- 您現在的位置：買賣IC網 > PDF目錄10537 > AD7856ARSZ (Analog Devices Inc)IC ADC 14BIT 8CHAN 5V 24SSOP PDF資料下載
參數資料
| 型號： | AD7856ARSZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 19/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 14BIT 8CHAN 5V 24SSOP |
| 標準包裝： | 1 |
| 位數： | 14 |
| 采樣率（每秒）： | 285k |
| 數據接口： | 8051，QSPI?，串行，SPI? µP |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 89.25mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 24-SSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 8 個單端，單極；4 個偽差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD7856
–26–
REV. A
CONFIGURING THE AD7856
The AD7856 contains 14 on-chip registers that can be accessed
via the serial interface. In the majority of applications it will not
be necessary to access all of these registers. Here the CLKIN
signal is applied directly after power-on, the CLKIN signal must
be present to allow the part to perform a calibration. This auto-
matic calibration will be completed approximately 150 ms
after power-on.
Writing to the AD7856
For accessing the on-chip registers it is necessary to write to the
part. To change the channel from the default channel setting the
user will be required to write to the part. To enable Serial Inter-
face Mode 1 the user must also write to the part. Figures 34 and
35 outline flowcharts of how to configure the AD7856 Serial
Interface Modes 1 and 2 respectively. The continuous loops on
all diagrams indicate the sequence for more than one conversion.
START
POWER-ON, APPLY CLKIN SIGNAL,
WAIT 150ms FOR AUTOMATIC CALIBRATION
APPLY
SYNC (IF REQUIRED), SCLK,
WRITE TO CONTROL REGISTER
SETTING CHANNEL AND TWO-WIRE MODE
PULSE
CONVST PIN
WAIT FOR BUSY SIGNAL TO GO LOW
OR
WAIT FOR BUSY BIT = 0
1
SERIAL
INTERFACE
MODE
?
READ
DATA
DURING
CONVERSION
?
NO
YES
APPLY
SYNC (IF REQUIRED), SCLK, READ
CURRENT CONVERSION RESULT ON DIN PIN
APPLY
SYNC (IF REQUIRED), SCLK, READ
PREVIOUS CONVERSION RESULT ON DIN PIN
WAIT APPROX. 200 ns AFTER
CONVST RISING EDGE OR AFTER END
OF CONTROL REGISTER WRITE
Figure 34. Flowchart for Setting Up, Reading and Writing in Interface Mode 1
The options of using a hardware (pulsing the
CONVST pin) or
software (setting the CONVST bit to 1) conversion start, and
reading/writing during or after conversion are shown in Figures
34 and 35. If the
CONVST pin is never used, it should be
permanently tied to DVDD. Where reference is made to the
BUSY bit equal to a Logic 0, to indicate the end of conversion,
the user in this case would poll the BUSY bit in the status register.
Interface Mode 1 Configuration
Figure 34 shows the flowchart for configuring the part in Inter-
face Mode 1. This mode of operation can only be enabled by
writing to the control register and setting the 2/
3 MODE bit.
Reading and writing cannot take place simultaneously in this
mode as the DIN pin is used for both reading and writing.
Initiating conversions in software is not recommended in this
mode, see Detailed Timing section.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B4J-MX-F3 | CONVERTER MOD DC/DC 36V 75W |
| HIN202ECBZ | IC TXRX RS-232 5V ESD 16-SOIC |
| AD7899ARZ-2 | IC ADC 14BIT 400KSPS 5V 28SOIC |
| HIN232ACBZ | IC 2DRVR/2RCVR RS232 5V 16-SOIC |
| VI-B4J-MX-F2 | CONVERTER MOD DC/DC 36V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7856ARSZ-REEL7 | 功能描述:IC ADC 14BIT 8CHAN 5V 24SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD7856ARZ | 功能描述:IC ADC 14BIT 8CHAN 5V 24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7856ARZ-REEL7 | 功能描述:IC ADC 14BIT 8CHAN 5V 24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7856KR | 制造商:Analog Devices 功能描述:ADC Single SAR 285ksps 14-bit Serial 24-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:8 CH. 14-BIT 300 KSPS ADC I.C. - Bulk |
| AD7856KR-REEL | 功能描述:IC ADC 14BIT 8CH 5V 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。