- 您現在的位置：買賣IC網 > PDF目錄378405 > AND8098 (ON SEMICONDUCTOR) Low-Cost 100 mA High-Voltage Buck and Buck-Boost Using NCP1052 PDF資料下載
參數資料
| 型號： | AND8098 |
| 廠商： | ON SEMICONDUCTOR |
| 英文描述： | Low-Cost 100 mA High-Voltage Buck and Buck-Boost Using NCP1052 |
| 中文描述： | 低成本百毫安高電壓降壓和降壓升壓使用NCP1052 |
| 文件頁數： | 3/10頁 |
| 文件大?。?/td> | 93K |
| 代理商： | AND8098 |
AND8098/D
http://onsemi.com
3
output voltage will rise up dramatically and burn the output
capacitor eventually. Hence, a zener diode Z
1
or minimum
“dummy” load resistor is needed to consume the minimum
amount of energy as shown in Figure 1. It is also noted that
when R
1
pulls up the output voltage at a given output current
condition, the output voltages at lower output current
conditions are also pulled up. Hence, the clamping zener
diode Z
1
is needed to be with the breakdown voltage as same
as the output voltage but it will reduce some of the efficiency
at lower output current conditions.
DESIGN CONSIDERATION
Topology
Buck circuit is to step down a voltage. Buck-boost circuit
is to step up or down a voltage. The output voltage is
inverted. The maximum duty of NCP1052 is typically 77%.
Because of burst-mode control, the effective maximum
duty is lower and said to be 70% roughly. When a buck
converter is in continuous conduction mode (CCM), the
input voltage V
in
and output voltage V
out
are related by the
duty ratio D.
Vout
Vin
The relationship in buck-boost is
D
0.7
(eq. 2)
Vout
Vin
D
1
D
0.7
1
0.7
2.33
(eq. 3)
Another aspect on topology is the output current. The
maximum output current is always smaller than the
maximum switch current in non-isolated topologies.
However, in isolated topologies such as flyback the
maximum output current can be increased by a transformer.
Table 1. Summary of Topology Difference Using NCP1052
Buck
Buck-boost
Flyback
Output voltage
< 0.7 V
in
< 300 mA
Negative & < 2.33 Vin
Depending on transformer ratio
Output current
<< 300 mA, output current is
only a portion of the inductor
current
< 10 W. It depends on operating
condition and audible noise level
Input voltage
< 700 V
700
700 V
Vout V
<< 700 V. It depends on
transformer ratio
Operating mode in nominal
condition
Continuous
Continuous
Discontinuous
Standby ability on V
CC
charging
current
Bad. The current flows through
output even if there is no load
Good. The current passes
through inductor only
Good. The current passes
through primary winding only
Transformer / Auxiliary winding
It is only for standby
improvement or additional
output
It is only for standby
improvement or additional
output
It is a must for the main output.
Additional auxiliary winding can
improve standby performance
Isolation
No
No
Yes. Opto coupler can be
eliminated if isolation is not
needed
Burst-mode Operation
The NCP1052 is with a burst-mode control method. It
means the MOSFET can be completely off for one or more
switching cycles. The output voltage is regulated by the
overall duration of dead time or non-dead time over a
number of switching cycles. This feature offers advantages
on saving energy in standby condition since it can reduce the
effective duty cycle dramatically. In flyback topology, the
circuit is mainly designed for discontinuous conduction
mode (DCM) in which the inductor current reaches zero in
every switching cycle. The DCM burst-mode waveform can
be represented in Figure 4. It is similar to the pulse-width
modulation (PWM) one.
Figure 4. DCM Inductor Currents in Burst Mode
and PWM Control
Burst mode
PWM
相關PDF資料 |
PDF描述 |
|---|---|
| AND8099 | 5.0 V, 2.0 A Flyback Converter |
| AND8109 | LED CONSTANT CURRENT SOURCE SCHEME |
| AND8112 | A Quasi-Resonant SPICE Model Eases Feedback Loop Designs |
| AND8116 | Integrated Relay/Inductive Load Drivers for Industrial and Automotive Applications |
| AND8116D | Integrated Relay/Inductive Load Drivers for Industrial and Automotive Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AND8099 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:5.0 V, 2.0 A Flyback Converter |
| AND8099/D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:5.0 V, 2.0 A Flyback Converter |
| AND8104/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MicroIntegration Technology Solutions for Protection in High Speed I/O Data Lines |
| AND8109 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:LED CONSTANT CURRENT SOURCE SCHEME |
| AND8112 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:A Quasi-Resonant SPICE Model Eases Feedback Loop Designs |
發布緊急采購，3分鐘左右您將得到回復。