- 您現在的位置：買賣IC網 > PDF目錄378828 > CH2056TBR (Electronic Theatre Controls, Inc.) HIGH SPEED Modem and FAX FAMILY PDF資料下載
參數資料
| 型號： | CH2056TBR |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | HIGH SPEED Modem and FAX FAMILY |
| 中文描述： | 高速調制解調器和傳真家庭 |
| 文件頁數： | 8/19頁 |
| 文件大?。?/td> | 365K |
| 代理商： | CH2056TBR |
Cermetek Microelectronics, Inc.
High Speed Modem and FAX Family
2003 Cermetek Microelectronics, Inc.
Page 8
Document No. 607-0003 Revision K3 (09/03)
Table 3.
HS Modem Family Pin Descriptions.
PIN
NAME
I/O
FUNCTION
1
RING
I/O
TELCO/TELSET INPUT
. Directly connects to the telephone line’s RING lead through a
user supplied RJ-11C jack.
2
TIP
I/O
TELCO/TELSET INPUT
. Directly connects to the telephone line’s TIP lead through a user
supplied RJ-11C jack.
3
T1
I/O
ANALOG VOICE INJECTED
. Input (See Figure 5). 2.2V P-P max. Let float if not used.
4
NC
-
No connection.
5
SPK
O
SPEAKER
. Audio output for speaker. See speaker control diagram.
6
NC
-
No connection.
7
NC
-
No connection.
8
NC
-
No connection.
9
NC
-
No connection.
10
TXD
I
TRANSMIT DATA
. Serial Transmit data input. Marking, or a binary 1 condition, is
transmitted when a HIGH is asserted.
11
RXD
O
RECEIVE DATA
. Serial Receive data output. Received marking or a binary 1 condition is
indicated by a HIGH.
12
NC
-
No connection.
13
DTR
I
DATA TERMINAL READY
. Active LOW. Switching off DTR can either return modem to
command state, disconnect phone call, or reset the modem. DTR should be set LOW
when not used.
14
DSR
O
DATA SET READY
. LOW indicates handshaking with a remote modem is in progress,
and/or the data carrier of a remote modem has been detected.
15
RI
O
RING INDICATION
. This signal follows the frequency of the ringing signal and is normally
about 20 to 40 Hz for 2 seconds on with 4 seconds off.
16
CTS
O
CLEAR TO SEND
. Active LOW. Indicates that the modem is ready to accept data from
the DTE.
17
DCD
O
DATA CARRIER DETECT
. LOW indicates a data carrier from a remote modem has been
detected. This feature must be enabled using the
&C1
command.
18
NC
-
No connection.
19
VCC
-
POWER SUPPLY
. 5 Volts ± 5%. Note: Noise should be less than 25mV peak-to-peak.
20
GRD
-
GROUND
. Note: Noise should be less than 25mV peak-to-peak.
21
RST
I
RESET
. Active HIGH. This input must be asserted HIGH for at least 10-msec to reset the
modem. RESET is then returned to LOW for normal operation. If no system reset is
available, let this pin float to enable the internal reset.
22
RTS
(1) If VCC has a slow power up ramp time, the internal reset may be ineffective.
(2) Do not drive LED’s directly from any output. Use Buffers.
I
REQUEST TO SEND
. Active LOW. Used for flow control. Should be tied low if not used.
NOTE:
相關PDF資料 |
PDF描述 |
|---|---|
| CH1817 | Family of Low Profile DAA Modules |
| CH1817-DM | Family of Low Profile DAA Modules |
| CH1817-L | Family of Low Profile DAA Modules |
| CH1817-LM | Family of Low Profile DAA Modules |
| CH1817D | Family of Low Profile DAA Modules |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CH206 | 功能描述:重負荷電源連接器 HOODKIT206 RoHS:否 制造商:Hirose Connector 系列:PS2 產品類型:Connectors 位置/觸點數量: 端接類型:Crimp 觸點材料: 觸點電鍍:Gold 電壓額定值: 電流額定值:300 A 附件類型: |
| CH208 | 功能描述:重負荷電源連接器 HOODKIT208 RoHS:否 制造商:Hirose Connector 系列:PS2 產品類型:Connectors 位置/觸點數量: 端接類型:Crimp 觸點材料: 觸點電鍍:Gold 電壓額定值: 電流額定值:300 A 附件類型: |
| CH20H100R | 制造商:Eaton Corporation 功能描述:1Ph/CH Loadcenter 100A 42kAIC MCB 20 Cir. Cu Bus Nema 3R |
| CH20L100-A2 | 制造商:AIS 功能描述:20.1IN 1600X1200 1000:1 300NIT CHASSIS - Bulk |
| CH20L100-A3 | 制造商:AIS 功能描述:20.1 IN 16:9 1366X768 700:1 450NIT CHASS - Bulk |
發布緊急采購，3分鐘左右您將得到回復。