- 您現在的位置：買賣IC網 > PDF目錄375327 > AN8029 (PANASONIC CORP) Self-excited RCC pseudo-resonance type AC-DC switching power supply control IC PDF資料下載
參數資料
| 型號： | AN8029 |
| 廠商： | PANASONIC CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Self-excited RCC pseudo-resonance type AC-DC switching power supply control IC |
| 中文描述： | 1 A SWITCHING CONTROLLER, PSIP9 |
| 封裝： | PLASTIC, SIP-9 |
| 文件頁數： | 6/13頁 |
| 文件大?。?/td> | 132K |
| 代理商： | AN8029 |
6
AN8029
Voltage Regulators
I
Application Notes (continued)
[1] Operation descriptions (continued)
1. Start/stop circuit block (continued)
Start mechanism (continued)
Since the supply voltage continuously decreases during the above period (area b in figure 1), the power supply
is not able to start (state c in figure 1), if the stop voltage of the IC is reached before the sufficient supply voltage
is supplied from the bias coil.
Function
The start/stop circuit block is provided with the function to monitor the V
CC
voltage, and to start the operation
of IC when V
CC
voltage reaches the start voltage (14.9 V typical), and to stop when it decreases under the stop
voltage (8.6 V typical). A large voltage difference is set between start and stop (6.3 V typical) so that it is easier
to select the start resistor and the capacitor to be connected to V
CC
.
Note) To start up the IC operation, the startup current which is a pre-start current plus a circuit drive current is necessary.
Set the resistance value so as to supply a startup current of 350
μ
A.
2. Oscillation circuit
The oscillation circuit generates the pulse signal for turning on/off the power MOSFET by using charge/
discharge of the C2, R2 and C3 connected to TOFF (pin 2), TON (pin 3) respectively.
The concept of constant voltage control at the time of making up the switching power supply is fixing the off-
period of the power MOSFET and achieving the control by changing the on-period. This on-period control is
performed by directly changing the output pulse width of the oscillation circuit.
During the on-period of the power MOSFET, the C2 is charged to the constant voltage (approximately 0.9 V).
On the other hand, the C3 is charged from almost 0 V by the charge current from the TON terminal. When the
voltage across the both ends of the C3 reaches approximately 0.7 V (T
a
=
75°C), the oscillation circuit output is
reversed and the power MOSFET is turned off. At the same time, the C3 is rapidly discharged by the discharge
circuit inside the IC and its voltage across the both ends becomes almost 0 V. The charge current from the TON
terminal is changed by the feedback signal to the FB terminal (pin 9). (Described later.)
Figure 2. Oscillation circuit operation
Voltage across
both ends of C2
Voltage across
both ends of C3
IC output
0.9 V
0.1 V
0.7 V
0 V
0 V
On-period Off-period
200
T
T
C2
C3
R2
An equation for approximate calculation of the maximum on-period T
ON(max)
of the power MOSFET is as follows:
T
ON(max)
=
6 500
×
C3
When the power MOSFET is off, the TOFF terminal becomes a high impedance state and the C2 starts
discharging by the R2. When the voltage across the both ends of C2 decreases to approximately 0.1 V, the oscillation
circuit output is reversed again to turn on the power MOSFET. At the same time, the C2 is rapidly charged to
approximately 0.9 V. An equation for approximate calculation of the minimum off-period T
OFF(min)
is as follows:
T
OFF(min)
=
2.2
×
C2
×
R2
However, when the voltage-time fed back to the TDL terminal (pin 1) is longer than the T
OFF
period deter-
mined by the C2 and R2, the off-period in the pseudo-resonance circuit operation described below is determined
by the former.
By repeating the above operation, the power MOSFET is turned on and off continuously. Figure 2 shows the
oscillation waveform at the time when the TDL terminal is pulled down to the GND.
相關PDF資料 |
PDF描述 |
|---|---|
| AN8031 | Active filter control IC |
| AN8032 | Active filter control IC |
| AN8038S | AC-DC switching power supply control IC with RCC local resonance circuit for improved conformance with energy conservation laws |
| AN8041S | Liquid crystal backlight control IC |
| AN8049 | 1.8-volt 3-channel step-up, step-down, and polarity inverting DC-DC converter control IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AN8031 | 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:Active filter control IC |
| AN8031-6-080 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| AN8031AH | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| AN8032 | 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:Active filter control IC |
| AN8032AH | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。