參數資料
型號： DC571A
廠商： Linear Technology
文件頁數： 24/48頁
文件大?。?/td> 0K
描述： BOARD DELTA SIGMA ADC LTC2418
軟件下載： QuikEval System
設計資源： DC571A Design File
DC571A Schematic
標準包裝： 1
系列： QuikEval™
ADC 的數量： 1
位數： 24
采樣率（每秒）： 7.5
數據接口： MICROWIRE?，串行，SPI?
工作溫度： 0°C ~ 70°C
已用 IC / 零件： LTC2418
已供物品： 板
相關產品： DC590B-ND - BOARD DEMO USB SERIAL CONTROLLER
LTC2418IGN#PBF-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418CGN#TRPBF-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418IGN#TRPBF-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418CGN#PBF-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418CGN-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418IGNTR-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418IGN-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2418CGNTR-ND - IC ADC 24BIT DIFF INPUT 28SSOP
LTC2414/LTC2418
30
241418fa
In addition to this gain error, the converter INL perfor-
mance is degraded by the reference source impedance.
When FO = LOW (internal oscillator and 60Hz notch), every
100
of source resistance driving REF+ or REF– translates
into about 1.34ppm additional INL error. When FO = HIGH
(internal oscillator and 50Hz notch), every 100
of source
resistance driving REF+ or REF– translates into about
1.1ppm additional INL error. When FO is driven by an
external oscillator with a frequency fEOSC, every 100 of
source resistance driving REF+ or REF– translates into
about 8.73 10–6 fEOSCppm additional INL error.
Figure 22 shows the typical INL error due to the source
resistance driving the REF+ or REF– pins when large CREF
values are used. The effect of the source resistance on the
two reference pins is additive with respect to this INL error.
In general, matching of source impedance for the REF+
and REF– pins does not help the gain or the INL error. The
user is thus advised to minimize the combined source
impedance driving the REF+ and REF– pins rather than to
try to match it.
The magnitude of the dynamic reference current depends
upon the size of the very stable internal sampling capaci-
tors and upon the accuracy of the converter sampling
clock. The accuracy of the internal clock over the entire
temperature and power supply range is typical better than
0.5%. Such a specification can also be easily achieved by
an external clock. When relatively stable resistors
(50ppm/
°C) are used for the external source impedance
seen by REF+ and REF–, the expected drift of the dynamic
current gain error will be insignificant (about 1% of its
value over the entire temperature and voltage range). Even
for the most stringent applications a onetime calibration
operation may be sufficient.
In addition to the reference sampling charge, the reference
pins ESD protection diodes have a temperature dependent
leakage current. This leakage current, nominally 1nA
(
±10nA max), results in a small gain error. A 100 source
resistance will create a 0.05
V typical and 0.5V maxi-
mum full-scale error.
Output Data Rate
When using its internal oscillator, the LTC2414/LTC2418
can produce up to 7.5 readings per second with a notch
frequency of 60Hz (FO = LOW) and 6.25 readings per
second with a notch frequency of 50Hz (FO = HIGH). The
actual output data rate will depend upon the length of the
sleep and data output phases which are controlled by the
user and which can be made insignificantly short. When
operated with an external conversion clock (FO connected
to an external oscillator), the LTC2414/LTC2418 output
data rate can be increased as desired up to that determined
by the maximum fEOSC frequency of 2000kHz. The dura-
tion of the conversion phase is 20510/fEOSC. If fEOSC =
153600Hz, the converter behaves as if the internal oscil-
lator is used and the notch is set at 60Hz. There is no
significant difference in the LTC2414/LTC2418 perfor-
mance between these two operation modes.
An increase in fEOSC over the nominal 153600Hz will
translate into a proportional increase in the maximum
output data rate. This substantial advantage is neverthe-
less accompanied by three potential effects, which must
be carefully considered.
First, a change in fEOSC will result in a proportional change
in the internal notch position and in a reduction of the
converter differential mode rejection at the power line
frequency. In many applications, the subsequent perfor-
mance degradation can be substantially reduced by rely-
ing upon the LTC2414/LTC2418’s exceptional common
APPLICATIO S I FOR ATIO
WU
UU
Figure 22. INL vs Differential Input Voltage (VIN = IN+ – IN–)
and Reference Source Resistance (RSOURCE at REF+ and REF– for
Large CREF Values (CREF ≥ 1F)
VINDIF/VREFDIF
–0.5 –0.4–0.3–0.2–0.1 0
0.1 0.2 0.3 0.4 0.5
INL
(ppm
OF
V
REF
)
15
12
9
6
3
0
–3
–6
–9
–12
–15
VCC = 5V
REF+ = 5V
REF– = GND
VINCM = 0.5 (IN
+ + IN–) = 2.5V
FO = GND
CREF = 10F
TA = 25°C
RSOURCE = 1000
RSOURCE = 500
RSOURCE = 100
2414/18 F22
相關PDF資料
PDF描述
MIC2015-1.2YM6 TR IC DISTRIBUTION SW 1.2A SOT23-6
DC570A BOARD DELTA SIGMA ADC LTC2440
DC1012A-A BOARD DELTA SIGMA ADC LTC2499
DC1010A-A BOARD DELTA SIGMA ADC LTC2493
RCM15DCAH-S189 CONN EDGECARD 30POS R/A .156 SLD
相關代理商/技術參數
參數描述
DC57-28 功能描述:ANT BKHAUL 28DBI 5.7GHZ 30" NFEM RoHS:是 類別:RF/IF 和 RFID >> RF 天線 系列:* 標準包裝:1 系列:*
DC572A 制造商:Linear Technology 功能描述:EVAL BOARD, LTC1592 16BIT DAC 制造商:Linear Technology 功能描述:EVAL BOARD, LTC1592 16BIT DAC; Silicon Manufacturer:Linear Technology; Silicon Core Number:LTC1592; Kit Contents:Evaluation Board for LTC1592; Features:Serial SoftSpan IOUT DAC; Length:29mm
DC573A 功能描述:BOARD DELTA SIGMA ADC LTC2400 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:QuikEval™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件
DC575A 功能描述:BOARD DELTA SIGMA ADC LTC2410 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:QuikEval™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件
DC579A 功能描述:BOARD DAC LTC2600 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:QuikEval™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*