- 您現在的位置：買賣IC網 > PDF目錄10289 > AD7366BRUZ-5500RL7 (Analog Devices Inc)IC ADC 12BIT DUAL BIPO 24-TSSOP PDF資料下載
參數資料
| 型號： | AD7366BRUZ-5500RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT DUAL BIPO 24-TSSOP |
| 設計資源： | Driving the AD7366/7 Bipolar SAR ADC in Low-Distortion DC-Coupled Appls (CN0042) |
| 標準包裝： | 500 |
| 系列： | iCMOS® |
| 位數： | 12 |
| 采樣率（每秒）： | 500k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 88.8mW |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 4 個單端，單極；4 個單端，雙極 |
| 配用： | EVAL-AD7366CBZ-ND - BOARD EVALUATION FOR AD7366 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7366-5/AD7367-5
Rev. A | Page 20 of 28
MODES OF OPERATION
The mode of operation for the AD7366-5/AD7367-5 is selected
by the (logic) state of the CNVST signal at the end of a conver-
sion. There are two possible modes of operation: normal mode
and shutdown mode. These modes of operation are designed to
provide flexible power management options, which can be
chosen to optimize the power dissipation/throughput rate
ratio for differing application requirements.
NORMAL MODE
Normal mode is intended for applications needing fast
throughput rates because the user does not have to worry
about any power-up times (with the AD7366-5/AD7367-5
remaining fully powered at all times). Figure 22 shows the
normal mode of operation for the AD7366-5, while Figure 23
illustrates normal mode for the AD7367-5.
The conversion is initiated on the falling edge of CNVST as
described in the
section. To ensure that
the part remains fully powered up at all times,
CNVST must be
at a logic high state prior to the BUSY signal going low. If
CNVST is at a logic low state when the BUSY signal goes low,
the analog circuitry powers down and the part ceases converting.
The BUSY signal remains high for the duration of the conversion.
The CS pin must be brought low to bring the data bus out of
three-state; subsequently 12 SCLK cycles are required to read
the conversion result from the AD7366-5, while 14 SCLK cycles
are required to read from the AD7367-5. The DOUT lines return
to three-state only when CS is brought high. If CS is left low for
a further 12 SCLK cycles for the AD7366-5 or 14 SCLK cycles
for the AD7367-5, the result from the other on-chip ADC is
also accessed on the same DOUT line, as shown in
and
(see the
section).
After 24 SCLK cycles have elapsed for the AD7366-5 and 28 SCLK
cycles have elapsed for the AD7367-5, the DOUT line returns to
three-state when CS is brought high (not on the 24th or 28th SCLK
falling edge). If CS is brought high prior to this, the DOUT line
returns to three-state at that point. Thus, CS must be brought
high once the read is completed because the bus does not
automatically return to three-state upon completion of the
dual result read.
Once a data transfer is complete and DOUTA and DOUTB have
returned to three-state, another conversion can be initiated after
the quiet time, tQUIET, has elapsed by bringing CNVST low again.
CNVST
BUSY
SCLK
t2
t1
t3
SERIAL READ OPERATION
CS
tCONVERT
tQUIET
1
12
06
84
2-
0
24
BUSY
Figure 22. Normal Mode Operation for the AD7366-5
t2
t1
t3
CS
SCLK
SERIAL READ OPERATION
1
14
tCONVERT
tQUIET
CNVST
06
84
2-
0
25
Figure 23. Normal Mode Operation for the AD7367-5
相關PDF資料 |
PDF描述 |
|---|---|
| VI-BNF-IW-B1 | CONVERTER MOD DC/DC 72V 100W |
| D38999/20JG75BA | CONN HSG RCPT 4POS WALL MT SCKT |
| AD7476ABKSZ-500RL7 | IC ADC 12BIT 1MSPS LP SC70-6 |
| AD7352BRUZ-RL | IC ADC DUAL 12BIT 3MSPS 16TSSOP |
| LTC1407HMSE#TRPBF | IC ADC 12BIT 3MSPS 10-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7366BRUZ-5-RL7 | 功能描述:IC ADC 12BIT DUAL BIPO 24-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:iCMOS® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7366BRUZ-REEL7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:True Bipolar Input, Dual 1us, 12-Bit, 2-Channel SAR ADC |
| AD7366BRUZ-RL7 | 功能描述:IC ADC 12BIT SAR 1MSPS 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:iCMOS® 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7367 | 制造商:AD 制造商全稱:Analog Devices 功能描述:True Bipolar Input, Dual 1 レs, 12-/14-Bit, 2-Channel SAR ADCs |
| AD7367-5 | 制造商:AD 制造商全稱:Analog Devices 功能描述:True Bipolar Input, Dual 1 レs, 12-/14-Bit, 2-Channel SAR ADCs |
發布緊急采購，3分鐘左右您將得到回復。