參數資料
型號： ATMEGA1284P-MUR
廠商： Atmel
文件頁數： 126/160頁
文件大?。?/td> 0K
描述： MCU AVR 128KB FLASH 20MHZ 44VQFN
產品培訓模塊： MCU Product Line Introduction
megaAVR Introduction
標準包裝： 4,000
系列： AVR® ATmega
核心處理器： AVR
芯體尺寸： 8-位
速度： 20MHz
連通性： I²C，SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 32
程序存儲器容量： 128KB（64K x 16）
程序存儲器類型： 閃存
EEPROM 大?。?/td> 4K x 8
RAM 容量： 16K x 8
電壓 - 電源 (Vcc/Vdd)： 1.8 V ~ 5.5 V
數據轉換器： A/D 8x10b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 44-VFQFN 裸露焊盤
包裝： 帶卷 (TR)
配用： ATSTK600-ND - DEV KIT FOR AVR/AVR32
其它名稱： ATMEGA1284P-MUR-ND
68
8272E–AVR–04/2013
ATmega164A/PA/324A/PA/644A/PA/1284/P
Bits 5:0 – ISC21, ISC20 – ISC00, ISC00: External Interrupt 2 - 0 Sense Control Bits
The External Interrupts 2 - 0 are activated by the external pins INT2:0 if the SREG I-flag and the
corresponding interrupt mask in the EIMSK is set. The level and edges on the external pins that
activate the interrupts are defined in Table 13-1. Edges on INT2:INT0 are registered asynchro-
nously. Pulses on INT2:0 pins wider than the minimum pulse width given in ”External interrupts
characteristics” on page 338 will generate an interrupt. Shorter pulses are not guaranteed to
generate an interrupt. If low level interrupt is selected, the low level must be held until the com-
pletion of the currently executing instruction to generate an interrupt. If enabled, a level triggered
interrupt will generate an interrupt request as long as the pin is held low. When changing the
ISCn bit, an interrupt can occur. Therefore, it is recommended to first disable INTn by clearing its
Interrupt Enable bit in the EIMSK Register. Then, the ISCn bit can be changed. Finally, the INTn
interrupt flag should be cleared by writing a logical one to its Interrupt Flag bit (INTFn) in the
EIFR Register before the interrupt is re-enabled.
Note:
1. n = 2, 1 or 0.
When changing the ISCn1/ISCn0 bits, the interrupt must be disabled by clearing its Interrupt
Enable bit in the EIMSK Register. Otherwise an interrupt can occur when the bits are changed.
13.2.2
EIMSK – External Interrupt Mask Register
Bits 2:0 – INT2:0: External Interrupt Request 2 - 0 Enable
When an INT2:0 bit is written to one and the I-bit in the Status Register (SREG) is set (one), the
corresponding external pin interrupt is enabled. The Interrupt Sense Control bits in the External
Interrupt Control Register, EICRA, defines whether the external interrupt is activated on rising or
falling edge or level sensed. Activity on any of these pins will trigger an interrupt request even if
the pin is enabled as an output. This provides a way of generating a software interrupt.
13.2.3
EIFR –External Interrupt Flag Register
Bits 2:0 – INTF2:0: External Interrupt Flags 2 - 0
When an edge or logic change on the INT2:0 pin triggers an interrupt request, INTF2:0 becomes
set (one). If the I-bit in SREG and the corresponding interrupt enable bit, INT2:0 in EIMSK, are
set (one), the MCU will jump to the interrupt vector. The flag is cleared when the interrupt routine
Table 13-1.
Interrupt Sense Control
ISCn1
ISCn0
Description
0
The low level of INTn generates an interrupt request
0
1
Any edge of INTn generates asynchronously an interrupt request
1
0
The falling edge of INTn generates asynchronously an interrupt request
1
The rising edge of INTn generates asynchronously an interrupt request
Bit
76543210
–
INT2
INT1
IINT0
EIMSK
Read/Write
RRRRR
R/W
Initial Value
00000000
Bit
76543210
–
INTF2
INTF1
IINTF0
EIFR
Read/Write
R/W
RRRR
R/W
Initial Value
00000000
相關PDF資料
PDF描述
AT89C51RB2-SLRUM MCU 8051 16K FLASH 5V 44-PLCC
AT89C51RB2-SLRUL MCU 8051 16K FLASH 3V 44-PLCC
MS27484E14B18S CONN PLUG 18POS STRAIGHT W/SCKT
MS27473E12A98PB CONN PLUG 10POS STRAIGHT W/PINS
D38999/20FD19PB CONN RCPT 19POS WALL MNT W/PINS
相關代理商/技術參數
參數描述
ATMEGA1284P-PU 功能描述:8位微控制器 -MCU 128KB Flash 20MHz 1.8V-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA1284PR212-AU 功能描述:8位微控制器 -MCU ATmega 1284P-AU AT86RF212-ZU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA1284PR212-MU 功能描述:8位微控制器 -MCU ATmega 1284P-MU AT86RF212-ZU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA1284PR231-AU 功能描述:8位微控制器 -MCU ATmega 1284P-AU AT86RF231-ZUU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA1284PR231-MU 功能描述:8位微控制器 -MCU ATmega 1284P-MU AT86RF231-ZU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*