- 您現在的位置：買賣IC網 > PDF目錄223322 > AFBR-5803TZ FIBER OPTIC TRANSCEIVER, 1270-1380nm, 125Mbps(Tx), 125Mbps(Rx), THROUGH HOLE MOUNT, ST CONNECTOR PDF資料下載
參數資料
| 型號： | AFBR-5803TZ |
| 元件分類： | 光收發 |
| 英文描述： | FIBER OPTIC TRANSCEIVER, 1270-1380nm, 125Mbps(Tx), 125Mbps(Rx), THROUGH HOLE MOUNT, ST CONNECTOR |
| 封裝： | ROHS COMPLIANT, SIP-9 |
| 文件頁數： | 13/16頁 |
| 文件大?。?/td> | 489K |
| 代理商： | AFBR-5803TZ |
Figure 7. Recommended Decoupling and Termination Circuits
Figure 6. Bit Error Rate vs. Relative Receiver Input Optical Power.
BIT
ERROR
RATE
-6
4
1 x 10 -2
RELATIVE INPUT OPTICAL POWER - dB
-4
2
-2
0
1 x 10 -4
1 x 10 -6
1 x 10 -8
1 x 10 -10
1 x 10 -11
CONDITIONS:
1. 155 MBd
2. PRBS 27-1
3. CENTER OF SYMBOL SAMPLING
4. TA= +25C
5. VCC= 3.3 V to 5 V dc
6. INPUT OPTICAL RISE/FALL TIMES = 1.0/2.1 ns.
1 x 10 -12
1 x 10 -9
1 x 10 -7
1 x 10 -5
1 x 10 -3
CENTER OF SYMBOL
AFBR-5803 SERIES
NO INTERNAL CONNECTION
AFBR-5803Z
TOP VIEW
V
EE
RD
SD
V
CC
V
CC
TD
V
EE
1
2
3
4
5
6
7
8
9
C1
C2
L1
L2
R2
R3
R1
R4
C5
C3
C4
R9
R10
V
CC FILTER
AT V
CC PINS
TRANSCEIVER
R5
R7
R6
R8
C6
RD
SD
V
CC
TD
TERMINATION
AT PHY
DEVICE
INPUTS
NOTES:
THE SPLIT-LOAD TERMINATIONS FOR ECL SIGNALS NEED TO BE LOCATED AT THE INPUT
OF DEVICES RECEIVING THOSE ECL SIGNALS. RECOMMEND 4-LAYER PRINTED CIRCUIT
BOARD WITH 50 OHM MICROSTRIP SIGNAL PATHS BE USED.
R1 = R4 = R6 = R8 = R10 = 130 OHMS FOR +5.0 V OPERATION, 82 OHMS FOR +3.3 V OPERATION.
R2 = R3 = R5 = R7 = R9 = 82 OHMS FOR +5.0 V OPERATION, 130 OHMS FOR +3.3 V OPERATION.
C1 = C2 = C3 = C5 = C6 = 0.1 F.
C4 = 10 F.
L1 = L2 = 1 H COIL OR FERRITE INDUCTOR.
TERMINATION
AT TRANSCEIVER
INPUTS
Rx
Tx
V
CC
V
CC
Rx
Tx
Transceiver Jitter Performance
TheAvago Technologies 1300 nm transceivers are
designed to operate per the system jitter allocations
stated in Tables E1 of Annexes E of the FDDI PMD and
LCF-PMD standards.
The Avago Technologies1300 nm transmitters will
tolerate the worst case input electrical jitter allowed in
these tables without violating the worst case output jitter
requirements of Sections 8.1 Active Output Interface of
the FDDI PMD and LCF-PMD standards.
The Avago Technologies 1300 nm receivers will tolerate
the worst case input optical jitter allowed in Sections 8.2
Active Input Interface of the FDDI PMD and LCF-PMD
standards without violating the worst case output electri-
cal jitter allowed in the Tables E1 of the Annexes E.
The jitter specifications stated in the following 1300 nm
transceiver specification tables are derived from the
values in Tables E1 of Annexes E. They represent the worst
case jitter contribution that the transceivers are allowed
to make to the overall system jitter without violating the
Annex E allocation example. In practice the typical con-
tribution of the Avago Technologies transceivers is well
below these maximum allowed amounts.
Recommended Handling Precautions
Avago Technologies recommends that normal static pre-
cautions be taken in the handling and assembly of these
transceivers to prevent damage which may be induced
by electrostatic discharge (ESD). The AFBR-5800 series of
transceivers meet MIL-STD-883C Method 3015.4 Class 2
products.
Care should be used to avoid shorting the receiver data
or signal detect outputs directly to ground without
proper current limiting impedance.
相關PDF資料 |
PDF描述 |
|---|---|
| AFBR-5903EZ | FIBER OPTIC TRANSCEIVER, 1270-1380nm, 125Mbps(Tx), 125Mbps(Rx), BOARD/PANEL MOUNT, MT-RJ CONNECTOR |
| AFBR-5903Z | FIBER OPTIC TRANSCEIVER, 1270-1380nm, 125Mbps(Tx), 125Mbps(Rx), BOARD/PANEL MOUNT, MT-RJ CONNECTOR |
| AFBR-5930Z | FIBER OPTIC TRANSCEIVER, 1280-1380nm, 200Mbps(Tx), 200Mbps(Rx), BOARD/PANEL MOUNT, MT-RJ CONNECTOR |
| AFBR-700SDZ | FIBER OPTIC TRANSCEIVER, 840-860nm, 10000Mbps(Tx), 10000Mbps(Rx), PANEL MOUNT, LC CONNECTOR |
| AFBR-707SDZ | FIBER OPTIC TRANSCEIVER, 1260-1355nm, 10000Mbps(Tx), 10000Mbps(Rx), SURFACE MOUNT, LC CONNECTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AFBR-5803Z | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFBR-5805ATZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFBR-5805AZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFBR-5805TZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFBR-5805Z | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
發布緊急采購，3分鐘左右您將得到回復。