參數資料
型號: CLP270M-TR
廠商: 意法半導體
英文描述: OVERVOLTAGE AND OVERCURRENT PROTECTION FOR TELECOM LINE
中文描述: 過壓和過流保護的電信線路保護
文件頁數: 4/24頁
文件大小: 368K
代理商: CLP270M-TR
CLP270M
4/24
The figure 2 summarizes the firing modes of the CLP270M which basically hold the SLIC inside its correct
voltage and current values.
2.2 Application circuit: CLP270M in line card.
Figure 3 above shows the topology of a protected analog subscriber line at the exchange side. The
CLP270M is connected to the ring relay via two balanced Rp resistors, and to the Subscriber Line Interface
Circuit. A second device is located near the SLIC : it can be either a LCP1511D, a THDT series or a
LCDP1511D.
These two devices are complementary and their functions are explained below :
I
The first stage based on CLP270M manages the high power issued from the external surges. When
used in ringing mode, the CLP270M operates in voltage mode and provides a symmetrical and
bidirectional overvoltage protection at +/- 270 V on both TIP and RING lines. When used in speech
mode, the CLP270M operates in current mode and the activation current of the CLP270M is adjusted
by R
sense
.
I
The second stage is the external voltage reference device which defines the firing threshold voltage
during the speech mode and also assumes a residual power overvoltage suppression. This protection
stage can be either a fixed or programmable breakover device. The THDTxx family acts as a fixed
breakover device while the LCP1511D or the LCDP1511D operates as a programmable protection.
Thanks to this topology,
the surge current in the line is reduced after the CLP270M. Because the
remaining surge energy is low, the power ratings of Rp, the ring relay contacts and the external voltage
reference circuit can be downsized. This results in a significant cost reduction.
RINGS
-Vbat
-Vbat
Rp
Rsense
TIP
1
1
2
2
SLIC
(*)
(*) LCP1511D or THDT series or LCDP1511D
Ov
ref
(+/- 270 V)
v
er oltage
erence
Overvoltage
detector
Overcurrent
detector
OR
Overvoltage
reference
(+/- 270 V)
Overvoltage
detector
Overcurrent
detector
OR
TIPL
TIPS
RINGL
FS
GND
SW3 SW1
SW4 SW2
Rsense
Rp
Ring
Generator
Fuse
Fuse
TIP
RING
External
voltage
reference
RING
I
Fig. 3 :
CLP270M in line card
相關PDF資料
PDF描述
CLP30-200B1RL OVERVOLTAGE & OVERCURRENT PROTECTION FOR TELECOM LINE
CLP30-200B1 Overvoltage and Overcurrent Protection for Telcom Line(電信裝備的過壓和過流保護)
CLT3-4BT6-TR CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION
CLT3-4B CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION
CLT3-4BT6 CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION
相關代理商/技術參數
參數描述
CLP285C 制造商:SUMIDA 制造商全稱:Sumida Corporation 功能描述:LAN Transformer
CLP-2B6 制造商:SYNERGY 制造商全稱:SYNERGY MICROWAVE CORPORATION 功能描述:MIXERS TRIPLE-BALANCED
CLP2EA1C115 制造商:Carlo Gavazzi 功能描述:COND.LEVEL 2+1 FILL EMPTY PLUG
CLP2EA1C230 制造商:Carlo Gavazzi 功能描述:COND.LEVEL 2+1 FILL EMPTY PLUG
CLP2EA1CM24 功能描述:CONTROL LIQ LEV DPDT 24 V AC/DC 制造商:carlo gavazzi inc. 系列:CL 零件狀態:在售 類型:高/低液位 電壓 - 電源:24VAC/DC 靈敏度:250歐姆 ~ 500千歐 特性:可調靈敏度 距離 - 對傳感器的控制(最大值):- 輸出類型:繼電器 觸頭外形:DPDT(2 C 型) 不同電壓時的觸頭額定電流:8A @ 250VAC 安裝類型:可插 端子類型:插入式,11 引腳(八針) 工作溫度:-20°C ~ 50°C 流型:化學溶劑, 廢水 標準包裝:1