參數資料
型號: ATMEGA1284-MUR
廠商: Atmel
文件頁數: 133/160頁
文件大?。?/td> 0K
描述: IC MCU AVR 128K FLASH 44QFN
產品培訓模塊: megaAVR Introduction
標準包裝: 1
系列: AVR® ATmega
核心處理器: AVR
芯體尺寸: 8-位
速度: 20MHz
連通性: I²C,SPI,UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 32
程序存儲器容量: 128KB(64K x 16)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 4K x 8
RAM 容量: 16K x 8
電壓 - 電源 (Vcc/Vdd): 1.8 V ~ 5.5 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 44-VFQFN 裸露焊盤
包裝: 剪切帶 (CT)
其它名稱: ATMEGA1284-MURCT
74
8272E–AVR–04/2013
ATmega164A/PA/324A/PA/644A/PA/1284/P
If PORTxn is written logic one when the pin is configured as an output pin, the port pin is driven
high (one). If PORTxn is written logic zero when the pin is configured as an output pin, the port
pin is driven low (zero).
14.2.2
Toggling the pin
Writing a logic one to PINxn toggles the value of PORTxn, independent on the value of DDRxn.
Note that the SBI instruction can be used to toggle one single bit in a port.
14.2.3
Switching between input and output
When switching between tri-state ({DDxn, PORTxn} = 0b00) and output high ({DDxn, PORTxn}
= 0b11), an intermediate state with either pull-up enabled {DDxn, PORTxn} = 0b01) or output
low ({DDxn, PORTxn} = 0b10) must occur. Normally, the pull-up enabled state is fully accept-
able, as a high-impedant environment will not notice the difference between a strong high driver
and a pull-up. If this is not the case, the PUD bit in the MCUCR Register can be set to disable all
pull-ups in all ports.
Switching between input with pull-up and output low generates the same problem. The user
must use either the tri-state ({DDxn, PORTxn} = 0b00) or the output high state ({DDxn, PORTxn}
= 0b11) as an intermediate step.
Table 14-1 summarizes the control signals for the pin value.
14.2.4
Reading the Pin Value
Independent of the setting of Data Direction bit DDxn, the port pin can be read through the
PINxn Register bit. As shown in Figure 14-2, the PINxn Register bit and the preceding latch con-
stitute a synchronizer. This is needed to avoid metastability if the physical pin changes value
near the edge of the internal clock, but it also introduces a delay. Figure 14-3 shows a timing dia-
gram of the synchronization when reading an externally applied pin value. The maximum and
minimum propagation delays are denoted t
pd,max and tpd,min respectively.
Table 14-1.
Port pin configurations.
DDxn
PORTxn
PUD
(in MCUCR)
I/O
Pull-up
Comment
0
X
Input
No
Tri-state (Hi-Z)
0
1
0
Input
Yes
Pxn will source current if ext. pulled low.
0
1
Input
No
Tri-state (Hi-Z)
1
0
X
Output
No
Output Low (Sink)
1
X
Output
No
Output High (Source)
相關PDF資料
PDF描述
D38999/24FB98PN CONN RCPT 6POS JAM NUT W/PINS
SC16C652BIBS,151 IC ENCODER/DECODER IRDA 32HVQFN
VE-BTP-IW-F2 CONVERTER MOD DC/DC 13.8V 100W
VI-2NL-IY CONVERTER MOD DC/DC 28V 50W
MS27499E20B39P CONN RCPT 39POS BOX MNT W/PINS
相關代理商/技術參數
參數描述
ATMEGA1284P 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Atmel Microcontroller with 16/32/64/128K Bytes In-System Programmable Flash
ATMEGA1284P_09 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 128K Bytes In-System Programmable Flash
ATMEGA1284P_1 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 128K Bytes In-System Programmable Flash
ATMEGA1284P-AU 功能描述:8位微控制器 -MCU 128KB Flash 20MHz 1.8V-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA1284P-AUR 功能描述:8位微控制器 -MCU AVR,128KB FLASH,1.8V 4KB EE 16KB SRAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT