- 您現在的位置：買賣IC網 > PDF目錄5408 > AD8614ARTZ-REEL (Analog Devices Inc)IC OPAMP GP R-R 5.5MHZ SOT23-5 PDF資料下載
參數資料
| 型號： | AD8614ARTZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R 5.5MHZ SOT23-5 |
| 標準包裝： | 10,000 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 7.5 V/µs |
| 增益帶寬積： | 5.5MHz |
| 電流 - 輸入偏壓： | 80nA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 800µA |
| 電流 - 輸出 / 通道： | 70mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 18 V |
| 工作溫度： | -20°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SC-74A，SOT-753 |
| 供應商設備封裝： | SOT-23-5 |
| 包裝： | 帶卷 (TR) |
AD8614/AD8644
Rev. B | Page 11 of 16
CAPACITIVE LOAD DRIVE
The AD8614/AD8644 exhibit excellent capacitive load driving
capabilities. Although the device is stable with large capacitive
loads, there is a decrease in amplifier bandwidth as the
capacitive load increases.
When driving heavy capacitive loads directly from the
AD8614/AD8644 output, a snubber network can be used to
improve the transient response. This network consists of a
series R-C connected from the amplifier’s output to ground,
placing it in parallel with the capacitive load. The configuration
is shown in Figure 28. Although this network does not increase
the bandwidth of the amplifier, it does significantly reduce the
amount of overshoot.
AD86x4
VOUT
5V
RX
CX
CL
VIN
06
48
5-
028
Figure 28. Snubber Network Compensation for Capacitive Loads
The optimum values for the snubber network should be
determined empirically based on the size of the capacitive load.
Table 4 shows a few sample snubber network values for a given
load capacitance.
Table 4. Snubber Networks for Large Capacitive Loads
Load Capacitance (CL)
Snubber Network (RX, CX)
0.47 nF
300 Ω, 0.1 μF
4.7 nF
30 Ω, 1 μF
47 nF
5 Ω, 10 μF
DIRECT ACCESS ARRANGEMENT
Figure 29 shows a schematic for a 5 V single-supply transmit/
receive telephone line interface for 600 Ω transmission systems. It
allows full duplex transmission of signals on a transformer-
coupled 600 Ω line. Amplifier A1 provides gain that can be
adjusted to meet the modem’s output drive requirements. Both
A1 and A2 are configured to apply the largest possible differential
signal to the transformer. The largest signal available on a single
5 V supply is approximately 4.0 V p-p into a 600 Ω transmission
system. Amplifier A3 is configured as a difference amplifier to
extract the receive information from the transmission line for
amplification by A4. A3 also prevents the transmit signal from
interfering with the receive signal. The gain of A4 can be adjusted
in the same manner as A1 to meet the modem input signal
requirements. Standard resistor values permit the use of single
in-line package (SIP) format resistor arrays. Couple this with
the AD8644 14-lead SOIC or TSSOP package and this circuit
can offer a compact solution.
6.2V
2k
1:1
1
2
3
7
6
5
2
3
1
6
5
7
5V DC
A1, A2 = 1/2 AD8644
A3, A4 = 1/2 AD8644
R12
10k
R11
10k
R10
10k
R13
10k
R14
14.3k
C2
0.1F
RECEIVE
RxA
2k
10F
P2
Rx GAIN
ADJUST
R7
10k
R8
10k
R9
10k
R6
10k
R5
10k
TRANSMIT
TxA
C1
0.1F
R1
10k
R2
9.09k
P1
Tx GAIN
ADJUST
R3
360
TO TELEPHONE
LINE
ZO
600
T1
MIDCOM
671-8005
06
48
5-
02
9
A1
A2
A3
A4
Figure 29. A Single-Supply Direct Access Arrangement for Modems
A ONE-CHIP HEADPHONE/MICROPHONE
PREAMPLIFIER SOLUTION
Because of its high output current performance, the AD8644
makes an excellent amplifier for driving an audio output jack in
a computer application. Figure 30 shows how the AD8644 can
be interfaced with an ac codec to drive headphones or speakers.
U1-A
4
5V
1
10
2
3
5
5V
AVDD1
VREFOUT
LINE_OUT_L
LINE_OUT_R
AVSS1
7
8
6
9
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
U1-B
U1 = AD8644
28
35
36
26
25
+
AD1881A
(AC'97)
R3
20
+
C1
100F
R1
2k
R4
20
C2
100F
R2
2k
064
85
-0
30
Figure 30. A PC-99-Compliant Headphone/Line Out Amplifier
相關PDF資料 |
PDF描述 |
|---|---|
| 3413.0328.26 | FUSE 10A 32V 1206 SLOW SMD |
| AD8607ARM-R2 | IC OPAMP GP R-R CMOS DUAL 8MSOP |
| 3413.0328.24 | FUSE 10A 32V 1206 SLOW SMD |
| LTC6084HMS8#TRPBF | IC AMP R-R CMOS DUAL 8-MSOP |
| 3413.0327.26 | FUSE 8A 32V 1206 SLOW SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8614ARTZ-REEL7 | 功能描述:IC OPAMP GP R-R 5.5MHZ SOT23-5 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| AD8615 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8615_05 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8615_08 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, 20 MHz, CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8615ARJ | 制造商:Analog Devices 功能描述:SINGLE, PRECISION 20 MHZ CMOS RAIL-TO-RAIL INPUT/OUTPUT OPER - Bulk |
發布緊急采購，3分鐘左右您將得到回復。