- 您現在的位置：買賣IC網 > PDF目錄379148 > DGP30E48S12 SINGLE OUTPUT PDF資料下載
參數資料
| 型號： | DGP30E48S12 |
| 英文描述： | SINGLE OUTPUT |
| 中文描述： | 單輸出 |
| 文件頁數： | 3/4頁 |
| 文件大?。?/td> | 888K |
| 代理商： | DGP30E48S12 |
3
DGP30 SERIES – SINGLE OUTPUT
DGP30 SERIES APPLICATION NOTES:
External Capacitance Requirements
No external capacitance is required for operation of the DGP30
Series. However, it is recommended that the DGP30 Series use a
capacitor of sufficient ripple current capacity connected across the
input pins if a capacitive input source is farther than 1” from the
converter. To meet the reflected ripple requirements of the
converter, an input impedance of less than 0.05 Ohms from DC to
200KHz is required. External output capacitance is not required
for operation, however it is recommended that 1 F to 10 F of
tantalum and 0.001 to 0.1 F ceramic capacitance be selected for
reduced system noise. Additional output capacitance may be
added for increased filtering, but should not exceed 400 F.
Negative Outputs
A negative output voltage may be obtained by connecting the
+OUT to circuit ground and connecting -OUT as the negative
output.
Remote ON/OFF Operation
The remote ON/OFF pin may be left floating if this function is
not used. It is recommended to drive this pin with an open
collector arrangement or a relay contact. When the ON/OFF pin
is pulled low with respect to the -INPUT, the converter is placed
in a low power drain state. Since the ON/OFF pin is driven by a 9
volt internal source via a 100K
driven by TTL logic. Attempts to drive this circuit with logic
circuits may result in damage to user circuitry.
resistor, the pin should not be
Output TRIM
The TRIM pin may be used to adjust the output ±5% from the
nominal setting. This function allows adjustment for voltage drops
in the system wiring, as well 5.2 volt outputs for ECL applications.
Figure 1 shows the proper connections to use this function. A
trimpot value of 10K
should be used for the 5 volt output.
A trimpot value of 20K
should be used for 12 and 15 volt outputs.
If the TRIM function is not required the pin may be left floating.
5
+OUT
7
TRIM
10K
LOAD
USING TRIMPOT
6
-OUT
5
+OUT
7
TRIM
TRIM
DOWN
TRIM
UP
LOAD
USING FIXED RESISTORS
6
-OUT
Figure 1.
相關PDF資料 |
PDF描述 |
|---|---|
| DGP30E48S15 | SINGLE OUTPUT |
| DGP30E48S5 | SINGLE OUTPUT |
| DGT304RE | Reverse Blocking Gate Turn-off Thyristor |
| DGT304SE | Gate Turn-off Thyristor |
| DGT304RE13 | Reverse Blocking Gate Turn-off Thyristor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DGP30E48S15 | 功能描述:CONVERTER DC-DC 30W 48V/15V SGL RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:DGP30 標準包裝:5 系列:* |
| DGP30E48S15M | 制造商:Power-One 功能描述: |
| DGP30E48S5 | 功能描述:CONVERTER DC-DC 30W 48V/5V SGL RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:DGP30 標準包裝:5 系列:* |
| DGP30E48S5S208 | 制造商:Power-One 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。