- 您現在的位置：買賣IC網 > PDF目錄369664 > CLP270M-TR (意法半導體) OVERVOLTAGE AND OVERCURRENT PROTECTION FOR TELECOM LINE PDF資料下載
參數資料
| 型號： | CLP270M-TR |
| 廠商： | 意法半導體 |
| 英文描述： | OVERVOLTAGE AND OVERCURRENT PROTECTION FOR TELECOM LINE |
| 中文描述： | 過壓和過流保護的電信線路保護 |
| 文件頁數： | 3/24頁 |
| 文件大小： | 368K |
| 代理商： | CLP270M-TR |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
CLP270M
3/24
APPLICATION NOTE
1. INTRODUCTION
This device includes a primary protection level and is suitable for main distribution frames and line cards.
This protection concept is explained and, in addition, the CLP270M performances are analysed when
facing different surges as described in the BELLCORE GR 1089 recommendations.
Figure 1 is a simplified block diagram of a subscriber line protection that is commonly used.
This shows two different topologies :
I
A “primary protection” located on the Main Distribution Frame (MDF) eliminates coarsely the high energy
environmental disturbances (lightning transients and AC power mains disturbances)
I
A “secondary protection” located on the line card includes a primary protection level (first stage) and a
residualprotection(secondstage)which eliminatesfinelytheremainingtransientsthathavenotbeentotally
suppressed by the first stage.
2. STMicroelectronics CLP270M CONCEPT
2.1. Evolution of the SLIC protection
Over the years, the silicon protection performances have considerably changed.
The first generation of products like SMTHBTxx and SMTHDTxx offered fixed overvoltage protection
against surges on either TIP or RING line in four
packages.
The
following
generation
like
THBTxx
and
THDTxx still offered fixed overvoltage protection
against surges on both TIP and RING lines in two
packages.
The next step was the introduction of the
LCP1511D which brought the advantage of full
programmable voltage.
Today, the CLP270M combines the features of all
the previous generations. In addition to that, it
offers an overcurrent detection when operating in
speech mode and also a Failure Status output
signal.
CLP270M
CLP270M
SLIC
SLIC
THDTxx
LCPor
or
LCDP1511D
“PRIMARY PROTECTION”
“SECONDARY PROTECTION”
“SECONDARY PROTECTION”
Telecommunication
line
Telecommunication
line
MDF
EXCHANGE
EXCHANGE
LINE CARD
LINE CARD
MDF
Fig. 1:
Subscriber line protection topology
Line card
operating
conditions
V
I
-I
+I
SWON
SWON
Programmable
thanks to an
external resistor
Programmable
thanks to any
external voltage
reference
Fig. 2:
Line card protection
相關PDF資料 |
PDF描述 |
|---|---|
| CLP30-200B1RL | OVERVOLTAGE & OVERCURRENT PROTECTION FOR TELECOM LINE |
| CLP30-200B1 | Overvoltage and Overcurrent Protection for Telcom Line(電信裝備的過壓和過流保護) |
| CLT3-4BT6-TR | CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION |
| CLT3-4B | CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION |
| CLT3-4BT6 | CURRENT LIMITED OVER-VOLTAGE PROTECTED QUAD DIGITAL TERMINATION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CLP285C | 制造商:SUMIDA 制造商全稱:Sumida Corporation 功能描述:LAN Transformer |
| CLP-2B6 | 制造商:SYNERGY 制造商全稱:SYNERGY MICROWAVE CORPORATION 功能描述:MIXERS TRIPLE-BALANCED |
| CLP2EA1C115 | 制造商:Carlo Gavazzi 功能描述:COND.LEVEL 2+1 FILL EMPTY PLUG |
| CLP2EA1C230 | 制造商:Carlo Gavazzi 功能描述:COND.LEVEL 2+1 FILL EMPTY PLUG |
| CLP2EA1CM24 | 功能描述:CONTROL LIQ LEV DPDT 24 V AC/DC 制造商:carlo gavazzi inc. 系列:CL 零件狀態:在售 類型:高/低液位 電壓 - 電源:24VAC/DC 靈敏度:250歐姆 ~ 500千歐 特性:可調靈敏度 距離 - 對傳感器的控制（最大值）:- 輸出類型:繼電器 觸頭外形:DPDT（2 C 型） 不同電壓時的觸頭額定電流:8A @ 250VAC 安裝類型:可插 端子類型:插入式，11 引腳（八針） 工作溫度:-20°C ~ 50°C 流型:化學溶劑， 廢水 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。