參數資料
型號: ADN2891ACPZ-500RL7
廠商: Analog Devices Inc
文件頁數: 2/16頁
文件大?。?/td> 0K
描述: IC AMP LIM 16LFCSP
標準包裝: 1
放大器類型: 限制
電路數: 1
輸出類型: 差分
電壓 - 輸入偏移: 100µV
電流 - 電源: 45mA
電壓 - 電源,單路/雙路(±): 2.9 V ~ 3.6 V
工作溫度: -40°C ~ 95°C
安裝類型: 表面貼裝
封裝/外殼: 16-VFQFN 裸露焊盤,CSP
供應商設備封裝: 16-LFCSP-VQ EP(3x3)
包裝: 標準包裝
其它名稱: ADN2891ACPZ-500RL7DKR
ADN2891
Rev. A | Page 10 of 16
THEORY OF OPERATION
LIMITING AMPLIFIER
Input Buffer
The ADN2891 limiting amplifier provides differential inputs
(PIN/NIN), each having single-ended, on-chip, 50 Ω termina-
tion. The amplifier can accept either dc-coupled or ac-coupled
signals; however, an ac-coupled signal is recommended. Using a
dc-coupled signal, the amplifier needs a correct input common-
mode voltage and enough headroom to handle the dynamic
input signal strength. Additionally, TIA output offset drifts may
degrade receiver performance.
The ADN2891 limiting amplifier is a high gain device. It is
susceptible to dc offsets in the signal path. The pulse width
distortion presented in the NRZ data or a distortion generated
by the TIA may appear as dc offset or a corrupted signal to the
ADN2891 inputs. An internal offset correction loop can
compensate for certain levels of offset. To compensate for more
offset, an external capacitor connected between the CAZ1 and
CAZ2 pins maybe necessary. For GbE and FC applications, no
external capacitor is necessary; however, for SONET appli-
cations, a 0.01 μF capacitor helps the input signal offset
compensation and provides a 3 dB cutoff frequency at 1 kHz.
CML Output Buffer
The ADN2891 provides differential CML outputs, OUTP and
OUTN. Each output has an internal 50 Ω termination to VCC.
LOSS OF SIGNAL (LOS) DETECTOR
The on-chip LOS circuit drives LOS to logic high when the
input signal level falls below a user-programmable threshold.
The threshold level can be set to anywhere from 3.5 mV p-p to
35 mV p-p, typical, and is set by a resistor connected between
the THRADJ pin and VEE. See Figure 8 and Figure 9 for the
LOS threshold vs. THRADJ. The ADN2891 LOS circuit has an
electrical hysteresis greater than 2.5 dB to prevent chatter at the
LOS signal. The LOS output is an open-collector output that
must be pulled up externally with a 4.7 kΩ to 10 kΩ resistor.
RECEIVED SIGNAL STRENGTH INDICATOR (RSSI)
The ADN2891 has an on-chip, RSSI circuit. By monitoring the
current supplied to the photodiode, the RSSI circuit provides an
accurate, average power measurement. The output of the RSSI is
a current that is directly proportional to the average amount of
PIN photodiode current. Placing a resistor between the
RSSI_OUT pin and GND converts the current to a GND
referenced voltage. This function eliminates the need for
external RSSI circuitry for SFF-8472-compliant optical
receivers. For more information, see Figure 14 to Figure 18.
SQUELCH MODE
Driving the SQUELCH input to logic high disables the limiting
amplifier outputs. Using LOS output to drive the SQUELCH
input, the limiting amplifier outputs stop toggling anytime a
signal input level to the limiting amplifier drops below the
programmed LOS threshold.
The SQUELCH pin has a 100 kΩ, internal, pull-down resistor.
相關PDF資料
PDF描述
ADN2892ACPZ-500RL7 IC AMP LIM 16LFCSP
ADR827BRMZ-REEL7 IC OPAMP GP R-R 1MHZ LP 10MSOP
ADTL084ARZ-REEL7 IC OPAMP JFET 5MHZ QUAD 14SOIC
AFB02512HHA FAN DC AXIAL 12V 25X10 13000RPM
AFB0305HA-AF00 FAN DC 5V 30X30X10 MM
相關代理商/技術參數
參數描述
ADN2891ACPZ-RL 功能描述:IC AMP LIM 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP(0.300",7.62mm) 供應商設備封裝:8-PDIP 包裝:管件
ADN2891ACPZ-RL7 功能描述:IC AMP LIM 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源,單路/雙路(±):3 V ~ 32 V,±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR
ADN2891ACPZ-WP 制造商:Analog Devices 功能描述:SP Amp Limiting Amp Single 3.6V 16-Pin LFCSP EP Tray 制造商:Analog Devices 功能描述:SP AMP LIMITING AMP SGL 3.6V 16LFCSP EP - Waffle Pack 制造商:Analog Devices 功能描述:APC12.7GBPS LIMITING AMPLIFIER.I.C.
ADN2891XCPZ 制造商:Analog Devices 功能描述:- Trays
ADN2892 制造商:AD 制造商全稱:Analog Devices 功能描述:3.3 V 4.25 Gb/s Limiting Amplifier