參數資料
型號： AD9116BCPZ
廠商： Analog Devices Inc
文件頁數： 46/52頁
文件大?。?/td> 0K
描述： IC DAC DUAL 12BIT LO PWR 40LFCSP
產品培訓模塊： Data Converter Fundamentals
DAC Architectures
標準包裝： 1
系列： TxDAC®
位數： 12
數據接口： 串行
轉換器數目： 2
電壓電源： 模擬和數字
功率耗散（最大）： 232mW
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 40-VFQFN 裸露焊盤，CSP
供應商設備封裝： 40-LFCSP-VQ（6x6）
包裝： 托盤
輸出數目和類型： 4 電流，單極
采樣率（每秒）： 125M
AD9114/AD9115/AD9116/AD9117
Data Sheet
Rev. C | Page 50 of 52
Note that LO feedthrough compensation is independent of
phase compensation. However, gain compensation can affect
the LO compensation because the gain compensation may change
the common-mode level of the signal. The dc offset of some
modulators is common-mode level dependent. Therefore, it is
recommended that the gain adjustment be performed prior to
LO compensation.
LO FEEDTHROUGH COMPENSATION
To achieve LO feedthrough compensation in a circuit, each
output of the two AUXDACs must be connected through a
10 kΩ resistor to one side of the differential DAC output. See
the Auxiliary DACs section for details of how to use AUXDACs.
The purpose of these connections is to drive a very small amount
of current into the nodes at the quadrature modulator inputs,
thereby adding a slight dc bias to one or the other of the
quadrature modulator signal inputs.
To achieve LO feedthrough compensation, the user should start
with the default conditions of the AUXDAC registers and then
increment the magnitude of one or the other AUXDAC output
voltages. While this is being done, the amplitude of the LO
feedthrough at the quadrature modulator output should be
sensed. If the LO feedthrough amplitude increases, try either
decreasing the output voltage of the AUXDAC being adjusted
or try adjusting the output voltage of the other AUXDAC. It
may take practice before an effective algorithm is achieved. The
AD9114/AD9115/AD9116/ AD9117 evaluation board can be
used to adjust the LO feedthrough down to the noise floor,
although this is not stable over temperature.
RESULTS OF GAIN AND OFFSET CORRECTION
The results of gain and offset correction can be seen in Figure 109
and Figure 110. Figure 109 shows the output spectrum of the
quadrature demodulator before gain and offset correction.
Figure 110 shows the output spectrum after correction. The
LO feedthrough spur at 450 MHz has been suppressed to the
noise level. This result can be achieved by applying the correction,
but the correction must be repeated after a large change in
temperature.
Note that gain matching improves the negative frequency
image rejection, but it is also related to the phase mismatch in
the quadrature modulator. It can be improved by adjusting the
relative phase between the two quadrature signals at the digital side
or properly designing the low-pass filter between the DACs and
quadrature modulators. Phase mismatch is frequency dependent;
therefore, routines must be developed to adjust it if wideband
signals are desired.
5
–5
–15
–25
–35
–45
–55
–65
–75
–85
–95
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
447.5
449.0
450.0
451.0
452.5
FREQUENCY (MHz)
dB
07466-
070
Figure 109. AD9114/AD9115/AD9116/AD9117 and ADL5370 with a Single-
Tone Signal at 450 MHz, No Gain or LO Compensation
5
–5
–15
–25
–35
–45
–55
–65
–75
–85
–95
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
447.5
449.0
450.0
451.0
452.5
FREQUENCY (MHz)
dB
07466-
071
Figure 110. AD9114/AD9115/AD9116/AD9117 and ADL5370 with a Single-
Tone Signal at 450 MHz, Gain and LO Compensation Optimized
相關PDF資料
PDF描述
VI-J0P-MZ-F4 CONVERTER MOD DC/DC 13.8V 25W
VI-J0P-MZ-F2 CONVERTER MOD DC/DC 13.8V 25W
VI-J0V-MZ-F2 CONVERTER MOD DC/DC 5.8V 25W
DAC8800FSZ IC DAC 8BIT OCTAL CMOS 20-SOIC
ICS844S42BKILFT IC SYNTHESIZER RF FREQ 56-VFQFPN
相關代理商/技術參數
參數描述
AD9116BCPZRL7 功能描述:IC DAC DUAL 12BIT LO PWR 40LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC® 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:*
AD9116-DPG2-EBZ 功能描述:IC DAC DUAL 12BIT LO PWR 40LFCSP RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
AD9116-EBZ 制造商:Analog Devices 功能描述:DUAL 12 BIT LOW POWER CONVERTER - Boxed Product (Development Kits)
AD9117 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual, 8-/10-/12-/14-Bit Low Power Digital-to-Analog Converters
AD9117BCPZ 功能描述:IC DAC DUAL 14BIT LO PWR 40LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*