- 您現在的位置：買賣IC網 > PDF目錄10728 > ADS1222IPWT (Texas Instruments)IC 24BIT ADC W/2CH MUX 14-TSSOP PDF資料下載
參數資料
| 型號： | ADS1222IPWT |
| 廠商： | Texas Instruments |
| 文件頁數： | 26/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC 24BIT ADC W/2CH MUX 14-TSSOP |
| 產品培訓模塊： | Data Converter Basics |
| 視頻文件： | Nuts and Bolts of the Delta-Sigma Converter |
| 標準包裝： | 1 |
| 位數： | 24 |
| 采樣率（每秒）： | 240 |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 2.25mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 4 個單端，單極；2 個差分，雙極 |
| 其它名稱： | 296-17321-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁
ADS1222
SBAS314B APRIL 2004 REVISED JANUARY 2009
www.ti.com
9
Analog Input Measurement without the Input Buffer
With the buffer disabled by setting the BUFEN pin low,
the ADS1222 measures the input signal using internal
capacitors
that
are
continuously
charged
and
discharged. Figure 14 shows a simplified schematic of
the ADS1222 input circuitry, with Figure 15 showing the
on/off timings of the switches. The S1 switches close
during the input sampling phase. With S1 closed, CA1
charges to AINP, CA2 charges to AINN, and CB charges
to (AINP – AINN). For the discharge phase, S1 opens
first and then S2 closes. CA1 and CA2 discharge to
approximately VDD/2 and CB discharges to 0V. This
two-phase sample/discharge cycle repeats with a
frequency of fCLK/32 (62.5kHz for fCLK = 2MHz).
Mux
VDD
VDD/2
S
1
S
1
AINN
AINP
S
2
C
A1
3pF
C
B
6pF
C
A2
3pF
VDD
ESD Protection
AINPx
AINNx
S
2
Figure 14. Simplified Input Structure with the
Buffer Turned Off
ON
OFF
ON
S
1
S
2
OFF
t
SAMPLE = 32/fCLK
Figure 15. S1 and S2 Switch Timing for Figure 14
The constant charging of the input capacitors presents
a load on the inputs that can be represented by effective
impedances. Figure 16 shows the input circuitry with
the capacitors and switches of Figure 14 replaced by
their effective impedances. These impedances scale
inversely with fCLK frequency. For example, if fCLK
frequency is reduced by a factor of 2, the impedances
will double.
Zeff
A =tSAMPLE/CA1 =6M
(1)
Zeff
B =tSAMPLE/CB =3M
(1)
Zeff
A =tSAMPLE/CA2 =6M
(1)
NOTE: (1) fCLK =2MHz.
AINPx
AINNx
VDD/2
Figure 16. Effective Analog Input Impedances
with the Buffer Off
ESD diodes protect the inputs. To keep these diodes
from turning on, make sure the voltages on the input
pins do not go below GND by more than 100mV, and
likewise do not exceed VDD by 100mV:
GND – 100mV < (AINP, AINN) < VDD + 100mV
Analog Input Measurement with the Input Buffer
When the buffer is enabled by setting the BUFEN pin
high, a low-drift, chopper-stabilized input buffer is used
to achieve very high input impedance. The buffer
charges the input sampling capacitors, thus removing
the load from the measurement. Because the input
buffer is chopper-stabilized, the charging of parasitic
capacitances causes the charge to be carried away, as
if by resistance. The input impedance can be modeled
by a single resistor, as shown in Figure 17. The
impedance scales inversely with fCLK frequency, as in
the nonbuffered case. Note that during standby mode,
the buffer must be disabled to prevent loading of the
inputs.
AINP
AINN
1.2G
(1)
NOTE: (1) f
CLK =2MHz.
Figure 17. Effective Analog Input Impedances
with the Buffer On
Note also that the analog inputs (listed in the Electrical
Characteristics table as Absolute Input Range) must
remain between GND + 0.05V to VDD 1.5V.
Exceeding this range degrades linearity and results in
performance outside the specified limits.
相關PDF資料 |
PDF描述 |
|---|---|
| LM393DRE4 | IC DUAL DIFF COMPARATOR 8-SOIC |
| ADS7818EB/250 | IC 12-BIT 500KHZ A/D CONV 8-MSOP |
| MCP3428-E/ST | IC ADC 16BIT I2C PROGBL 14-TSSOP |
| MAX901ACSE+ | IC COMPARATOR VOLT 16-SOIC |
| VI-J4Y-MW-F4 | CONVERTER MOD DC/DC 3.3V 66W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS1222IPWT | 制造商:Texas Instruments 功能描述:IC 24-BIT ADC 2 CH DIFF I/P MULTI |
| ADS1222IPWTG4 | 功能描述:模數轉換器 - ADC 24-Bit Conv w/2-Ch Diff Input Mltplxer RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1224 | 制造商:BB 制造商全稱:BB 功能描述:24-Bit Analog-to-Digital Converter with 4-Channel Differential Input Multiplexer |
| ADS1224EVM | 功能描述:數據轉換 IC 開發工具 ADS1224 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| ADS1224IPWR | 功能描述:模數轉換器 - ADC 24-bit 240SPS RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。