- 您現在的位置：買賣IC網 > PDF目錄298840 > ATH15T05-9S 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | ATH15T05-9S |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 3/14頁 |
| 文件大?。?/td> | 408K |
| 代理商： | ATH15T05-9S |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
Application Notes
ATH Series of Wide-Output Adjust Power
Modules (3.3/5-V Input)
North America (USA): 1-888-41-ASTEC
Europe (UK): 44(1384)842-211
Asia (HK): 852-2437-9662
Margin Up/Down Controls
The ATH10 (10A), ATH12/15 (12/15A), ATH18/22 (18/
22A) and ATH26/30 (26/30A) products incorporate Margin
Up and Margin Down control inputs. These controls allow
the output voltage to be momentarily adjusted 1, either up
or down, by a nominal 5 %. This provides a convenient
method for dynamically testing the operation of the load
circuit over its supply margin or range. It can also be used to
verify the function of supply voltage supervisors. The
±5 % change is applied to the adjusted output voltage, as set
by the external resistor, Rset at the Vo Adjust pin.
The 5 % adjustment is made by pulling the appropriate
margin control input directly to the GND terminal 2.
A low-leakage open-drain device, such as an n-channel
MOSFET or p-channel JFET is recommended for this
purpose 3. Adjustments of less than 5 % can also be accom-
modated by adding series resistors to the control inputs
(See Figure 3-4). The value of the resistor can be selected
from Table 3-2, or calculated using the following formula.
Up/Down Adjust Resistance Calculation
To reduce the margin adjustment to something less than
5 %, series resistors are required (See RD and RU in
Figure 3-7). For the same amount of adjustment, the
resistor value calculated for RU and RD will be the same.
The formulas is as follows.
R
U or RD =
499
– 99.8
k
%
Where
% = The desired amount of margin adjust in
percent.
Notes:
1. The Margin Up* and Margin Dn* controls were not
intended to be activated simultaneously. If they are
their affects on the output voltage may not completely
cancel, resulting in the possibility of a slightly higher
error in the output voltage set point.
2. The ground reference should be a direct connection to
the module GND at pin 7 (pin 1 for the ATH06).
This will produce a more accurate adjustment at the
load circuit terminals. The transistors Q1 and Q2 should
be located close to the regulator.
3. The Margin Up and Margin Dn control inputs are not
compatible with devices that source voltage. This includes
TTL logic. These are analog inputs and should only be
controlled with a true open-drain device (preferably
a discrete MOSFET transistor). The device selected
should have low off-state leakage current. Each input
sources 8 A when grounded, and has an open-circuit
voltage of 0.8 V.
Figure 3-7; Margin Up/Down Application Schematic
Table 3-2; Margin Up/Down Resistor Values
% Adjust
RU / RD
5
0.0 k
4
24.9 k
3
66.5 k
2
150.0 k
1
397.0 k
C
out
+
C
in
V
IN
GND
MargDn
L
O
A
D
Q
2
+V
OUT
Q
1
+
MargUp
0V
+V
o
R
D
R
U
PTH05010W
(Top View)
1
2
10 9
8
7
6
5
4
3
GND
R
SET
0.1 W, 1 %
ATH15T05-9S
相關PDF資料 |
PDF描述 |
|---|---|
| ATO2815T | 3-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| ATT17128AM20I | 128K X 1 CONFIGURATION MEMORY, PQCC20 |
| ATT1736AG8I-DT | 36288 X 1 OTPROM, PDSO8 |
| AU1550500MBC | 500 MHz, MICROPROCESSOR, PBGA483 |
| AU1PDHM3/84A | 1 A, 200 V, SILICON, SIGNAL DIODE, DO-220AA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATH15T05-9SJ | 功能描述:DC/DC轉換器 DC-DC 1OUT 0.8V-3.6V 15A 66W 10-Pin SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| ATH15T05-9SJL | 功能描述:DC/DC轉換器 DC-DC 1OUT 0.8V-3.6V 15A 66W 10-Pin SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| ATH15T05-9SL | 功能描述:DC/DC轉換器 DC-DC 1OUT 0.8V-3.6V 15A 66W 10-Pin SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| ATH18 | 制造商:ASTEC 制造商全稱:Astec America, Inc 功能描述:6-A, 3.3-V Input Non-Isolated Wide-Output Adjust Power Module |
| ATH18K12 | 制造商:ASTEC 制造商全稱:Astec America, Inc 功能描述:18-A, 12-V Input Non-Isolated Wide-Output Adjust Power Module |
發布緊急采購，3分鐘左右您將得到回復。