參數資料
型號： AT42QT1070-SSU
廠商： ATMEL CORP
元件分類： 速度傳感器和接近開關
英文描述： PROXIMITY SENSOR-CAPACITIVE, 0.6-2.6V, RECTANGULAR, SURFACE MOUNT
封裝： 0.150 INCH, ROHS COMPLIANT, PLASTIC, MS-012AB, SOIC-14
文件頁數： 8/38頁
文件大?。?/td> 509K
代理商： AT42QT1070-SSU
16
9596A–AT42–10/10
AT42QT1070
3.
The device sends an ACK.
4.
The host then sends the memory address within the device it wishes to write to.
5.
The device sends an ACK if the write address is in the range 0x00 – 0x7F, otherwise it
sends a NACK.
6.
The host transmits one or more data bytes; each is acknowledged by the device (unless
trying to write to an invalid address).
7.
If the host sends more than one data byte, they are written to consecutive memory
addresses.
8.
The device automatically increments the target memory address after writing each data
byte.
9.
After writing the last data byte, the host should send the STOP condition.
Note: the host should not try to write to addresses outside the range 0x20 to 0x39 because this
is the limit of the device’s internal memory address.
4.3.2
Reading Data From the Device
The sequence of events required to read data from the device is shown next.
1.
The host initiates the transfer by sending the START condition
2.
The host follows this by sending the slave address of the device together with the
WRITE bit.
3.
The device sends an ACK.
4.
The host then sends the memory address within the device it wishes to read from.
5.
The device sends an ACK if the address to be read from is less than 0x80 otherwise it
sends a NACK).
6.
The host must then send a STOP and a START condition followed by the slave address
again but this time accompanied by the READ bit.
Note:
Alternatively, instead of step 6 a repeated START can be sent so the host does not
need to relinquish control of the bus.
7.
The device returns an ACK, followed by a data byte.
8.
The host must return either an ACK or NACK.
a.
If the host returns an ACK, the device subsequently transmits the data byte from
the next address. Each time a data byte is transmitted, the device automatically
increments the internal address. The device continues to return data bytes until the
host responds with a NACK.
b.
If the host returns a NACK, it should then terminate the transfer by issuing the
STOP condition.
9.
The device resets the internal address to the location indicated by the memory address
sent to it previously. Therefore, there is no need to send the memory address again
when reading from the same location.
Note:
Reading the 16-bit reference and signal values is not an automatic operation; reading
the first byte of a 16-bit value does not lock the other byte. As a result glitches in the
reported value may be seen as values increase from 255 to 256, or decrease from 256
to 255.
SLA+W
MemAddress
AA
S
SLA+R
A
P
Host to Device
Device to Host
P
A
/A
Data 1
Data 2
Data n
相關PDF資料
PDF描述
AT42QT1110-AZ PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
AT42QT1110-MZ PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
AT42QT1111-AU PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
AT76C453AC-MY19T IMAGE SENSOR-CMOS, 708(H) X 494(V) PIXEL, 30fps, SURFACE MOUNT
ATF-33143-TR2 X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET
相關代理商/技術參數
參數描述
AT42QT1070-SSU QS529 功能描述:IC TOUCH SENSOR 7KEY 14SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:QTouch™ 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AT42QT1070-SSUR 功能描述:IC TOUCH SENSOR 7KEY 14SOIC 制造商:microchip technology 系列:QTouch?? 包裝:Digi-Reel? 零件狀態:在售 類型:按鈕 接近探測:無 輸入數:最高 7 LED 驅動器通道:最高 5 接口:I2C 分辨率:- 電壓 - 電源:1.8 V ~ 5.5 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商器件封裝:14-SOIC 標準包裝:1
AT42QT1085-AU 功能描述:電容觸摸傳感器 8 Channel QTouch Haptic Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
AT42QT1085-AUR 功能描述:電容觸摸傳感器 8 Channel QTouch Haptic Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
AT42QT1085-MU 功能描述:電容觸摸傳感器 8 Channel QTouch Haptic Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*