Networking stations may be configured
either as master stations or slave stations. Only one master
may exist on a given Home Phoneline Network over which
the header is preserved. Operation is master station mode is
optional while operation is slave mode is a requirement.
The master station may send commands embedded in the
header control word to remotely set various parameters of
the remote slave stations. Stations are identified via the AID
as follows:
1. The master station is identified on the Home Phoneline
Network with an AID of 0xFF (hex).
2. The slave is identified with an AID of 0x00 (hex) to 0xEF
(hex).
3. AID values of 0xF0 to 0xFE are reserved for future use.
Once a command has been transmitted, the master station
must revert to a slave AID so that subsequent control words
are not interpreted by the slave stations as new commands.
A master remote command must consist of three frames
with an AID header of 0xFF (hex). Since the header is
appended (piggy-backed) to packets received from the
MAC that are normally transmitted independently of the
DM9801, master control frames are transmitted only when
the MAC sends packets to the DM9801. Therefore, packets
from the master station may be separated by long intervals
during which other (slave) stations may transmit their
frames.
A remote master Control-Word command must be
recognized and executed by a Home Phoneline Networking
PHY when it receives three consecutive valid frames with an
AID of 0xFF (hex). Valid commands are as follows:
1. SET_VERSION - Commands slave devices to operate
according to 1M Home Networking version.
2. SET_POWER - commands slave stations to set their
transmit level to a prescribed level until another master
command is received.
3. SET_SPEED - commands slave stations to set their
transmit speed to a prescribed value until another
master command is received.
The control word bit encoding and possible values are
described in Table 4 below.
Bit #
0
Indicated Status
0 = This station is version 0
1 = This station is not version 0
0 = Frame transmitted at low power
1 = Frame transmitted at high power
0 = Frame transmitted at low speed
0 = Frame transmitted at high speed
Reserved
1
2
3
Master/Slave Station Control Word Functions
Table 4
Note: Master and Slave control word bit encoding are identical.
相關PDF資料
PDF描述
DMA2271 Consumer IC
DMA2280 Consumer IC
DMA2281 Consumer IC
DMA2275 DMA 2275, DMA 2286 C/D/D2-MAC Descrambler
DMA2286 DMA 2275, DMA 2286 C/D/D2-MAC Descrambler
相關代理商/技術參數
參數描述
DM9B 功能描述:數字萬用表 4000 COUNT AUTO RoHS:否 制造商:Tektronix 產品:Multimeters 類型:Bench 準確性:0.04 % 電壓范圍:2 V to 2 kV 電阻范圍: 電容范圍: 顯示計數: 頻率:10 Hz to 45 Hz, 850 Hz to 1 MHz 測距: 真均方根值: 數據保持:
D-M9B 制造商:SMC Corporation of America 功能描述:Sensor, solid state, direct mount, grommet connection, for MX/MH/CQ2/NCQ2/NCQ8 制造商:SMC 功能描述:2-Wire Auto Switch for 24Vdc Relay/PLC
D-M9BA 制造商:SMC Corporation of America 功能描述:Autoswitch, water resistant, 2 wire, horizontal
D-M9BAL 制造商:SMC Corporation of America 功能描述:AUTOSWITCH, DIRECT MT, SOLID STATE, GROMMET ENTRY, 3M LEADWIRE
D-M9BAVL 制造商:SMC Corporation of America 功能描述:Autoswitch, water resistant, 2 wire, vertical
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*