- 您現在的位置：買賣IC網 > PDF目錄376564 > DAC8541EVM (Texas Instruments, Inc.) DAC8541EVM(DAC8541評估板) PDF資料下載
參數資料
| 型號： | DAC8541EVM |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | DAC8541EVM(DAC8541評估板) |
| 中文描述： | DAC8541EVM（DAC8541評估板） |
| 文件頁數： | 21/26頁 |
| 文件大?。?/td> | 351K |
| 代理商： | DAC8541EVM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁
Host Processor Operation
3-3
EVM Operation
Table 3-2.Unity Gain Output Jumper Settings
Reference
Jumper Position
Function
W3
2-3
Negative rail of the op amp tied to analog GND
W4
Don’t care
Positive rail of the op amp can be supplied by 15 V or V
CC
Buffered output of DAC is channeled to the output terminals
W5
3-4
W6
Open
Disconnect V
REF(H)
from negative input of op amp
Disconnect negative input of op amp from GND
W7
Open
3.2.2
Output Gain of Two
This configuration allows the output of the DAC to have a gain of two which is
particularly useful when the EVM is operating at 3.3 V and there is a need for
the DAC output to maintain a 5 V peak level. The output gain of two
configuration that can be implemented on this EVM should not exceed the
effective range of 2
×
V
REF(H)
.
The reference voltage must be set such that the output voltage range of the
DAC does not exceed the positive rail supply of the op amp, U2, as well.
Otherwise the output of the op amp, U2, is clipped.
V
CC
can be used also to supply the positive rail of the op amp by shorting pins
1 and 2 of W4. With this configuration, the effective output of the op amp is
at a maximum of V
CC
. The reference voltage must also be set to V
CC
/2.
Table 3-3 shows the proper jumper settings for the 2
×
gain output of the DAC.
Table 3-3.Gain of Two Output Jumper Settings
Reference
Jumper Position
Function
W3
2-3
Negative rail of the op amp tied to analog GND
W4
1-2
Positive rail supply of the op amp tied to 15 V
W5
3-4
Amplifier output of DAC is channeled to the output terminals
W6
Open
Disconnect V
REF(H)
from negative input of op amp
Configures op amp for a 2
×
gain output
W7
Close
3.2.3
Capacitive Load Drive
Another output configuration option is to drive a wide range of capacitive load
requirements. However, all op-amps under certain conditions may become
unstable depending on the op-amp configuration, gain, and load value. These
are just a few factors that can affect op-amps stability performance that should
be considered when implementing.
In unity gain, the OPA627 op amp, U2, performs very well with very large
capacitive loads. Increasing the gain enhances the amplifier’s ability to drive
even more capacitance, and adding a load resistor would even improve the
capacitive load drive capability.
Table 3-4 shows the jumper setting configuration for a capacitive load drive.
相關PDF資料 |
PDF描述 |
|---|---|
| DAC8544I | QUAD, 16-BIT, RAIL-TO-RAIL VOLTAGE OUTPUT, PARALLEL INTERFACE, DIGITAL-TO-ANALOG CONVERTER |
| DAC8551IDGK | 16-BIT, ULTRA-LOW GLITCH, VOLTAGE OUTPUT DIGITAL-TO-ANALOG CONVERTER |
| DAC8551IDRBR | 16-BIT, ULTRA-LOW GLITCH, VOLTAGE OUTPUT DIGITAL-TO-ANALOG CONVERTER |
| DAC8551IDRBT | 16-BIT, ULTRA-LOW GLITCH, VOLTAGE OUTPUT DIGITAL-TO-ANALOG CONVERTER |
| DAC8562ER | 12-Bit Digital-to-Analog Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DAC8541Y | 制造商:Texas Instruments 功能描述:IC 16BIT DAC SMD 8541 TQFP32 |
| DAC8541Y | 制造商:Texas Instruments 功能描述:IC 16BIT DAC SMD 8541 TQFP32 |
| DAC8541Y/250 | 功能描述:數模轉換器- DAC Low Power 16-Bit DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| DAC8541Y/250G4 | 功能描述:數模轉換器- DAC Low Power 16-Bit DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| DAC8541Y/2K | 功能描述:數模轉換器- DAC Low Power 16-Bit DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。