參數資料
型號： C8051F015-TB
廠商： Silicon Laboratories Inc
文件頁數： 168/171頁
文件大小： 0K
描述： BOARD PROTOTYPING W/C8051F015
標準包裝： 1
C8051F000/1/2/5/6/7
C8051F010/1/2/5/6/7
13.8.1. Watchdog Usage
The WDT consists of a 21-bit timer running from the programmed system clock. The timer measures the period
between specific writes to its control register.
If this period exceeds the programmed limit, a WDT reset is
generated. The WDT can be enabled and disabled as needed in software, or can be permanently enabled if desired.
Watchdog features are controlled via the Watchdog Timer Control Register (WDTCN) shown in Figure 13.3.
Enable/Reset WDT
The watchdog timer is both enabled and the countdown restarted by writing 0xA5 to the WDTCN register. The
user’s application software should include periodic writes of 0xA5 to WDTCN as needed to prevent a watchdog
timer overflow. The WDT is enabled and restarted as a result of any system reset.
Disable WDT
Writing 0xDE followed by 0xAD to the WDTCN register disables the WDT.
The following code segment
illustrates disabling the WDT.
CLR
EA
; disable all interrupts
MOV
WDTCN,#0DEh ; disable software
MOV
WDTCN,#0ADh ; watchdog timer
SETB
EA
; re-enable interrupts
The writes of 0xDE and 0xAD must occur within 4 clock cycles of each other, or the disable operation is ignored.
Interrupts should be disabled during this procedure to avoid delay between the two writes.
Disable WDT Lockout
Writing 0xFF to WDTCN locks out the disable feature. Once locked out, the disable operation is ignored until the
next system reset. Writing 0xFF does not enable or reset the watchdog timer. Applications always intending to use
the watchdog should write 0xFF to WDTCN in their initialization code.
Setting WDT Interval
WDTCN.[2:0] control the watchdog timeout interval. The interval is given by the following equation:
4
3+WDTCN[2:0] x T
SYSCLK , (where T SYSCLK is the system clock period).
For a 2MHz system clock, this provides an interval range of 0.032msec to 524msec. WDTCN.7 must be a 0 when
setting this interval. Reading WDTCN returns the programmed interval. WDTCN.[2:0] is 111b after a system
reset.
Figure 13.3. WDTCN: Watchdog Timer Control Register
R/W
Reset Value
xxxxx111
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
SFR Address:
0xFF
Bits7-0: WDT Control
Writing 0xA5 both enables and reloads the WDT.
Writing 0xDE followed within 4 clocks by 0xAD disables the WDT.
Writing 0xFF locks out the disable feature.
Bit4:
Watchdog Status Bit (when Read)
Reading the WDTCN.[4] bit indicates the Watchdog Timer Status.
0: WDT is inactive
1: WDT is active
Bits2-0: Watchdog Timeout Interval Bits
The WDTCN.[2:0] bits set the Watchdog Timeout Interval. When writing these bits,
WDTCN.7 must be set to 0.
Rev. 1.7
96
相關PDF資料
PDF描述
ISC1210ER8R2J INDUCTOR WW 8.2UH 5% 1210
ISC1210ER6R8J INDUCTOR WW 6.8UH 5% 1210
ISC1210ER5R6J INDUCTOR WW 5.6UH 5% 1210
GCM12DRMT CONN EDGECARD 24POS .156 WW
RP15-4815DF/N-HC CONV DC/DC 15W 36-75VIN +/-15V
相關代理商/技術參數
參數描述
C8051F016 功能描述:8位微控制器 -MCU 32KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016-GQ 功能描述:8位微控制器 -MCU 32KB 10ADC 48P MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016-GQR 功能描述:8位微控制器 -MCU 32KB 10ADC 48Pin MCU Tape and Reel RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016R 功能描述:8位微控制器 -MCU C +-10Bit 48Pin RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F017 功能描述:8位微控制器 -MCU 32KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*