- 您現在的位置：買賣IC網 > PDF目錄373995 > ADM1033ARQZ-REEL7 (ANALOG DEVICES INC) Thermal Monitor and Fan Speed (RPM) Controller PDF資料下載
參數資料
| 型號： | ADM1033ARQZ-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 溫度/濕度傳感器 |
| 英文描述： | Thermal Monitor and Fan Speed (RPM) Controller |
| 中文描述： | DIGITAL TEMP SENSOR-SERIAL, 8BIT(s), 2Cel, RECTANGULAR, SURFACE MOUNT |
| 封裝： | LEAD FREE, MO-137AB, QSOP-16 |
| 文件頁數： | 26/40頁 |
| 文件大?。?/td> | 1164K |
| 代理商： | ADM1033ARQZ-REEL7 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
ADM1033
FAN INPUTS
Pin 2 is the TACH input intended for fan speed measurement.
This input is open-drain.
Rev. 0 | Page 26 of 40
Signal conditioning on the ADM1033 accommodates the slow
rise and fall time of typical tachometer outputs. The maximum
input signal range is from 0 V to 5 V, even when V
CC
is less than
5 V. If these inputs are supplied from fan outputs that exceed
0 V to 5 V, either resistive attenuation of the fan signal or diode
clamping must be used to keep the fan inputs within an
acceptable range.
Figure 36 to Figure 38 show examples of possible fan input
circuits.
5V OR 12V
FAN
DRIVE X
FAN SPEED
COUNTER
ADM1033
TACH X
PULL-UP
4.7k
TYP
TACH
OUTPUT
V
CC
V
CC
100k
TYP
0
ZD1*
*CHOOSE ZD1 VOLTAGE APPROXIMATELY 0.8
×
V
CC
Figure 36. Fan with TACH Pull-Up to Voltage > 5 V, Clamped with Zener Diode
If the fan output has a resistive pull-up to 12 V (or another
voltage greater than 5 V), the fan output can be clamped with a
Zener diode, as shown in Figure 36. Select a Zener voltage that
is greater than V
IH
but less than 5 V, allowing for the voltage
tolerance of the Zener. A value of between 3 V and 5 V is
suitable.
12V
ADM1033
FAN SPEED
COUNTER
FAN(0–7)
PULL-UP TYP
<1 k
OR
TOTEM POLE
TACH
OUTPUT
V
CC
*CHOOSE ZD1 VOLTAGE APPROXIMATELY 0.8
×
V
CC
ZD1
ZENER*
R1
10k
0
Figure 37. Fan with Strong TACH Pull-Up to Voltage > V
CC
or Totem Pole
Output, Clamped with Zener and Resistor
If the fan has a strong pull-up (less than 1 k to 12 V) or a
totem-pole output, then a series resistor can be added to limit
the Zener current, as shown in Figure 37.
Or, resistive attenuation can be used, as shown in Figure 38.
R1
and
R2
should be chosen such that
2 V <
V
PULL-UP
×
R2
/(
R
PULL-UP
+ R1 + R2
) < 5 V
The fan inputs have an input resistance of about 160 k to
ground. Consider this when calculating resistor values.
With a pull-up voltage of 12 V and pull-up resistor of less than
1 k, suitable values for R1 and R2 would be 100 k and 47 k.
This gives a high input voltage of 3.83 V.
12V
FAN SPEED
COUNTER
ADM1033
FAN(0–7)
<1 k
TACH
OUTPUT
V
CC
R1*
R2
*SEE TEXT
0
Figure 38. Fan with Strong TACH Pull-Up to Voltage > V
CC
to Totem Pole
Output, Attenuated with R1/R2
FAN SPEED MEASUREMENT
The fan counter does not count the fan TACH output pulses
directly. This is because the fan may be spinning at less than
1,000 rpm and it would take several seconds to accumulate a
large and accurate count. Instead, the period of the fan
revolution is measured by gating an on-chip 81.92 kHz
oscillator into the input of a 16-bit counter for one complete
revolution of the fan. Therefore, the accumulated count value is
actually proportional to the fan tachometer period and inversely
proportional to the fan speed.
The number of poles in the fan must be programmed in
Configuration Register 3 (Address 0x03). This number must be
an even number only, because there cannot be an uneven
number of poles in a fan. A TACH period is output for every
two poles. Therefore, the number of poles must be known so
that the ADM1033 can measure for a full revolution.
Figure 39 shows the fan speed measurement period, assuming
that the fan outputs an ideal TACH signal. In reality, the TACH
signal output by the fan is chopped by the drive signal. However,
because the drive signal and TACH signal are synchronized,
there is enough information available for the ADM1033 to
measure the fan speed accurately.
CLOCK
IDEAL
TACH
FAN
MEASUREMENT
PERIOD
0
Figure 39. Fan Speed Measurement for a 4-Pole Fan
相關PDF資料 |
PDF描述 |
|---|---|
| ADM1041ARQ-REEL | Secondary-Side Controller with Current Share and Housekeeping |
| ADM1041ARQ-REEL7 | Secondary-Side Controller with Current Share and Housekeeping |
| ADM1041 | Secondary-Side Controller with Current Share and Housekeeping |
| ADM1041ARQ | Secondary-Side Controller with Current Share and Housekeeping |
| ADM1041A | Secondary-Side Controller with Current Share and Housekeeping |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM1033ARQZ-RL7 | 功能描述:IC THERM/FAN SPEED CTLR 16-QSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱管理 系列:- 標準包裝:1 系列:- 功能:溫度監控系統（傳感器） 傳感器類型:內部和外部 感應溫度:-40°C ~ 125°C，外部傳感器 精確度:±2.5°C 本地（最大值），±5°C 遠程（最大值） 拓?fù)?ADC，比較器，寄存器庫 輸出類型:2 線 SMBus? 輸出警報:無 輸出風扇:無 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 供應商設備封裝:SOT-23-8 包裝:Digi-Reel® 其它名稱:296-22675-6 |
| ADM1034 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Thermal Monitor and Fan Speed (RPM) Controller |
| ADM1034ARQ | 制造商:ON Semiconductor 功能描述:Temp Sensor Digital Serial (2-Wire) 16-Pin QSOP Tube 制造商:Rochester Electronics LLC 功能描述:DUAL FAN CONTROLLER, SRC, SMBUS I.C. - Bulk |
| ADM1034ARQ-REEL | 功能描述:IC THERM/FAN SPEED CTRLR 16-QSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱管理 系列:- 標準包裝:1 系列:- 功能:溫度監控系統（傳感器） 傳感器類型:內部和外部 感應溫度:-40°C ~ 125°C，外部傳感器 精確度:±2.5°C 本地（最大值），±5°C 遠程（最大值） 拓?fù)?ADC，比較器，寄存器庫 輸出類型:2 線 SMBus? 輸出警報:無 輸出風扇:無 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 供應商設備封裝:SOT-23-8 包裝:Digi-Reel® 其它名稱:296-22675-6 |
| ADM1034ARQ-REEL7 | 功能描述:IC THERM/FAN SPEED CTRLR 16-QSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱管理 系列:- 標準包裝:1 系列:- 功能:溫度監控系統（傳感器） 傳感器類型:內部和外部 感應溫度:-40°C ~ 125°C，外部傳感器 精確度:±2.5°C 本地（最大值），±5°C 遠程（最大值） 拓?fù)?ADC，比較器，寄存器庫 輸出類型:2 線 SMBus? 輸出警報:無 輸出風扇:無 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 供應商設備封裝:SOT-23-8 包裝:Digi-Reel® 其它名稱:296-22675-6 |
發布緊急采購，3分鐘左右您將得到回復。