- 您現在的位置：買賣IC網 > PDF目錄364674 > AMIS-52100 Transceiver with Clock and Data Recovery PDF資料下載
參數資料
| 型號： | AMIS-52100 |
| 英文描述： | Transceiver with Clock and Data Recovery |
| 中文描述： | 收發器時鐘和數據恢復 |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 1040K |
| 代理商： | AMIS-52100 |
AMIS-52100
Low-Power Transceiver with Clock and Data Recovery
Data Sheet
8.3 LPFILT, Loop Filter
The LPFILT pin connects the AMIS-52100 internal phase lock loop (PLL) frequency synthesizer to an external loop filter. An external
loop filter allows the design engineer to optimize the operation of the AMIS-52100 to meet the requirements of their product application.
For more information see the AMIS application note: “Extending to Frequencies outside the 403MHz Target”.
Figure 5: Typical Loop Filter
8.4 RSSI/BG, Analog Output
The RSSI/BG pin is used to output the signal from the RSSI circuits, the output of the voltage from the bandgap voltage reference or a
bypass capacitor node. The RSSI output is a true analog representation of the received signal level. The pin can also be programmed
to output the voltage of the bandgap voltage reference. When using the AMIS-52100 in the clock and data recovery mode, a capacitor
needs to be connected from the RSSI/BG pin to ground. A typical value for this capacitor is 2.2nF. Additional information on the CDR
function can be found later in this document. Table 12 presents the registers that control the function of the RSSI/BG pin.
Table 12: RSSVBG Pin Control Registers
RSSI Pin Definition Control Registers
Register
(HEX)
0x0e
Bandgap on RSSI
3
0
Normal operation
1
BG output on RSSI*
0x1e
RSSI Ext Amp
4
0
Tri-stated
1
RSSI signal
*Note that device needs to be in RX, TX or crystal on moded for bandgap voltage to be present on pin.
Name
Bits
States
Comments
8.5 CREF, Current Reference Bias
A resistor must be connected to the AMIS-52100 CREF pin to provide a current bias to the internal bandgap voltage reference circuit. It
is critical that this resistor be a 33.2K
with one percent or better tolerance for proper operation of the bandgap voltage reference.
R(Bias) = 33.2K
(1%)
8
AMI Semiconductor
– Rev 4.0, Mar. 06 – M-20535-004
www.amis.com
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS-52100-A | Transceiver with Clock and Data Recovery |
| AMIS-52100-I | Transceiver with Clock and Data Recovery |
| AMIS-52100-M | Transceiver with Clock and Data Recovery |
| AMIS-52150 | Low-Power Transceiver with Clock and Data Recovery |
| AMIS-53000 | Frequency Agile Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS52100/19293001XTD | 制造商:AMI Semiconductor 功能描述: 制造商:NTE Electronics 功能描述: |
| AMIS-52100-A | 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery |
| AMIS-52100-I | 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery |
| AMIS-52100-M | 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery |
| AMIS-52150 | 制造商:AMI 制造商全稱:AMI 功能描述:Low-Power Transceiver with Clock and Data Recovery |
發布緊急采購，3分鐘左右您將得到回復。