- 您現在的位置：買賣IC網 > PDF目錄10977 > AD9850BRS-REEL (Analog Devices Inc)IC DDS SYNTHESIZER CMOS 28-SSOP PDF資料下載
參數資料
| 型號： | AD9850BRS-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/20頁 |
| 文件大小： | 0K |
| 描述： | IC DDS SYNTHESIZER CMOS 28-SSOP |
| 產品培訓模塊： | Direct Digital Synthesis Tutorial Series (1 of 7): Introduction Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator |
| 標準包裝： | 1,500 |
| 分辨率（位）： | 10 b |
| 主 fclk： | 125MHz |
| 調節字寬（位）： | 32 b |
| 電源電壓： | 3.3V，5V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
AD9850
–13–
REV. H
DATA (7) –
W CLK
FQ UD
W32 = 0
W33 = 0
W34 = 1
W35 = X
W36 = X
W37 = X
W38 = X
W39 = X
Figure 13. Serial Load Power-Down Sequence
VCC
QOUT/
QOUTB
VCC
IOUT IOUTB
VINP/
VINN
VCC
DIGITAL
IN
VCC
DAC Output
Comparator Output
Comparator Input
Digital Inputs
Figure 14. AD9850 I/O Equivalent Circuits
PCB LAYOUT INFORMATION
The AD9850/CGPCB and AD9850/FSPCB evaluation boards
(Figures 15 through 18) represent typical implementations of the
AD9850 and exemplify the use of high frequency/high resolution
design and layout practices. The printed circuit board that contains
the AD9850 should be a multilayer board that allows dedicated
power and ground planes. The power and ground planes should
be free of etched traces that cause discontinuities in the planes. It
is recommended that the top layer of the multilayer board also
contain an interspatial ground plane, which makes ground avail-
able for surface-mount devices. If separate analog and digital
system ground planes exist, they should be connected together at
the AD9850 for optimum results.
Avoid running digital lines under the device because these
couple noise onto the die. The power supply lines to the
AD9850 should use as large a track as possible to provide a low
impedance path and reduce the effects of glitches on the power
supply line. Fast switching signals like clocks should be shielded
with ground to avoid radiating noise to other sections of the
board. Avoid crossover of digital and analog signal paths. Traces
on opposite sides of the board should run at right angles to each
other. This reduces the effects of feedthrough through the cir-
cuit board. Use microstrip techniques where possible.
Good decoupling is also an important consideration. The analog
(AVDD) and digital (DVDD) supplies to the AD9850 are
independent and separately pinned out to minimize coupling
between analog and digital sections of the device. All analog
and digital supplies should be decoupled to AGND and DGND,
respectively, with high quality ceramic capacitors. To achieve
best performance from the decoupling capacitors, they should
be placed as close as possible to the device, ideally right up
against the device. In systems where a common supply is used to
drive both the AVDD and DVDD supplies of the AD9850, it is
recommended that the system’s AVDD supply be used.
Analog Devices, Inc. applications engineering support is avail-
able to answer additional questions on grounding and PCB
layout. Call 1-800-ANALOGD or contact us at
www.analog.com/dds.
Evaluation Boards
Two versions of evaluation boards are available for the AD9850,
which facilitate the implementation of the device for bench-
top analysis and serve as a reference for PCB layout. The
AD9850/FSPCB is used in applications where the device is used
primarily as a frequency synthesizer. This version facilitates
connection of the AD9850’s internal D/A converter output to a
50
spectrum analyzer input; the internal comparator on the
AD9850 DUT is not enabled (see Figure 15 for an electrical
schematic of AD9850/FSPCB). The AD9850/CGPCB is used
in applications using the device in the clock generator mode. It
connects the AD9850’s DAC output to the internal comparator
input via a single-ended, 42 MHz low-pass, 5-pole elliptical
filter. This model facilitates the access of the AD9850’s com-
parator output for evaluation of the device as a frequency- and
phase-agile clock source (see Figure 17 for an electrical sche-
matic of AD9850/CGPCB).
Both versions of the AD9850 evaluation board are designed to
interface to the parallel printer port of a PC. The operating
software runs under Microsoft
Windows and provides a user-
friendly and intuitive format for controlling the functionality
and observing the performance of the device. The 3.5 inch
floppy provided with the evaluation board contains an execut-
able file that loads and displays the AD9850 function-selection
screen. The evaluation board can be operated with 3.3 V or 5 V
supplies. The evaluation boards are configured at the factory for
an external reference clock input; if the on-board crystal clock
source is used, remove R2.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BWJ-IY-F3 | CONVERTER MOD DC/DC 36V 50W |
| VE-BWH-IY-F2 | CONVERTER MOD DC/DC 52V 50W |
| VE-BWF-IY-F2 | CONVERTER MOD DC/DC 72V 50W |
| AD9851BRSZRL | IC SYNTHESR DDS/DAC 28SSOP TR |
| VE-BW3-IY-F3 | CONVERTER MOD DC/DC 24V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9850BRSZ | 功能描述:IC DDS SYNTHESIZER CMOS 28-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 調節字寬（位）:32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD9850BRSZ | 制造商:Analog Devices 功能描述:IC, DDS, 125MHz, SSOP-28 |
| AD9850BRSZ-REEL | 功能描述:IC DDS SYNTHESIZER CMOS 28-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 調節字寬（位）:32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD9851 | 制造商:AD 制造商全稱:Analog Devices 功能描述:CMOS 180 MHz DDS/DAC Synthesizer |
| AD9851/CGPCB | 制造商:Analog Devices 功能描述:NCO/DDS, CMOS 180MHZ DDS/DAC SYNTHESIZER - Bulk 制造商:Rochester Electronics LLC 功能描述:DDS CLOCK DRIVER - Bulk |
發布緊急采購，3分鐘左右您將得到回復。