
AMIS-710650-A6: Color CIS Module
Data Sheet
Analog Video Output
11.0 I/O Connector Pin Configuration
The connector is for a 12-pin flex-strip-line cable, PDK97-1201. The connector location is shown in Figure 6, an ISO drawing of the
AMIS-710650-A6 module. It also shows the location of Pin 1.
Use caution when connecting the power to the LED!
Note that all the negative sides of the LED sources are connected to the cathodes.
These I/O sources are current inputs.
Constant current sources are used to control the balance of the color in the RGB outputs. Their typical voltage drops are between 2.3 to
2.7V. Under no circumstances should the applied current be greater than 30mA, otherwise the LED source will be damaged.
Table 8: Connector Pin Outs
Pin Number
Pin Names
Symbol
1
Analog signal output
VOUT
2
Ground
GND
3
Power supply
VDD
I/0
O
I
I
Names and Functions
Analog signal output
Ground; 0V
Positive 3.3V
4
DPI-control
SR
I
Selects resolution control
5
Reference voltage
VREF
I
For externally or internally controlling the dark
bias level
Shift register start pulse
Ground; 0V
Clock input for the module
Common anodes for all LED, plus 5.0V terminal
Cathode green LED input
Cathode red LED input
Cathode blue LED input
6
7
8
9
10
11
12
Start pulse
Ground
Clock
Common
LED Green
LED Red
LED Blue
SP
GND
I
I
I
I
I
I
I
CP (CLK on the schematic)
VLED (common anode on the schematic)
GLED
RLED
BLED
7
AMI Semiconductor
– Aug. 06, M-20611-001
www.amis.com