- 您現在的位置：買賣IC網 > Datasheet目錄39 > BD9153MUV-E2 (Rohm Semiconductor)IC REG TRPL BCK/LINEAR 24VQFN Datasheet資料下載
參數資料
| 型號： | BD9153MUV-E2 |
| 廠商： | Rohm Semiconductor |
| 文件頁數： | 12/21頁 |
| 文件大小： | 630K |
| 描述： | IC REG TRPL BCK/LINEAR 24VQFN |
| 特色產品： | CMOS LDO Regulators |
| 標準包裝： | 1 |
| 拓撲： | 降壓（降壓）同步（2），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 3 |
| 頻率 - 開關： | 1MHz |
| 電壓/電流 - 輸出 1： | 1.8 V ~ 3.3 V，1.5A |
| 電壓/電流 - 輸出 2： | 0.8 V ~ 2.5 V，1.5A |
| 電壓/電流 - 輸出 3： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 24-VQFN |
| 包裝： | 標準包裝 |
| 其它名稱： | BD9153MUV-E2DKR |
Technical Note
12/18
www.rohm.com
2009.08 - Rev.A
?2009 ROHM Co., Ltd. All rights reserved.
BD9153MUV
?SPAN class="pst BD9153MUV-E2_2471427_7">Selection of components externally connected
1. Selection of inductor (L)
;Current exceeding the current rating of the inductor results in magnetic saturation of the inductor, which decreases efficiency.
The inductor must be selected allowing sufficient margin with which the peak current may not exceed its current rating.
If VCC=5.0V, VOUT=1.2V, f=1.0MHz, 擨L=0.3?.5A=0.45A, for example,(BD9153MUV)
;Select the inductor of low resistance component (such as DCR and ACR) to minimize dissipation in the inductor for
better efficiency.
2. Selection of output capacitor (CO)
The inductance significantly depends on output ripple current.
s seen in the equation (1), the ripple current decreases as the
inductor and/or switching frequency increases.
擨L=
(VCC-VOUT)譜OUT
L譜CC譮
A?
ppropriate ripple current at output should be 20% more or less of
the maximum output current.
擨L=0.2譏OUTmax. [A]?2)
L=
(VCC-VOUT)譜OUT
擨L譜CC譮
H?
(擨L: Output ripple current, and f: Switching frequency)
Output capacitor should be selected with the consideration on the stability region
and the equivalent series resistance required to smooth ripple voltage.
Output ripple voltage is determined by the equation (4)
擵OUT=擨L譋SR [V]?4)
(擨L: Output ripple current, ESR: Equivalent series resistance of output capacitor)
;Rating of the capacitor should be determined allowing sufficient margin against
output voltage. A 22礔 to 100糉 ceramic capacitor is recommended.
Less ESR allows reduction in output ripple voltage.
Fig.36 Output capacitor
5-1.2?.2
0.45??.0M
L=
=2.02??2.2[糎]
擨L
V
OUT
Fig.35 Output ripple current
IL
VCC
IL
L
Co
VCC
L
Co
VOUT
ESR
相關PDF資料 |
PDF描述 |
|---|---|
| CAT2300VP2-GT3 | IC SENSE FET CONTROLLER 8TDFN |
| CAT34TS02VP2GT4A | IC TEMP SENSOR 2K MEMORY 8TDFN |
| CAT6095VP2-GT4 | IC TEMP SENSOR STAND ALONE 8TDFN |
| DS1621S+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS1624S+T&R | IC THERM/EEPROM DIG 256BYT 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BD9160FVM | 制造商:ROHM 制造商全稱:Rohm 功能描述:1ch DC／DC Converter Controller IC with Built-in Synchronous Rectifier |
| BD9160FVM-TR | 制造商:ROHM Semiconductor 功能描述:Cut Tape |
| BD9161FVM | 制造商:ROHM 制造商全稱:Rohm 功能描述:Output 1.5A or Less High-efficiency Step-down Switching Regulator with Built-in Power MOSFET |
| BD9161FVM_12 | 制造商:ROHM 制造商全稱:Rohm 功能描述:2.5V to 4.5V, 0.6A 1ch Synchronous Buck Converter Integrated FET |
| BD9161FVM-LBTR | 功能描述:Buck Switching Regulator IC Positive Adjustable 1V 1 Output 600mA 8-VSSOP, 8-MSOP (0.110", 2.80mm Width) 制造商:rohm semiconductor 系列:- 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:2.5V 電壓 - 輸入（最大值）:4.5V 電壓 - 輸出（最小值/固定）:1V 電壓 - 輸出（最大值）:3.3V 電流 - 輸出:600mA 頻率 - 開關:1MHz 同步整流器:是 工作溫度:-25°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:8-VSSOP，8-MSOP（0.110"，2.80mm 寬） 供應商器件封裝:8-MSOP 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。