- 您現在的位置：買賣IC網 > PDF目錄10904 > AMIS49587C5872RG (ON Semiconductor)IC MODEM PLC 50/60MHZ 52QFN PDF資料下載
參數資料
| 型號： | AMIS49587C5872RG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 26/55頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MODEM PLC 50/60MHZ 52QFN |
| 標準包裝： | 2,500 |
| 波特率： | 可選 |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 52-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 52-QFN（8x8） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
AMIS49587
http://onsemi.com
32
11:
48 data bits per mains period = 2400 baud @ 50 Hz
MAINS_FREQ:
0:
50 Hz
1:
60 Hz
R_FS and R_FM step registers are defining the space and mark frequency. Explanation on the values can be found in paragraph
Sine wave generator. This register can be accessed via a WriteConfig_Request.
Table 31. FS AND FM STEP REGISTERS (See Table 41: Configuration Parameters)
ARM Register
Hard Reset
Soft Reset
Description
R_FS[15:0]
0000h
Step register for the space frequency fS
R_FM[15:0]
0000h
Step register for the mark frequency fM
R_ZC_ADJUST register defines the value which is preloaded in the PLL counter. This is used to fine tune the phase
difference between HIP_CLK, CIP_CLK and the – to + zero crossing of the mains. Explanation on the values can be found
in paragraph 50/60 Hz PLL. This register can be accessed via a WriteConfig_Request.
Table 32. ZC_ADJUST REGISTERS (See Table 41: Configuration Parameters)
ARM Register
Hard Reset
Soft Reset
Description
R_ZC_ADJUST[7:0]
02h
Fine tuning of phase difference between CHIP_CLK and rising
edge of Mains zero crossing
R_ALC_CTRL register enables or disables the Automatic Level Control. In case ALC is disabled the attenuation of the TX
output driver is fixed according to the value in R_ALC_CTRL[2:0]. Explanation on the attenuation values can be found in
paragraph Amplifier with Automatic Level Control. This register can be accessed via a WriteConfig_Request.
Table 33. ALC_CTRL REGISTERS (See appendix C)
ARM Register
Hard Reset
Soft Reset
Description
R_ALC_CTRL[3:0]
00h
Control register for the automatic level control
Where:
R_ALC_CTRL[3]:
0:
Automatic level control is enabled
1:
Automatic level control is disabled and attenuation is fixed
R_ALC_CTRL[2:0]:
Fixed attenuation value
Table 34. FIXED TRANSMITTER OUTPUT
ATTENUATION
ALC_CTRL[2:0]
Attenuation
000
0 dB
001
3 dB
010
6 dB
011
9 dB
100
12 dB
101
15 dB
110
18 dB
111
21 dB
6.4.10 Reset and Low Power
AMIS49587 has 2 reset mode: hard reset and soft reset.
The hard reset initializes the complete IC (hardware and
ARM) excluding the data RAM for the ARM. This makes
sure that startup of hardware and ARM is guaranteed. A
hard reset is active when pin RESB = 0 or when the power
supply VDD < VPOR (See Table 14 Power On Reset). When
switching on the power supply the output of the crystal
oscillator is disable until a few 1000 clock pulses have been
detected, this to enable the oscillator to start up.
The soft reset initializes part of the hardware. The soft
reset is activated when going into initialization mode for the
duration of maximum 1 CHIP_CLK. Initialization mode is
entered by R_CONF[5:3] = 000.
The concept of AMIS49587 has a number of provisions
to have low power consumption. When working in transmit
mode the analogue receiver path and most of the digital
receive parts are disabled. When working in receive mode
the analog transmitter and most of the digital transmit parts,
except for the sine generation, are disabled.
When the pin RESB = 0 the power consumption is
minimal. Only a limited power is necessary to maintain the
bias of a minimum number of analog functions and the
oscillator cell.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J6B-IY-B1 | CONVERTER MOD DC/DC 95V 50W |
| NCN5192MNG | IC HART MODEM CMOS SGL 32QFN |
| VI-2N4-IX-F2 | CONVERTER MOD DC/DC 48V 75W |
| VI-26D-CV | CONVERTER MOD DC/DC 85V 150W |
| VI-2N4-IX-F1 | CONVERTER MOD DC/DC 48V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS49587GEVK | 功能描述:KIT EVALUATION AMIS49587 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板 |
| AMIS-50050 | 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Trays 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Tape and Reel |
| AMIS-50051 | 制造商:ON Semiconductor 功能描述:DMOD 32LQFP / - Trays 制造商:ON Semiconductor 功能描述:DMOD - Tape and Reel |
| AMIS-52000 | 制造商:AMI 制造商全稱:AMI 功能描述:Single-Chip Radio Transceiver |
| AMIS-52050 | 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Rail/Tube 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。